Mutations affecting pore formation by haemolysin from Escherichia coli

Summary By introduction of site-specific deletions, three regions in HlyA were identified, which appear to be involved in pore formation by Escherichia coli haemolysin. Deletion of amino acids 9–37 at the N-terminus led to a haemolysin which had an almost threefold higher specific activity than wild-type and formed pores in an artificial asolectin lipid bilayer with a much longer lifetime than those produced by wild-type haemolysin. The three hydrophobic regions (DI–DIII) located between amino acids 238–410 contributed to pore formation to different extents. Deletion of DI led to a mutant haemolysin which was only slightly active on erythrocyte membranes and increased conductivity of asolectin bilayers without forming defined pores. Deletions in the two other hydrophobic regions (DII and DIII) completely abolished the pore-forming activity of the mutant haemolysin. The only polar amino acid in DI, Asp, was shown to be essential for pore formation. Removal of this residue led to a haemolysin with a considerably reduced capacity to form pores, while replacement of Asp by Glu or Asn had little effect on pore formation. A deletion mutant which retained all three hydrophobic domains but had lost amino acids 498–830 was entirely inactive in pore formation, whereas a shorter deletion from amino acids 670–830 led to a mutant haemolysin which formed abnormal minipores. The conductivity of these pores was drastically reduced compared to pores introduced into an asolectin bilayer by wild-type haemolysin. Based on these data and structural predictions, a model for the pore-forming structure of E. coli haemolysin is proposed.     

Mutations affecting activity and transport of haemolysin in Escherichia coli

Summary Temperature-sensitive mutants that exhibit an altered haemolytic phenotype were isolated from Escherichia coli harbouring the plasmid pHly152. Complementation with recombinant plasmids carrying one of the four hly genes (C, A, B or D) allowed localization of the hly ^ts mutations. A ts mutation in hlyC leads to a proleu exchange in amino acid position 53 of HlyC. Two ts mutations in HlyA were found in positions 312 (serpro) and 315 (thrile). Both amino acid exchanges are located in the same hydrophobic domain of HlyA which extends from amino acids 299 to 327. Two different mutations were introduced by site-specific mutagenesis in this hlyA domain: one by an exchange of ala, val to asp, glu (positions 313, 314) altering the hydrophobicity of this region and another which removes most of this hydrophobic portion. Both mutants have entirely lost the haemolytic activity but the mutant haemolysins are still efficiently transported across both membranes when hlyB and hlyD are provided. Functional HlyC is not required for the transport of the mutant haemolysins. Two site-specific mutations at the N-terminal end of hlyA (one at amino acid position 2 leading to a thrpro exchange and another deleting ile and thr at positions 4 and 5) also do not affect the transport of the altered haemolysins. The thrpro exchange enhances the haemolytic activity of the corresponding mutant, whereas the ile, thr deletion exhibits little or no effect on the haemolytic activity. Removal of the last 37 amino acids from the C-terminal end of HlyA leads to a truncated haemolysin which retains its haemolytic activity but is not secreted by the HlyB and HlyD transport system.     

Mutations affecting the citrate-dependent iron uptake system in Escherichia coli.

Isolation of six strains of Escherichia coli K-12 carrying mutations affecting the citrate-dependent iron uptake system is described. Genetic analysis of these mutants showed that the mutation affecting the citrate system are cluster together at about min 6 on the E. coli chromosome.     

Mutations permitting the anaerobic growth of Escherichia coli on trehalose

Wild-type strains of Escherichia coli K-12 do not grow anaerobically on trehalose or galactose. We isolated two operon fusion mutants of E. coli which gained the ability to grow on trehalose anaerobically (tan). The tanA-lac mutation was located at 41 min on the E. coli genetic map and also abolished growth on glucuronic acid both aerobically and anaerobically. The tanB-lac mutation was mapped to 68 min and permitted anaerobic growth on galactose as well as trehalose. The tanB-lac fusion was induced anaerobically whereas tanA-lac showed more or less constitutive beta-galactosidase expression.     

