Minor groove recognition is important for the transcription factor PhoB: a surface plasmon resonance study

The two-component regulatory system PhoR/PhoB induces the expression of several genes in response to phosphate starvation in Escherichia coli. In order to quantify these protein-DNA interactions and to study the time-resolved dynamics of the binding mechanism, the specific recognition of different oligonucleotide duplexes by the DNA-binding domain of PhoB (PhoB(DBD)) was analyzed using surface plasmon resonance. In addition the two point mutants PhoB(DBD)D196A and PhoB(DBD)R219A were obtained and the DNA recognition in comparison to the wildtype PhoB(DBD) was investigated. Aspartic acid 196 and arginine 219 mediate specific minor groove interactions. All results reveal that at high PhoB(DBD)-concentrations all recognition sequences of the pho box are occupied. Decreasing the protein amount results in a mixture of free oligonucleotides and DNA molecules occupied by two WT-PhoB(DBD). Moreover, the SPR results indicate that both binding site segments, the TGTCA-motif and the A/T-rich minor groove, are essential for the binding process. A comparison of different regulons additionally proved the dependency of the recognition process on the base composition of the minor groove.     

Preferential protection of the minor groove of non-operator DNA by lac repressor against methylation by dimethyl sulphate.

The binding of lactose repressor to non-operator DNA was studied by the modification of several DNA's, including glycosylated DNA, with dimethyl sulphate, which affects the minor and major grooves of DNA and single stranded DNA regions. The non-specific binding of the repressor to DNA protected the minor groove but apparently not the major groove of the DNA double helix against methylation and did not increase the content of single stranded DNA regions. This suggests that the repressor on binding to non-operator DNA makes contacts mainly in the minor groove of DNA and does not uncoil the DNA double helix. This is different from the interaction of the repressor with lactose operator DNA which occurs, as shown by Gilbert et al. (1), along both the major and the minor groove.     

Triple helix stabilization by covalently linked DNA-bisbenzimidazole conjugate synthesized by maleimide-thiol coupling chemistry

Tethering of BBZPNH2, an analogue of the Hoechst 33258, with a 14 nucleotide long DNA sequence with the help of succinimidyl-4-(N-maleimidomethyl)cyclohexane-1-carboxylate (SMCC), a heterobifunctional crosslinking reagent, using DMF/ water as solvent yields a conjugate which effectively stabilizes the triple helix. The above conjugate was hybridized with 26 bp long double stranded (ds) DNA having 14 bp long polypurine-polypyrimidine stretch to form a pyrimidine motif triple helix. The above conjugate increases the thermal stability of both the transitions, that is, triple helix to double helix by 12 degrees C and double helix to single strand transition by 16 degrees C for the triple helix formed with conjugated TFO over the triple helix made from non-conjugated TFO. Fluorescence and circular dichroism spectra recorded at different temperatures confirm the presence of minor groove binding bisbenzimidazole in the AT-rich minor groove of dsDNA even after the major groove bound TFO separates out.     

Domain orientation in the inactive response regulator Mycobacterium tuberculosis MtrA provides a barrier to activation

The structure of MtrA, an essential gene product for the human pathogen Mycobacterium tuberculosis, has been solved to a resolution of 2.1 A. MtrA is a member of the OmpR/PhoB family of response regulators and represents the fourth family member for which a structure of the protein in its inactive state has been determined. As is true for all OmpR/PhoB family members, MtrA possesses an N-terminal regulatory domain and a C-terminal winged helix-turn-helix DNA-binding domain, with phosphorylation of the regulatory domain modulating the activity of the protein. In the inactive form of MtrA, these two domains form an extensive interface that is composed of the alpha4-beta5-alpha5 face of the regulatory domain and the C-terminal end of the positioning helix, the trans-activation loop, and the recognition helix of the DNA-binding domain. This domain orientation suggests a mechanism of mutual inhibition by the two domains. Activation of MtrA would require a disruption of this interface to allow the alpha4-beta5-alpha5 face of the regulatory domain to form the intermolecule interactions that are associated with the active state and to allow the recognition helix to interact with DNA. Furthermore, the interface appears to stabilize the inactive conformation of MtrA, potentially reducing the rate of phosphorylation of the N-terminal domain. This combination of effects may form a switch, regulating the activity of MtrA. The domain orientation exhibited by MtrA also provides a rationale for the variation in linker length that is observed within the OmpR/PhoB family of response regulators.     

