Characterization of an antigenically related family of cell-type specific proteins implicated in slug migration in Dictyostelium discoideum

The monoclonal antibody MUD50 recognizes a group of developmentally regulated proteins, which are almost exclusively expressed by prespore cells in developing aggregates of Dictyostelium discoideum. Some of these antigens are integrally associated with the cell membrane, as assessed by physical and detergent-fractionation procedures. The MUD50-reactive proteins are glycosylated and some are phosphorylated. Post-translational modification is the common antigenic feature that is recognized by the MUD50 antibody in these cell-type-specific proteins. A glycosylation-defective mutant, DL118, (modB) does not express the MUD50 epitope, but does express the MUD52 epitope, which is found on a different group of glycoproteins. Therefore, we conclude that MUD50 recognizes a particular carbohydrate epitope on a restricted group of proteins. These proteins are structurally diverse, but are apparently involved in the maintenance of structure and movement of the multicellular D. discoideum slug.     

The effects of varying inertial loadings on power variables in the flywheel romanian deadlift exercise

The aim of this study was to investigate the effect of four different inertial loads (0.025, 0.050, 0.075, and 0.100 kg· m²) on concentric (CON) power, eccentric (ECC) power, and ECC overload in the flywheel Romanian deadlift (RDL). Fourteen recreationally trained males (27.9 ± 6.4 years, 90 ± 10.7 kg, 180.7 ± 5.5 cm) volunteered for the study. They had a minimum of two years of resistance training experience, although none had experience in flywheel inertia training (FIT). All participants performed the flywheel RDL on a flywheel device (kBox 3, Exxentric, AB TM, Bromma, Sweden). Each set was performed using different inertial loads, those being 0.025, 0.050, 0.075, and 0.100 kg·m². For CON, ECC power, and ECC overload, there was a significant difference (p < 0.001) between inertial loadings. In conclusion, results highlight that lower inertial load leads to higher peak CON and ECC power values, precisely 0.025 kg· m². Regarding ECC overload, medium to higher loads (0.050, 0.075, and 0.100 kg·m²) will lead to higher values.     

Adapting Stand‐Alone Renewable Energy Technologies for the Circular Economy through Eco‐Design and Recycling

Renewable energy (RE) technologies are looked upon favorably to provide for future energy demands and reduce greenhouse gas (GHG) emissions. However, the installation of these technologies requires large quantities of finite material resources. We apply life cycle assessment to 100 years of electricity generation from three stand‐alone RE technologies—solar photovoltaics, run‐of‐river hydro, and wind—to evaluate environmental burden profiles against baseline electricity generation from fossil fuels. We then devised scenarios to incorporate circular economy (CE) improvements targeting hotspots in systems’ life cycle, specifically (1) improved recycling rates for raw materials and (ii) the application of eco‐design. Hydro presented the lowest environmental burdens per kilowatt‐hour of electricity generation compared with other RE technologies, owing to its higher efficiency and longer life spans for main components. Distinct results were observed in the environmental performance of each system based on the consideration of improved recycling rates and eco‐design. CE measures produced similar modest savings in already low GHG emissions burdens for each technology, while eco‐design specifically had the potential to provide significant savings in abiotic resource depletion. Further research to explore the full potential of CE measures for RE technologies will curtail the resource intensity of RE technologies required to mitigate climate change.