Dynamics of loading the Escherichia coli DNA polymerase processivity clamp

Sliding clamps and clamp loaders are processivity factors required for efficient DNA replication. Sliding clamps are ring-shaped complexes that tether DNA polymerases to DNA to increase the processivity of synthesis. Clamp loaders assemble these ring-shaped clamps onto DNA in an ATP-dependent reaction. The overall process of clamp loading is dynamic in that protein-protein and protein-DNA interactions must actively change in a coordinated fashion to complete the mechanical clamp-loading reaction cycle. The clamp loader must initially have a high affinity for both the clamp and DNA to bring these macromolecules together, but then must release the clamp on DNA for synthesis to begin. Evidence is presented for a mechanism in which the clamp-loading reaction comprises a series of binding reactions to ATP, the clamp, DNA, and ADP, each of which promotes some change in the conformation of the clamp loader that alters interactions with the next component of the pathway. These changes in interactions must be rapid enough to allow the clamp loader to keep pace with replication fork movement. This review focuses on the measurement of dynamic and transient interactions required to assemble the Escherichia coli sliding clamp on DNA.     

DNA replication fidelity in Escherichia coli: a multi-DNA polymerase affair

High accuracy (fidelity) of DNA replication is important for cells to preserve the genetic identity and to prevent the accumulation of deleterious mutations. The error rate during DNA replication is as low as 10(-9) to 10(-11) errors per base pair. How this low level is achieved is an issue of major interest. This review is concerned with the mechanisms underlying the fidelity of the chromosomal replication in the model system Escherichia coli by DNA polymerase III holoenzyme, with further emphasis on participation of the other, accessory DNA polymerases, of which E.?coli contains four (Pols I, II, IV, and V). Detailed genetic analysis of mutation rates revealed that (1) Pol II has an important role as a back-up proofreader for Pol III, (2) Pols IV and V do not normally contribute significantly to replication fidelity, but can readily do so under conditions of elevated expression, (3) participation of Pols IV and V, in contrast to that of Pol II, is specific to the lagging strand, and (4) Pol I also makes a lagging-strand-specific fidelity contribution, limited, however, to the faithful filling of the Okazaki fragment gaps. The fidelity role of the Pol III τ subunit is also reviewed.     

大肠杆菌表达的TaqDNA聚合酶的纯化

Taq DNA聚合酶是分子生物学研究中最常用的热稳定DNA聚合酶之一,与其他热稳定DNA聚合酶具有相似的特征,其纯化策略不但有潜在的应用前景,也对同类聚合酶的分离具有指导意义。已报道的适宜大量制备Taq酶的方案所需成本较高,而文章介绍了一种利用国产阳离子交换树脂廉价制备Taq酶的方案。在本方案中,采用热变性、(NH4)SO4沉淀与724离子交换层析分离大肠杆菌表达的Taq酶,约18 g Na型树脂干粉一次可回收比活约8 131.98 U/mg、总酶活2.2×105U、近27.07 mg Taq酶。纯化的产率可达48.92%,纯化倍数约59.35。所制酶SDS-PAGE电泳只检测到94 kDa单一蛋白条带,未检测到DNA核酸酶污染,与商品酶的PCR扩增能力无区别。此纯化方法成本低,适合实验室一般性的制备和生产应用。     

A dynamic polymerase exchange with Escherichia coli DNA polymerase IV replacing DNA polymerase III on the sliding clamp