Molecular basis for potentiation of bleomycin-mediated degradation of DNA by polyamines. Experimental and molecular mechanical studies

The bleomycin-mediated degradation of DNA is stimulated (amplified) by certain DNA binding compounds, such as polyamines, that distort the double helix. Computer modelling studies suggest that putrescine (1), spermidine (2), and spermine (3) bind preferentially on the floor of the major groove of (dGdC)5.(dGdC)5. This interaction results in a bend of the oligomer helix toward the major groove and enlargement of the minor groove, both effects being in the order 1 less than 2 less than 3. These polyamine-induced distortions, as obtained from theoretical studies, parallel the experimental values of the amplification activities of 1-3 in the bleomycin-mediated degradation of poly(dGdC).poly(dGdC). The amplification mechanism of non-competitive binding of amplifier molecules in the major groove, and bleomycin in the minor groove, is proposed. It is suggested that the amplifier-induced conformational changes of the DNA helix increase affinity of the activated bleomycin complex toward the DNA minor groove and, consequently, result in an increased efficiency of the bleomycin-mediated degradation of the helix.     

DNA curvature in native and modified EcoRI recognition sites and possible influence upon the endonuclease cleavage reaction

The ligation of a decadeoxynucleotide containing the EcoRI recognition site forms a series of multimers which appear to be curved based on observed anomalous gel migration in polyacrylamide gels. The degree of DNA curvature present in the recognition sequence, based upon the observed migration anomaly, can be altered by modifications to the purine functional groups at the 2- and 6-positions. Deletion of the guanine 2-amino group, occurring in the minor groove of the B-DNA helix, is most effective in increasing the observed DNA curvature. Conversely, the displacement of an amino group from the major groove to the minor groove eliminates curvature. DNA curvature is also modulated by the exocyclic group at the purine 6-position with decreasing curvature observed when changing the amino group to a carbonyl or proton substituent. Differences in the kinetic parameters characterizing the cleavage reaction by the endonuclease for many of the modified sequences are the result of modifications of functional groups in the major groove, which are likely to contact the endonuclease during catalysis. However, with two examples, significant decreases in the observed specificity constant (kcat/Km), characterizing the protein-nucleic acid interaction, cannot be easily explained in terms of such functional group contacts. It is more likely in these cases that the functional group modifications affect the efficiency of the endonuclease-DNA interaction by modulation of the structure of the double-stranded DNA helix. With both examples, modifications have been made to minor groove substituents. The extent of DNA curvature is increased significantly for one and decreased for the other, compared with that observed for the native recognition site. The results suggest that curvature of the DNA helix axis is an intrinsic property of the d(GAATTC) sequence which helps to optimize the protein-nucleic acid interactions observed for the EcoRI restriction endonuclease.     

Dimerization allows DNA target site recognition by the NarL response regulator

Two-component signal transduction systems are modular phosphorelay regulatory pathways common in prokaryotes. In the co-crystal structure of the Escherichia coli NarL signal output domain bound to DNA, we observe how the NarL family of two-component response regulators can bind DNA. DNA recognition is accompanied by the formation of a new dimerization interface, which could occur only in the full-length protein via a large intramolecular domain rearrangement. The DNA is recognized by the concerted effects of solvation, van der Waals forces and inherent DNA deformability, rather than determined primarily by major groove hydrogen bonding. These subtle forces permit a small DNA-binding domain to perturb the DNA helix, leading to major DNA curvature and a transition from B- to A-form DNA at the binding site, where valine on the recognition helix interacts unexpectedly with the polar major groove floor.     

Structure of a photoactive rhodium complex intercalated into DNA

Intercalating complexes of rhodium(III) are strong photo-oxidants that promote DNA strand cleavage or electron transfer through the double helix. The 1.2 A resolution crystal structure of a sequence-specific rhodium intercalator bound to a DNA helix provides a rationale for the sequence specificity of rhodium intercalators. It also explains how intercalation in the center of an oligonucleotide modifies DNA conformation. The rhodium complex intercalates via the major groove where specific contacts are formed with the edges of the bases at the target site. The phi ligand is deeply inserted into the DNA base pair stack. The primary conformational change of the DNA is a doubling of the rise per residue, with no change in sugar pucker from B-form DNA. Based upon the five crystallographically independent views of an intercalated DNA helix observed in this structure, the intercalator may be considered as an additional base pair with specific functional groups positioned in the major groove.     

The accessibility of DNA to dimethylsulfate in complexes with recA protein.

recA protein coats DNA co-operatively to form filaments approximately 100 A thick, which in the presence of ATP, and more stably so in the presence of the non-hydrolyzable analog ATP gamma S, have a helical appearance with a deep cleft in the protein coat. This protein helix follows the DNA helix, to which it imparts a new helicity of 18.5 bp per turn of 97 A pitch. Here we test the accessibility of the DNA in the complex to modification by dimethylsulfate, and find that the complexed DNA is approximately 2-fold more reactive on the major groove side than it was in B-DNA (methylation of guanine N7), while it is protected approximately 2-fold on the minor groove side (methylation of adenine N3), suggesting that the protein coats the DNA along the minor groove. Furthermore, N3 of cytosine, a residue involved in base pairing, is found exposed in complexes with single strands as it is in naked single-stranded DNA, while it remains inaccessible in complexes with double strands, suggesting that the latter is not melted at this stage of the strand exchange reaction.     

