Properties of a spherical stratified gas discharge

Experimental data are obtained on the conditions for the stratification of spherical direct-current discharges and on the properties of the strata. The experiments were aimed at studying discharges in both molecular and inert gases at low pressures and were carried out with a steel chamber whose wall served as a cathode. An anode was placed at the center of the chamber. The discharge stratification was observed to be especially pronounced in media containing a small admixture of the vapor of a high-molecular substance (e.g., acetone). In discharges in pure inert gases, no strata were observed. The current-voltage characteristics of discharges at different pressures were obtained. The discharges were found to be unsteady: current pulses with a duration of about 1 microsecond and a characteristic repetition rate of about 1 kHz were detected against a steady current background and were found to correlate with the pulses of the integral emission from the discharge. The radius of each of the strata was determined as a function of its number and of the gas pressure and discharge current. The radial profiles of the time-averaged floating potential were measured in experiments with stratified discharges and with uniform discharges in argon.     

Glow discharge in singlet oxygen

Currently, there is no experimental data on the plasma balance in gas mixtures with a high content of singlet delta oxygen O₂(¹Δ_g). These data can be obtained by studying the parameters of an electric discharge in singlet oxygen produced by a chemical generator. The O₂(¹Δ_g) molecules significantly change the kinetics of electrons and negative ions in plasma. Hence, the discharge conditions at low and high. O₂(¹Δ_g) concentrations are very different. Here, the parameters of the positive column of a glow discharge in a gas flow from a chemical singlet-oxygen generator are studied. It is experimentally shown that, at an O₂(¹Δ_g) concentration of 50% and at pressures of 1.5 and 2 torr, the electric field required to sustain the discharge is considerably lower than in the case when all of the oxygen molecules are in the ground state. A theoretical model of the glow discharge is proposed whose predictions are in good agreement with the experimental data.     

Glow discharge with electrostatic confinement of electrons in a chamber bombarded by fast electrons

A metal substrate is immersed in plasma of glow discharge with electrostatic confinement of electrons inside the vacuum chamber volume V ≈ 0.12 m³ filled with argon or nitrogen at pressures 0.005–5 Pa, and dependence of discharge characteristics on negative substrate potential is studied. Emitted by the substrate secondary electrons bombard the chamber walls and it results in electron emission growth of the chamber walls and rise of gas ionization intensity inside the chamber. Increase of voltage U between the chamber and the substrate up to 10 kV at a constant discharge current I _d in the anode circuit results in a manifold rise of current I in the substrate circuit and decrease of discharge voltage U _d between the anode and the chamber from hundreds to tens of volts. At pressure p < 0.05 Pa nonuniformity of plasma density does not exceed ∼10%. Using the Child-Langmuir law, as well as measurement results of sheath width d between homogeneous plasma and a lengthy flat substrate dependent on voltage U ion current density j _i on the substrate surface and ion-electron emission coefficient γ _i are calculated. After the current in circuit of a substrate made of the same material is measured, the γ _i values may be used to evaluate the average dose of ion implantation. The rate of dose rise at a constant high voltage U is by an order of magnitude higher than in known systems equipped with generators of square-wave high-voltage pulses. Application to the substrate of 10-ms-wide sinusoidal high-voltage pulses, which follow each other with 100-Hz frequency, results in synchronous oscillations of voltage U and ion current I _i in the substrate circuit. In this case variation of the sheath width d due to oscillations of U and Ii is insignificant and d does not exceed several centimeters thus enabling substrate treatment in a comparatively small vacuum chamber.     

Freely localized microwave discharge in a supersonic gas flow

Plasma Physics Reports - A discharge produced by a focused microwave beam in a supersonic gas flow has been investigated experimentally. It is shown that the degree of ionization and the gas...     

Pulsed microwave discharge in a capillary filled with atmospheric-pressure gas

A pulsed microwave coaxial capillary plasma source generating a thin plasma filament along the capillary axis in an atmospheric-pressure argon flow is described. The dynamics of filament formation is studied, and the parameters of the gas and plasma in the contraction region are determined. A physical model of discharge formation and propagation is proposed. The model is based on the assumption that, under the conditions in which the electric fields is substantially below the threshold value, the discharge operates in a specific form known as a self-sustained-non-self-sustained (SNS) microwave discharge.     

