Investigation of Charge Carrier Behavior in High Performance Ternary Blend Polymer Solar Cells

This study demonstrates high‐performance, ternary‐blend polymer solar cells by modifying a binary blend bulk heterojunction (PPDT2FBT:PC₇₁BM) with the addition of a ternary component, PPDT2CNBT. PPDT2CNBT is designed to have complementary absorption and deeper frontier energy levels compared to PPDT2FBT, while being based on the same polymeric backbone. A power conversion efficiency of 9.46% is achieved via improvements in both short‐circuit current density (J_SC) and open‐circuit voltage (V_OC). Interestingly, the V_OC increases with increasing the PPDT2CNBT content in ternary blends. In‐depth studies using ultraviolet photoelectron spectroscopy and transient absorption spectroscopy indicate that the two polymers are not electronically homogeneous and function as discrete light harvesting species. The structural similarity between PPDT2CNBT and PPDT2FBT allows the merits of a ternary system to be fully utilized to enhance both J_SC and V_OC without detriment to fill‐factor via minimized disruption of semi‐crystalline morphology of binary PPDT2FBT:PC₇₁BM blend. Further, by careful analysis, charge carrier transport in this ternary blend is clearly verified to follow parallel‐like behavior.     

Interplay Between Side Chain Pattern,Polymer Aggregation,and Charge Carrier Dynamics in PBDTTPD:PCBM Bulk‐Heterojunction Solar Cells

Poly(benzo[1,2‐b:4,5‐b′]dithiophene–alt–thieno[3,4‐c]pyrrole‐4,6‐dione) (PBDTTPD) polymer donors with linear side‐chains yield bulk‐heterojunction (BHJ) solar cell power conversion efficiencies (PCEs) of about 4% with phenyl‐C₇₁‐butyric acid methyl ester (PC₇₁BM) as the acceptor, while a PBDTTPD polymer with a combination of branched and linear substituents yields a doubling of the PCE to 8%. Using transient optical spectroscopy it is shown that while the exciton dissociation and ultrafast charge generation steps are not strongly affected by the side chain modifications, the polymer with branched side chains exhibits a decreased rate of nongeminate recombination and a lower fraction of sub‐nanosecond geminate recombination. In turn the yield of long‐lived charge carriers increases, resulting in a 33% increase in short circuit current (J _sc). In parallel, the two polymers show distinct grazing incidence X‐ray scattering spectra indicative of the presence of stacks with different orientation patterns in optimized thin‐film BHJ devices. Independent of the packing pattern the spectroscopic data also reveals the existence of polymer aggregates in the pristine polymer films as well as in both blends which trap excitons and hinder their dissociation.     

Improved Performance of Ternary Polymer Solar Cells Based on A Nonfullerene Electron Cascade Acceptor

Efficient ternary polymer solar cells are constructed by incorporating an electron‐deficient chromophore (5Z,5′Z)‐5,5′‐((7,7′‐(4,4,9,9‐tetrakis(4‐hexylphenyl)‐4,9‐dihydro‐s‐indaceno[1,2‐b:5,6‐b′]dithiophene‐2,7‐diyl)bis(6‐fluorobenzo[c][1,2,5]thiadiazole‐7,4‐diyl))bis(methanylylidene))bis(3‐ethyl‐2‐thioxothiazolidin‐4‐one) (IFBR) as an additional component into the bulk‐heterojunction film that consists of a wide‐bandgap conjugated benzodithiophene‐alt‐difluorobenzo[1,2,3]triazole based copolymer and a fullerene acceptor. With respect to the binary blend films, the incorporation of a certain amount of IFBR leads to simultaneously enhanced absorption coefficient, obviously extended absorption band, and improved open‐circuit voltage. Of particular interest is that devices based on ternary blend film exhibit much higher short‐circuit current densities than the binary counterparts, which can be attributed to the extended absorption profiles, enhanced absorption coefficient, favorable film morphology, as well as formation of cascade energy level alignment that is favorable for charge transfer. Further investigation indicates that the ternary blend device exhibits much shorter charge carrier extraction time, obviously reduced trap density and suppressed trap‐assisted recombination, which is favorable for achieving high short‐circuit current. The combination of these beneficial aspects leads to a significantly improved power conversion efficiency of 8.11% for the ternary device, which is much higher than those obtained from the binary counterparts. These findings demonstrate that IFBR can be a promising electron‐accepting material for the construction of ternary blend films toward high‐performance polymer solar cells.     

A Comparison of Five Experimental Techniques to Measure Charge Carrier Lifetime in Polymer/Fullerene Solar Cells

It is important to accurately measure the charge carrier lifetime, a crucial parameter that influences the collection efficiency in organic solar cells. Five transient and small perturbation experimental techniques that measure charge carrier lifetime are applied to a device composed of the polymer PDTSiTTz blended with the fullerene PCBM: time‐resolved charge extraction (TRCE), transient absorption spectroscopy (TAS), photoinduced charge extraction by linearly increasing voltage (photo‐CELIV), transient photovoltage, and electrochemical impedance spectroscopy. The motivation is to perform a comprehensive comparison of several different lifetime measurement techniques on the same device in order to assess their relative accuracy, applicability to operational devices, and utility in data analysis. The techniques all produce similar charge carrier lifetimes at high charge densities, despite previous suggestions that transient methods are less accurate than small perturbation ones. At lower charge densities an increase in the apparent reaction order is observed. This may be related to surface recombination at the contacts beginning to dominate, or an inhomogeneous charge distribution. A combination of TAS and TRCE appears suitable. TAS enables the investigation of recombination mechanisms at early times since it is not limited by RC (resistance‐capacitance product) or charge extraction losses. Conversely, TRCE is useful particularly at low densities when other mechanisms, such as surface recombination, may occur.     

Morphology‐Limited Free Carrier Generation in Donor/Acceptor Polymer Blend Solar Cells Composed of Poly(3‐hexylthiophene) and Fluorene‐Based Copolymer

The charge generation and recombination dynamics in polymer/polymer blend solar cells composed of poly(3‐hexylthiophene) (P3HT, electron donor) and poly[2,7‐(9,9‐didodecylfluorene)‐alt‐5,5‐(4′,7′‐bis(2‐thienyl)‐2′,1′,3′‐benzothiadiazole)] (PF12TBT, electron acceptor) are studied by transient absorption measurements. In the unannealed blend film, charge carriers are efficiently generated from polymer excitons, but some of them recombine geminately. In the blend film annealed at 160 °C, on the other hand, the geminate recombination loss is suppressed and hence free carrier generation efficiency increases up to 74%. These findings suggest that P3HT and PF12TBT are intermixed within a few nanometers, resulting in impure PF12TBT and disordered P3HT domains. The geminate recombination is likely due to charge carriers generated on isolated polymer chains in the matrix of the other polymer and at the domain interface with disordered P3HT. The undesired charge loss by geminate recombination is reduced by both the purification of the PF12TBT‐rich domain and crystallization of the P3HT chains. These results show that efficient free carrier generation is not inherent to the polymer/fullerene domain interface, but is possible with polymer/polymer systems composed of crystalline donor and amorphous acceptor polymers, opening up a new potential method for the improvement of solar cell materials.