Study of spatiotemporal dynamics of a nanosecond atmospheric-pressure dielectric barrier discharge in millimeter-long air gaps

The spatiotemporal dynamics of a nanosecond atmospheric-pressure dielectric barrier discharge in 1- to 3-mm-long air gaps was studied experimentally. By using a segmented electrode, data on the time evolution of the discharge in different regions of the discharge gap were obtained. The uniformity of the discharge over the cross section is estimated by analyzing the spatial distribution of its glow.     

Combined barrier discharge in atmospheric-pressure air

A combined (dual) barrier electric discharge in atmospheric-pressure air is investigated. The discharge is induced in a discharge chamber with two pairs of electrodes of different configurations. The electrodes are connected to two independent high voltage power supplies. The plasma-chemical synthesis of ozone was studied in atmospheric pressure air depending on the parameters of each discharge contour. The analysis was performed in terms of efficiency and practical application of a combined barrier discharge.     

Energy distribution of runaway electrons generated by a nanosecond discharge in atmospheric-pressure air

The spectra of an ultrashort avalanche electron beam generated by a nanosecond discharge in atmospheric-pressure air were investigated. The temporal characteristics of the beam current pulses, gap voltage, and discharge current in a gas diode were measured with a time resolution of ～0.1 ns. A simple technique was developed for recovering electron spectra from the curves of beam attenuation by aluminum foils. The effect of the cathode design, electrode gap length, and generator parameters on the electron spectra were studied using seven setups. It is shown that generation of electrons with anomalously high energies requires the use of cathodes with increased curvature radius.     

Numerical simulation of a surface barrier discharge in air

The development of a surface barrier discharge in air at atmospheric pressure under the action of a constant voltage of different polarity is simulated numerically. When the polarity of the high-voltage electrode is negative, the discharge develops as an ionization wave that moves along the dielectric surface. When the polarity is positive, the discharge develops as a streamer that first moves above the dielectric surface and then comes into contact with and continues to develop along it. In the case of a high-voltage electrode of positive polarity, the discharge zone above the dielectric surface is approximately five times thicker than that in the case of negative polarity. The characteristic aspects of numerical simulation of the streamer phase of a surface barrier discharge are discussed. The numerical results on the density of the charge stored at the dielectric surface and on the length of the discharge zone agree with the experimental data.     

Plasma decay in the afterglow of a high-voltage nanosecond discharge in air

The decay of air plasma produced by a high-voltage nanosecond discharge at room temperature and gas pressures in the range of 1–10 Torr was studied experimentally and theoretically. The time dependence of the electron density was measured with a microwave interferometer. The initial electron density was about 10¹² cm⁻³. The discharge homogeneity was monitored using optical methods. The dynamics of the charged particle densities in the discharge afterglow was simulated by numerically solving the balance equations for electron and ions and the equation for the electron temperature. It was shown that, under these experimental conditions, plasma electrons are mainly lost due to dissociative and three-body recombination with ions. Agreement between the measured and calculated electron densities was achieved only when the rate constant of the three-body electron-ion recombination was increased by one order of magnitude and the temperature dependence of this rate constant was modified. This indicates that the mechanism for three-body recombination of molecular ions differs from that of the well-studied mechanism of atomic ion recombination.     

Prebreakdown stages of a barrier discharge in air

The initial stages of a barrier discharge in a short air gap at atmospheric pressure are investigated by means of numerical simulations. A highly nonuniform electric field caused by the residual surface charges on the dielectric surfaces was taken into account. The results of calculations of the two-dimensional dynamics of the discharge radiation are in good agreement with the experiment.     

Kinetic processes initiated by a nanosecond high-current discharge in hot air

Results from numerical investigations of kinetic processes initiated by a pulsed nanosecond discharge in hot (T ₀ ≥ 1000 K) air at atmospheric pressure are presented. The calculated results on the dynamics of the electron density, the population of the N₂(B³Π _g ) and N₂(C³Π _u ) states, and the atomic oxygen density in the axial discharge region agree with experiment. The method for determining the gas temperature by measuring the rotational structure of the transitions N₂(C³Π _u , ν) → N₂(B³Π _g , ν′) of the 2⁺ nitrogen system is analyzed. It is shown that, in relatively weak reduced electric fields typical of secondary discharge pulses, the electron impact excitation of the N₂(C³Π _u ) state from the ground state N₂(X¹Σ _g ⁺) can be accompanied by its additional step population from the N₂(B³Π _g ), N₂(a′Σ _u ⁻), and other electronic states. This effect substantially influences the rotational distribution of nitrogen molecules in the N₂(C³Π _u , ν) state; moreover, the temperature determined from this distribution can be substantially higher than the true gas temperature.     