Study of a DC gas discharge with a copper cathode in a water flow

A dc gas discharge between copper electrodes in the current range of 5–20 А was studied experimentally. The discharge gap length was varied within 45–70 mm. The cathode was a 10-mm-diameter rod placed in the water flowing out from a dielectric tube. Three discharge configurations differing in the position of the cathode upper end with respect to the water surface were considered: (i) above water; (ii) flush with the water surface, and (iii) under water. The electric and optical characteristics of the discharge in the second configuration were studied in more detail. It is established that the discharge properties are similar to those of an electric arc. Considerable cathode erosion was observed in the third configuration. It is revealed that fine-dispersed copper grains form in the course of erosion.     

A powerful electrohydrodynamic flow generated by a high-frequency dielectric barrier discharge in a gas

Theoretical and experimental studies of an electrohydrodynamic flow induced by a high-frequency dielectric barrier discharge distributed over a dielectric surface in a gas have been conducted. Dependences of the ion current, the gas flow velocity, and the spatial distributions thereof on the parameters of the power supply of the plasma ion emitter and an external electric field determined by the collector grid voltage have been described.     

Ignition of a combustible gas mixture by a high-current electric discharge in a closed volume

Results are presented from experimental studies and numerical calculations of the ignition of a stoichiometric CH₄: O₂ gas mixture by a high-current gliding discharge. It is shown that this type of discharge generates an axially propagating thermal wave (precursor) that penetrates into the gas medium and leads to fast gas heating. This process is followed by an almost simultaneous ignition of the gas mixture over the entire reactor volume.     

The effect of the operation modes of a gas discharge low-pressure amalgam lamp on the intensity of generation of 185 nm UV vacuum radiation

The effect of the discharge current, mercury vapor pressure, and the inert gas pressure on the intensity and efficiency of the 185 nm line generation are considered. The spectra of the UV radiation (vacuum ultraviolet) transmission by protective coatings from the oxides of rare earth metals and aluminum are investigated.     

Ecton processes in the generation of pulsed runaway electron beams in a gas discharge

As was shown earlier for pulsed discharges that occur in electric fields rising with extremely high rates (10¹⁸ V/(cm s)) during the pulse rise time, the electron current in a vacuum discharge is lower than the current of runaway electrons in an atmospheric air discharge in a 1-cm-long gap. In this paper, this is explained by that the field emission current from cathode microprotrusions in a gas discharge is enhanced due to gas ionization. This hastens the initiation of explosive electron emission, which occurs within 10^–11 s at a current density of up to 10¹⁰ A/cm². Thereafter, a first-type cathode spot starts forming. The temperature of the cathode spot decreases due to heat conduction, and the explosive emission current ceases. Thus, the runaway electron current pulse is similar in nature to the ecton phenomenon in a vacuum discharge.     

Electrohydrodynamic effect resulting from high-frequency barrier discharge in gas

The formation of an electrohydrodynamic flow in atmospheric air by using a high-frequency barrier discharge distributed over the dielectric surface is investigated. The influence of variations in parameters of a fully solid-state pulse generator (with a peak voltage of 0–12 kV, a tunable repetition rate of 10–25 kHz, and a pulse duration of 7 μs) on the current of plasma ion emitter and velocity characteristics of airflow is considered.     

Axisymmetric electric discharge as a means for distant heating of gas media

Gas-dynamic phenomena accompanying a ring electric discharge excited in atmospheric-pressure air have been studied experimentally and theoretically. It is shown experimentally that the discharge generates a toroidal (three-dimensional) shock wave that converges toward the axis. A mathematical model describing the focusing of a toroidal shock wave is constructed. The measured characteristics of shock processes accompanying the discharge agree well with results of calculations. This makes it possible to estimate the gas temperature that can be achieved in the convergent shock wave at a certain distance from the center of the ring discharge.     