Synergistic effects in the melting of DNA hydration shell: melting of the minor groove hydration spine in poly(dA).poly(dT) and its effect on base pair stability.

We propose that water of hydration in contact with the double helix can exist in several states. One state, found in the narrow groove of poly(dA).poly(dT), should be considered as frozen to the helix, i.e., an integral part of the double helix. We find that this enhanced helix greatly effects the stability of that helix against base separation melting. Most water surrounding the helix is, however, melted or disassociated with respect to being an integral part of helix and plays a much less significant role in stabilizing the helix dynamically, although these water molecules play an important role in stabilizing the helix conformation statically. We study the temperature dependence of the melting of the hydration spine and find that narrow groove nonbonded interactions are necessary to stabilize the spine above room temperature and to show the broad transition observed experimentally. This calculation requires that synergistic effects of nonbonded interactions between DNA and its hydration shell affect the state of water-base atom hydrogen bonds. The attraction of waters into narrow groove tends to retain waters in the groove and compress or strain these hydrogen bonds.     

DNA conformational analysis in solution by uranyl mediated photocleavage.

Uranyl mediated photocleavage of double stranded DNA is proposed as a general probing for DNA helix conformation in terms of minor groove width/electronegative potential. Specifically, it is found that A/T-tracts known to constitute strong distamycin binding sites are preferentially photocleaved by uranyl in a way indicating strongest uranyl binding at the center of the minor groove of the AT-region. The A-tracts of kinetoplast DNA show the highest reactivity at the 3'-end of the tract--as opposed to cleavage by EDTA/Fell--in accordance with the minor groove being more narrow at this end. Finally, uranyl photocleavage of the internal control region (ICR) of the 5S-RNA gene yields a cleavage modulation pattern fully compatible with that obtained by DNase I which also--in a more complex way--senses DNA minor groove width.     

Stereochemistry of actinomycin binding to DNA : II. Detailed molecular model of actinomycin-DNA complex and its implications

The three-dimensional structure of a crystalline complex containing actinomycin D and deoxyguanosine (described in the previous paper) has shed light on the stereochemistry of actinomycin binding to DNA. The phenoxazone ring system on actinomycin intercalates between the base-paired dinucleotide sequence, GpC, while the peptide subunits lie in the narrow groove of the DNA helix and interact with deoxyguanosine residues on opposite chains through specific hydrogen bonds. The binding of actinomycin to DNA demonstrates a general principle which several classes of proteins may utilize in recognizing symmetrically arranged nucleotide sequences on the DNA helix.     

Binding of Hoechst 33258 to the minor groove of B-DNA

An X-ray crystallographic structure analysis has been carried out on the complex between the antibiotic and DNA fluorochrome Hoechst 33258 and a synthetic B-DNA dodecamer of sequence C-G-C-G-A-A-T-T-C-G-C-G. The drug molecule, which can be schematized as: phenol-benzimidazole-benzimidazole-piperazine, sits within the minor groove in the A-T-T-C region of the DNA double helix, displacing the spine of hydration that is found in drug-free DNA. The NH groups of the benzimidazoles make bridging three-center hydrogen bonds between adenine N-3 and thymine O-2 atoms on the edges of base-pairs, in a manner both mimicking the spine of hydration and calling to mind the binding of the auti-tumor drug netropsin. Two conformers of Hoechst are seen in roughly equal populations, related by 180 degrees rotation about the central benzimidazole-benzimidazole bond: one form in which the piperazine ring extends out from the surface of the double helix, and another in which it is buried deep within the minor groove. Steric clash between the drug and DNA dictates that the phenol-benzimidazole-benzimidazole portion of Hoechst 33258 binds only to A.T regions of DNA, whereas the piperazine ring demands the wider groove characteristic of G.C regions. Hence, the piperazine ring suggests a possible G.C-reading element for synthetic DNA sequence-reading drug analogs.     

Structural basis for stable DNA complex formation by the caspase-activated DNase

We describe a structural model for DNA binding by the caspase-activated DNase (CAD). Results of a mutational analysis and computational modeling suggest that DNA is bound via a positively charged surface with two functionally distinct regions, one being the active site facing the DNA minor groove and the other comprising distal residues close to or directly from helix alpha4, which binds DNA in the major groove. This bipartite protein-DNA interaction is present once in the CAD/inhibitor of CAD heterodimer and repeated twice in the active CAD dimer.