Dynamics of the optical emission from a high-voltage diffuse discharge in a rod-plane electrode system in atmospheric-pressure air

Results are presented from experimental investigations of the dynamics of optical emission from a nanosecond diffuse discharge in a rod-plane electrode system. A study was made of discharges in a 10-cm-long interelectrode gap in atmospheric-pressure air (the cathode being a 1-cm-diameter rod with a bullet-shaped end). The voltage across the discharge gap was 220 kV and the voltage pulse duration was 180 ns, the voltage rise time being 10 ns. In experiments, the discharges were observed to evolve through two stages: the bridging stage and the conduction stage. The bridging stage begins with intense optical emission from the cathode region, the onset of the emission being delayed with respect to the beginning of the voltage pulse. Simultaneously with the onset of optical emission, a displacement current corresponding to the motion of charged particles begins to be generated in the cathode region. The duration of this current corresponds to the time the emission front takes to bridge the gap. As the emission front reaches the anode region, the current increases abruptly, indicating the beginning of the conduction stage. It was found that the time delay of optical emission relative to the beginning of the voltage pulse largely governs the discharge parameters: as the time delay becomes longer, the emission front velocity in the bridging stage increases from 0.6 to 1.5 cm/ns, the probability of realizing a multichannel structure of the discharge becomes higher, and the discharge current and the intensity of X-ray emission from the discharge grow.     

Mechanism of streamer stopping in a surface dielectric barrier discharge

Two-dimensional numerical simulations of streamer development in a surface dielectric barrier discharge excited by a voltage pulse with a duration of 30–50 ns in atmospheric air show that the streamer propagation velocity is mainly governed by the velocity of potential diffusion along streamer channels. The calculated streamer length substantially exceeds the experimentally observed one due to the long-term conservation of the conductivity of these channels. A hypothesis on the three-dimensional character of the decay of the surface streamer channel is proposed. The model account of this effect in two-dimensional simulations reduces the calculated time of streamer development and the calculated streamer length to the experimentally observed values.     

Some features of imaging of the processes occurring in an extended arc discharge in atmospheric-pressure air

Processes occurring in the low-temperature plasma of extended quasi-stationary arc discharges in air between graphite electrodes are investigated. Along with the conventional (constricted) discharge geometry, other discharge modes—diffuse (distributed) and diffuse-constricted—are studied. Contraction, stratification, and shunting processes are considered. Current oscillation modes are revealed that are caused by the interaction between the cathode and anode jets and the origination of plasma jets and solid particles from the locally overheated anode surface. 1 The use of graphite electrodes with standard atmospheric pressure excludes the presence of the liquid phase in the electrode spots     

Decomposition of toluene in a steady-state atmospheric-pressure glow discharge

Results are presented from experimental studies of decomposition of toluene (C₆H₅CH₃) in a polluted air flow by means of a steady-state atmospheric pressure glow discharge at different water vapor contents in the working gas. The experimental results on the degree of C₆H₅CH₃ removal are compared with the results of computer simulations conducted in the framework of the developed kinetic model of plasma chemical decomposition of toluene in the N₂: O₂: H₂O gas mixture. A substantial influence of the gas flow humidity on toluene decomposition in the atmospheric pressure glow discharge is demonstrated. The main mechanisms of the influence of humidity on C₆H₅CH₃ decomposition are determined. The existence of two stages in the process of toluene removal, which differ in their duration and the intensity of plasma chemical decomposition of C₆H₅CH₃ is established. Based on the results of computer simulations, the composition of the products of plasma chemical reactions at the output of the reactor is analyzed as a function of the specific energy deposition and gas flow humidity. The existence of a catalytic cycle in which hydroxyl radical OH acts a catalyst and which substantially accelerates the recombination of oxygen atoms and suppression of ozone generation when the plasma-forming gas contains water vapor is established.     

Pulsed microwave discharge in a capillary filled with atmospheric-pressure gas

A pulsed microwave coaxial capillary plasma source generating a thin plasma filament along the capillary axis in an atmospheric-pressure argon flow is described. The dynamics of filament formation is studied, and the parameters of the gas and plasma in the contraction region are determined. A physical model of discharge formation and propagation is proposed. The model is based on the assumption that, under the conditions in which the electric fields is substantially below the threshold value, the discharge operates in a specific form known as a self-sustained-non-self-sustained (SNS) microwave discharge.     

Electric characteristics of a surface barrier discharge with a plasma induction electrode

Static and dynamic current-voltage and charge-voltage characteristics of a surface barrier discharge with a plasma induction electrode have been investigated experimentally. The dependences of the discharge current on both the gas pressure in the induction electrode tube and the winding pitch of the corona electrode, as well as of the discharge power efficiency on the applied voltage, have been measured.     