Influence of a transverse magnetic field on the characteristics of a dc gas discharge

The influence of a transverse magnetic field and the working-gas pressure on the rotation frequency of the current channel, as well as on the electric field in the positive column and the cathode voltage drop in a dc gas discharge, was studied experimentally. The working gases were pure hydrogen and hydrogen-methane, hydrogen-argon, and hydrogen-argon-methane mixtures. It is shown that a transverse (with respect to the discharge current) magnetic field stabilizes a normal glow discharge against a transition to an arc discharge at specific absorbed powers above 300 W/cm³. The cathode voltage drop and the electric field in the positive column are measured. It is shown that the electric field does not depend on the magnetic field strength, whereas the cathode voltage drop increases with increasing magnetic field. It is found that the rotation frequency of the current channel is a complicated function of the discharge parameters and attains 400 Hz.     

Dynamics of the water molecule density in a discharge chamber filled with a low-pressure humid gas

The dynamics of the H₂O molecule density in a metal gas-discharge chamber filled with low-pressure water vapor or its mixtures with noble gases was investigated by manometric and spectral methods. Regimes both with and without discharge excitation were studied. In the absence of a discharge, the molecule density dynamics is governed by the heterogeneous interaction of molecules with the chamber walls. In the presence of a discharge, in addition to the heterogeneous interaction, fast plasmachemical molecule dissociation also contributes to the initial stage of H₂O molecule loss. The role of heating of the chamber walls is discussed.     

Simulations of a surface glow discharge in a supersonic gas flow in the presence of external ionization

Results of two-dimensional hydrodynamic simulations of a surface glow discharge operating at pressures of 0.2–0.5 Torr in a nitrogen flow propagating with a velocity of 1000 m/s in the presence of external ionization are presented. The effect of the external ionization rate on discharge operation is analyzed. The current-voltage characteristics of the discharge are calculated for different intensities of external ionization in both the presence and absence of secondary electron emission from the cathode. The discharge structure and plasma parameters in the vicinity of the loaded electrode are considered. It is shown that, when the discharge operates at the expense of secondary emission from the cathode, the discharge current and cathode sheath configuration are insensitive to external ionization. It is also demonstrated that, even at a high rate of external ionization, the discharge operates due to secondary emission from the cathode.     

Glow Pause in a Helium Plasma at Room and Liquid Nitrogen Temperatures on Applying a Nanosecond Voltage Pulse to a Glow Discharge

The features of the relaxation of a quasi-steady glow discharge after extra excitation by a nanosecond high-voltage pulse are studied experimentally. It is shown that the plasma relaxation is characterized by the existence of a time interval with a low emission intensity—a glow pause. A kinetic model of the helium plasma relaxation is developed. It is shown that the nanosecond discharge that creates extra ionization and metastable atoms enables one to keep the electron temperature at a quasi-steady level within the range 0.05–0.5 eV for several hundred microseconds during the glow pause. The effect of the helium temperature on the glow pause features is investigated.     

Electrode microwave discharge in nitrogen: Structure and gas temperature

Electrode microwave discharges in nitrogen at pressures of 1–16 Torr and input microwave powers of 30–180 W have been studied by space-resolved emission spectroscopy. It is shown that the discharge is highly nonuniform. The relative intensities of the first and second positive nitrogen bands, as well as of the first negative band of nitrogen ions, are found to vary significantly throughout a discharge because, in different discharge regions, emitting particles are excited by different mechanisms. The gas temperature was determined by the method of the unresolved rotational structure of different sequences of the emission spectra of the second positive system of nitrogen.     

The Phycomyces lens: measurement of the sporangiophore intensity profile using a fiber optic microprobe

A fiber optic microprobe, 5.5 m in diameter, was used as a detector to measure the light intensity profile at the distal cell surface of Phycomyces blakesleeanus (Burgeff) sporangiophores that were irradiated unilaterally by a collimated xenon source. The light intensity at a fixed location of the cell surface showed large random variations over time which were probably the result of optical effects of particles being carried past the probe by cytoplasmic streaming. The intensity profile, formed around the distal periphery of the cell by the lens action of the sporangiophore, was determined from intensity measurements made while the probe was held fixed and the incident beam direction was varied in angle of azimuth. The resulting profile consisted of two steeply rising sides enclosing a central plateau or shallow well which ranged in fluence rate from 1.6 to 2.2 times that of the incident beam. These experimental findings differ from theoretical modeling where much greater contrast between the sides and central portion of the lens profile was predicted. These results also indicate that the mechanism of phototropic sensory perception in Phycomyces may filter out cytoplasmic light flicker and may not require strong contrasting regions within the lens profile to detect light direction.