Continuous microbial desulfurization of coal--application of a multistage slurry reactor and analysis of the interactions of microbial and chemical kinetics

Microbial desulfurization of coal by pyrite oxidizing bacterial enrichment cultures has been studied in air-agitated slurry reactors of 4- and 20-L volumes. Batch experiments showed that inoculation with an active bacterial culture is essential to minimize the lag phase, although a considerable number of pyrite oxidizing bacteria was found on the coal prior to desulfurization. For detailed investigations of kinetics, energy requirements, and technical applicability, a bioreactor equipment consisting of a cascade of eight stages was developed and operated continuously. Microbial desulfurization of coal-monitored by measuring the axial profile of dissolved iron concentration, real and maximum oxygen consumption rates, and cell concentration-at pulp densities to 30% was performed over a period of 200 days without any disturbances concerning the aeration system, fluidization, transport of solids and microbial growth. At a pulp density of 20%, a pyrite conversion of 68% was achieved after the third reactor stage at a total residence time of five days in the first three stages. The kinetics of pyrite degradation were found to be well described by a rate equation of first order in pyrite surface area concentration if the pyrite is directly accessible for microbial attack. Rate constants were determined to 0.48 mg pyrite/(cm(2) day) in the first and to 0.24 mg pyrite/(cm(2) day) in the following reactor stages. Kinetic models taking into account adsorption/desorption as well as growth kinetics failed to describe the observed reaction rates. However, a model treating pyrite degradation and microbial growth kinetics formalistically seems to be applicable when backmixing between the reactor stages can be avoided. The advantage of a multistage reactor in comparison to single-stage equipment was shown by calculation. To obtain a pyrite conversion of 68%, a three-stage reactor would require only 58% of the volume of single-stage equipment.Measurement of oxygen consumption rates proved to provide quickly and easily measurable parameters to observe microbial coal desulfurization in technical scale: the real oxygen consumption rate is correlated to the pyrite oxidation rate and the maximum oxygen consumption rate is correlated to the concentration of viable cells. The Y(o/s) coefficient for the amount of oxygen consumed per mass unit of pyrite oxygen was determined to approximately 0.33 in comparison to 1.0 which can be calculated from stoichiornetry. This could yet not be explained. Chemical leaching experiments as well as sulfur analyses of desulfurized coal samples showed that the microorganisms play the main role in degradation of pyrite from coal and that pyrite oxidation by ferric iron can be neglected.     

Competitive yeast fermentation with selective flocculation and recycle

Continuous fermentations were carried out involving competition between two strains of Saccharomyces cerevisiae. One of the strains has a lower specific growth rate and is very flocculent, whereas the fastergrowing strain is nonflocculent. The product stream from the chemostat was fed into an inclined settler where the flocculent strain was partially separated from the nonflocculent strain as a result of the higher sedimentation rate of the flocculent cells. The underflow from the inclined settler, which was concentrated and enriched with flocculent cells, was recycled to the chemostat. When no recycle was used, the fastergrowing, nonflocculent yeast rapidly overtook the culture. With selective recycle, however, the experiments demonstrated that the slower-growing flocculent yeast could be maintained as the dominant species. A theoretical development is also presented in order to describe the competition between two strains in the bioreactor-settler system. The concept of selective recycle via selective flocculation and sedimentation offers a possible means of maintaining unstable recombinant microorganisms in continuous fermentations.     

The heat generated by yeast cultures with a mixed metabolism in the transition between respiration and fermentation

The heat generated by both batch and continuous cultures of the yeast K. fragilis was studied using a modified Bench Scale Calorimeter. Batch cultures were used to measure the heat dissipation rates and the heat yields during fully aerobic and completely anaerobic growth, whereas continuous cultures enabled, in addition, a quantitative study of heat dissipation rates during growth on mixed metabolism. In this case, the extent of fermentation versus respiration could be specified and controlled by varying the degree of oxygen limitation. The heat dissipated per unit biomass formed was highest for fully respirative catabolism and fell continuously to a much lower value typical of anaerobic cultures as the catabolism was shifted increasingly to the fermentative mode. The heat generated per mole of oxygen taken up stayed quite close to the fully aerobic value of 506 kJ mol(-1) even when a sizable fraction of the substrate available to catabolism was fermented. If the fraction of respiration in the metabolism is lowered beyond a certain threshold, the ratio of the heat generation to oxygen consumption starts to increase dramatically and finally tends to infinity for fully anaerobic growth. All experimental results were quantitatively analyzed and explained on the basis of a simple model which formally describes the cultures in terms of two parallel "chemical" reactions. In simple cases such as the one presented here, the model enables calculation of the whole stoichiometry of the culture from a single measured heat yield.     

Mathematical descriptions of hybridoma culture kinetics: II. The relationship between thiol chemistry and the degradation of serum activity

The growth rate of the hybridoma cell line ATCC-CRL-1606 in low serum medium declines rapidly with time after inoculation. To characterize this phenomenon, the stability of the growth-promoting activity of serum was investigated. The activity of serum was found to de grade with time, and was stabilized by alterations in the medium formulation that acted to lower the oxidation/reduction potential. This included both the addition of thiols and the elimination of disulfides from the medium. Additionally, cysteine and other thiols were shown to stimulate growth in low serum, low cell density cultures, suggesting that thiols may be rate-limiting in low serum medium. Stimulation of growth by thiol addition was less significant at high cell levels, implying that the cells themselves may be acting to reduce their environment. A hypothesis is presented based on these results which suggests that the actual rate-limiting moieties in low serum cultures may be dithiols.     

Growth and death in overagitated microcarrier cell cultures

The effects of hydrodynamic forces on cell growth are investigated for animal cells growing on microcarriers. A reduction in net growth was observed with high levels of agitation. DNA measurements indicated that the reduction in net growth was due entirely to cell death, from hydrodynamic forces. No inhibition or enhancement of cell replication appeared to occur with high levels of agitation.     

Influence of the solvent on the conformational-dependent properties of random coil polypeptides. II. Mean square optical anisotropies and Kerr constants

Mean square optical anisotropies and molar Kerr constants were calculated for homopolypeptides of the 20 natural amino acids and of several enzymes and proteins in the random-coil state. The effect of hydration was taken into account in constructing the molecular potential that gives the conformational energies as a function of the rotational angles phi and psi of the backbone and chi(1) of the side chain. The Rotational Isomeric State model was used in calculated energies, the Valence Optical Scheme and the matrix calculus technique of Flory being employed in the evaluation of the optical properties. The results are compared with calculations for the same substances that were performed without taking into account the solvent, as well as with other similar studies. The Kerr constant is confirmed as being one of the most sensitive properties of a given polypeptide to the residue class and to the sequence of those residues.