Simulation of nonstationary phenomena in atmospheric-pressure glow discharge

Nonstationary processes in atmospheric-pressure glow discharge manifest themselves in spontaneous transitions from the normal glow discharge into a spark. In the experiments, both so-called completed transitions in which a highly conductive constricted channel arises and incomplete transitions accompanied by the formation of a diffuse channel are observed. A model of the positive column of a discharge in air is elaborated that allows one to interpret specific features of the discharge both in the stationary stage and during its transition into a spark and makes it possible to calculate the characteristic oscillatory current waveforms for completed transitions into a spark and aperiodic ones for incomplete transitions. The calculated parameters of the positive column in the glow discharge mode agree well with experiment. Data on the densities of the most abundant species generated in the discharge (such as atomic oxygen, metastable nitrogen molecules, ozone, nitrogen oxides, and negative oxygen ions) are presented.     

Cathode fall parameters of a self-sustained normal glow discharge in atmospheric-pressure helium

Results from comprehensive studies of a high-current self-sustained glow discharge in atmospheric-pressure helium are presented. The main parameters of the cathode fall, namely, the electric field pro-file, cathode fall thickness, current density, gas temperature, and heat flux to the cathode are determined. The results obtained are discussed using one-dimensional models of the cathode fall with allowance for volumetric heat release.     

Energy of electrons generated during a subnanosecond breakdown in atmospheric-pressure air

The influence of the cathode design on the energy of the main group of electrons generated during a subnanosecond breakdown in atmospheric-pressure air was studied experimentally. The electron energy was measured using a time-of-flight spectrometer with a picosecond time resolution. It is shown that the energy of the main group of electrons increases with increasing cathode curvature radius. It is established using 400- to 650-μm-thick aluminum foils that the electron energy reaches its maximum value in voltage pulses with abrupt trailing edges and amplitudes below the maximum amplitude. Electrons with maximum energies are generated with a stronger spatial and amplitude scatter than those with average energies.     

Parameters of a supershort avalanche electron beam generated in atmospheric-pressure air

Conditions under which the number of runaway electrons in atmospheric-pressure air reaches ∼5 × 10¹⁰ are determined. Recommendations for creating runaway electron accelerators are given. Methods for measuring the parameters of a supershort avalanche electron beam and X-ray pulses from gas-filled diodes, as well as the discharge current and gap voltage, are described. A technique for determining the instant of runaway electron generation with respect to the voltage pulse is proposed. It is shown that the reduction in the gap voltage and the decrease in the beam current coincide in time. The mechanism of intense electron beam generation in gas-filled diodes is analyzed. It is confirmed experimentally that, in optimal regimes, the number of electrons generated in atmospheric-pressure air with energies T > eU _m , where U _m is the maximum gap voltage, is relatively small.     

Self-consistent model of a pulsed air discharge excited by surface waves

A complete self-consistent electrodynamic model of a pulsed gas discharge excited by surface waves is developed. The model allows one to calculate both the initial phase of the discharge front propagation and the parameters of the produced plasma. The spatiotemporal evolution of the electromagnetic field and plasma parameters at the discharge front is investigated for the first time. It is shown that discharge propagation is mainly governed by a breakdown wave in an inhomogeneous electric field at the leading edge of the ionization front. It is found that the effect of the electric field enhancement in the plasma resonance region significantly affects the velocity of the breakdown wave. The results of calculations agree well with experimental data.     

Study of the oxidation of alkanes in their mixtures with oxygen and air under the action of a pulsed volume nanosecond discharge

The slow oxidation of alkanes (from methane to hexane) in their stoichiometric mixtures with oxygen or air under the action of nanosecond pulsed discharges was investigated. The discharges were excited in a tube of diameter 5 cm and length of 20 cm by 25-ns voltage pulses with an amplitude of 10 kV and a repetition rate of 40 Hz. The initial pressure in the mixture was varied in the range 0.76–10.1 torr. The current, the electric field strength, and the power deposited in a discharge were measured with a nanosecond time resolution. In time-resolved and time-integrated measurements, the intensities of the following bands were determined: CO ₂ ⁺ (B²Σ → X²Π, δv=0), CH(A²Δ, v′=0 → X²Π, v″=0), OH(A²Σ, v′=0 → X²Π, v″=0), CO(B¹Σ, v′=0 → A¹Π, v″=2), NO(A²Σ → X²Π, δv=3), N₂(C³Π, v′=1 → B³Π, v″=7), N₂(B³Π, v′=6 → A³Σ, v″=3), and N ₂ ⁺ (B²Σ, v′=0 → X²Σ, v″=2). The methane concentration was measured from the absorption of He-Ne laser radiation. Based on the results of optical measurements, the times of the complete oxidation of hydrocarbons were determined.     

Study of the homogeneity of the current distribution in a dielectric barrier discharge in air by means of a segmented electrode

The current distribution in a dielectric barrier discharge in atmospheric-pressure air at a natural humidity of 40–60% was studied experimentally with a time resolution of 200 ps. The experimental results are interpreted by means of numerically simulating the discharge electric circuit. The obtained results indicate that the discharge operating in the volumetric mode develops simultaneously over the entire transverse cross section of the discharge gap.