An assay that measures synchronized, processive DNA replication by Escherichia coli DNA polymerase III holoenzyme was used to reveal replacement of pol III by the specialized lesion bypass DNA polymerase IV when the replicative polymerase is stalled. When idled replication is restarted, a rapid burst of pol III-catalyzed synthesis accompanied by approximately 7-kb full-length products is strongly inhibited by the presence of pol IV. The production of slower-forming, shorter length DNA reflects a rapid takeover of DNA synthesis by pol IV. Here we demonstrate that pol IV rapidly (<15 s) obstructs the stable interaction between pol III* and the beta clamp (the lifetime of the complex is >5 min), causing the removal of pol III* from template DNA. We propose that the rapid replacement of pol III* on the beta clamp with pol IV is mediated by two processes, an interaction between pol IV and the beta clamp and a separate interaction between pol IV and pol III*. This newly discovered property of pol IV facilitates a dynamic exchange between the two free polymerases at the primer terminus. Our study suggests a model in which the interaction between pol III* and the beta clamp is mediated by pol IV to ensure that DNA replication proceeds with minimal interruption.     

Involvement of Escherichia coli K-12 DNA polymerase I in the growth of bacteriophage Mu.

We examined several aspects of bacteriophage Mu development in Escherichia coli strains that carry mutations in the polA structural gene for DNA polymerase I (PolI). We found that polA mutants were markedly less efficient than PolI wild-type (PolI+) strains in their capacity to form stable Mu lysogens and to support normal lytic growth of phage Mu. The frequency of lysogenization was determined for polA mutants and their isogenic PolI+ derivatives, with the result that mutants were lysogenized 3 to 8 times less frequently than were PolI+ cells. In one-step growth experiments, we found that phage Mu grew less efficiently in polA cells than in PolI+ cells, as evidenced by a 50 to 100% increase in the latent period and a 20 to 40% decrease in mean burst size in mutant cells. A further difference noted in infected polA strains was a 10-fold reduction in the frequency of Mu-mediated transposition of chromosomal genes to an F plasmid. Pulse labeling and DNA-DNA hybridization assays to measure the rate of phage Mu DNA synthesis after the induction of thermosensitive prophages indicated that phage Mu replication began at about the same time in both polA and PolI+ strains, but proceeded at a slower rate in polA cells. We conclude that PolI is normally involved in the replication and integration of phage Mu. However, since phage Mu does not exhibit an absolute requirement for normal levels of PolI, it appears that residual PolI activity in the mutant strains, other cellular enzymes, or both can partially compensate for the absence of normal PolI activity.     

Escherichia coli DNA polymerase II is stimulated by DNA polymerase III holoenzyme auxiliary subunits

DNA polymerase III of Escherichia coli requires multiple auxiliary factors to enable it to serve as a replicative complex. We demonstrate that auxiliary components of the DNA polymerase III holoenzyme, the gamma delta complex and beta subunit, markedly stimulate DNA polymerase II on long single-stranded templates. DNA polymerase II activity is enhanced by single-stranded DNA binding protein, but the stimulation by gamma delta and beta can be observed either in the absence or presence of single-stranded DNA binding protein. In contrast with DNA polymerase III, the requirement of DNA polymerase II for gamma delta cannot be bypassed by large excesses of the beta subunit at low ionic strength in the absence of the single-stranded DNA binding protein. The product of the DNA polymerase II-gamma delta-beta reaction on a uniquely primed single-stranded circle is of full template length; the reconstituted enzyme apparently is incapable of strand displacement synthesis. The possible biological implications of these observations are discussed.     

Site-directed mutagenesis with Escherichia coli DNA polymerase III holoenzyme

Escherichia coli DNA polymerase III holoenzyme was used to synthesize double-stranded DNA from M13 single-stranded DNA hybridized to a phosphorylated synthetic oligodeoxynucleotide containing a nucleotide substitution. The resulting DNA was transfected into E. coli JM101 without further treatment. Sequence analysis of randomly chosen phage clones revealed that the efficiency of mutagenesis was nearly 50%, which is the theoretical maximum. Treatment with DNA ligase after DNA synthesis was not necessary to obtain high efficiency of mutagenesis. Thus, use of DNA polymerase III holoenzyme provides a simple and efficient procedure for site-directed mutagenesis.