Acetone-soluble cellulose acetates prepared by one-step homogeneous acetylation of cornhusk cellulose in an ionic liquid 1-allyl-3-methylimidazolium chloride (AmimCl)

Cellulose samples extracted from cornhusk have been successfully acetylated in an ionic liquid 1-allyl-3-methylimidazolium chloride (AmimCl). Without using any catalyst, cornhusk cellulose acetates (CCAs) with the degree of substitution (DS) in a range from 2.16 to 2.63 were prepared in one-step. Under the homogeneous state, the DS value of CCAs was easily controlled by the acetylation time. The obtained CCAs were characterized by means of FT-IR, ¹³C NMR, DSC, TGA, and a mechanical test. The NMR results showed that the distribution of the acetyl moiety among the three OH groups of the anhydroglucose unit shows a preference at the C₆ position. The CCAs exhibited good solubility in some organic solvents, such as acetone and DMSO. The cast CCA films from their acetone solutions had good mechanical properties. At the end of each acetylation of cornhusk cellulose, the ionic liquid AmimCl could be effectively recovered. Therefore, this study presents a promising approach and “green process” to make use of crop by-products.     

氮磷对污水净化中藻类叶绿素含量的影响

在室内模拟生物净化槽中比较研究了氮磷对污水中藻类叶绿素含量和污水净化的影响。污水中磷含量均为７ｍｇ／Ｌ左右,氮含量分别为７７．４、４４．４、２４．８和１３．５ｍｇ／Ｌ,结果发现ＴＮ／ＴＰ＝７７．４／７．０１ｍｇ／Ｌ组,污水经７ｄ净化,藻类叶绿素含量最高,污水净化效果较好。四个实验组比较,叶绿素含量随ＴＮ／ＴＰ比例的上升而上升,呈显著正相关。     

水稻种子内生细菌多样性及其分泌植物生长素能力的测定

[目的]探讨水稻种子内生细菌的多样性并测定其分泌IAA能力.[方法]采用传统的可培养方法分离水稻种子内生细菌,并通过16S Rrna基因序列分析初步确定分离菌株的系统发育地位,利用比色法进一步对不同种类菌株产植物生长素(IAA)能力进行定性、定量检测.[结果]共分离纯化获得66株内生细菌菌株,分属于5个类群的15个属26个种.以26株细菌为代表对其进行分泌生长素(IAA)能力的定性及定量测定,共发现19株细菌可分泌生长素或其类似物,其中Z10、Z17、Z14和Z20 4株内生细菌具较强的分泌植物生长素能力.[讨论]分离得到的内生细菌表现了水稻种子内生细菌的多样性,其中某些细菌对植物有一定的促生功能.     

“共轭聚合物-产电菌”复合生物电极构建及其在微生物燃料电池中的应用

微生物燃料电池(Microbial fuel cell,MFC)作为一种生物电化学装置,在可再生能源生产和废水处理方面的巨大潜力已引起广泛关注。然而MFC面临输出功率低、欧姆内阻高以及启动时间长等问题,极大限制了其在实际工程中的应用。MFC中阳极是微生物附着的载体,对电子的产生及传递起着关键作用,开发优质的生物电极已发展成为改善MFC性能的有效途径。共轭聚合物具有成本低、电导率高、化学稳定性及生物相容性好等优点,利用共轭聚合物修饰生物电极结构,可以实现大比表面积、缩短电荷转移路径,从而实现高效生物电化学性能。同时,纳米级共轭聚合物包覆细菌,可以使细菌产生的电子有效地传递到电极。文中综述了最近报道的共轭聚合物在MFC中的应用,重点介绍了共轭聚合物修饰的MFC阳极,系统分析了共轭聚合物的优点及局限性,以及这些高效复合生物电极如何解决MFC应用中存在的低输出功率、高欧姆内阻及长启动时间等问题。     

Testing the responses of four wheat crop models to heat stress at anthesis and grain filling

Higher temperatures caused by future climate change will bring more frequent heat stress events and pose an increasing risk to global wheat production. Crop models have been widely used to simulate future crop productivity but are rarely tested with observed heat stress experimental datasets. Four wheat models (DSSAT‐CERES‐Wheat, DSSAT‐Nwheat, APSIM‐Wheat, and WheatGrow) were evaluated with 4 years of environment‐controlled phytotron experimental datasets with two wheat cultivars under heat stress at anthesis and grain filling stages. Heat stress at anthesis reduced observed grain numbers per unit area and individual grain size, while heat stress during grain filling mainly decreased the size of the individual grains. The observed impact of heat stress on grain filling duration, total aboveground biomass, grain yield, and grain protein concentration (GPC) varied depending on cultivar and accumulated heat stress. For every unit increase of heat degree days (HDD, degree days over 30 °C), grain filling duration was reduced by 0.30–0.60%, total aboveground biomass was reduced by 0.37–0.43%, and grain yield was reduced by 1.0–1.6%, but GPC was increased by 0.50% for cv Yangmai16 and 0.80% for cv Xumai30. The tested crop simulation models could reproduce some of the observed reductions in grain filling duration, final total aboveground biomass, and grain yield, as well as the observed increase in GPC due to heat stress. Most of the crop models tended to reproduce heat stress impacts better during grain filling than at anthesis. Some of the tested models require improvements in the response to heat stress during grain filling, but all models need improvements in simulating heat stress effects on grain set during anthesis. The observed significant genetic variability in the response of wheat to heat stress needs to be considered through cultivar parameters in future simulation studies.     

红松阔叶林倒木贮量动态的研究

在森林倒木研究的基础上探讨长白山红松阔叶林倒木贮量的动态,涉及红松阔叶林倒木分解及其贮量的动态规律。研究表明,倒木分解,除心腐木外,均由表及里进行;倒木分解速率在其它生态条件相同时因树种、直径和部位而异。红松阔叶林倒木贮量动态包括现有倒木贮量和倒木年输入量两个分解动态过程,现有倒木贮量在头100年其干重迅速减少,其中椴树比红松尤速,前者分解91%,后者为72%.林地倒木贮量动态与倒木年输入量分解动态相似,但前者在分解初期贮量增加较大,因为部分现有倒木未完全分解;100年后趋于一致,并恒定于16～17t·hm^-2,直至群落的顶极阶段结束.