Discriminating small molecule DNA binding modes by single molecule force spectroscopy

Drugs may interact with double stranded DNA via a variety of binding modes, each mode giving rise to a specific pharmacological function. Here we demonstrate the ability of single molecule force spectroscopy to discriminate between different interaction modes by measuring the mechanical properties of DNA and their modulation upon the binding of small molecules. Due to the unique topology of double stranded DNA and due to its base pair stacking pattern, DNA undergoes several well-characterised structural transitions upon stretching. We show that small molecule binding markedly affects these transitions in ways characteristic to the binding mode and that these effects can be detected at the level of an individual molecule. The minor groove binder berenil, the crosslinker cisplatin and the intercalator ethidium bromide are compared.     

Quantitative single cell and single molecule proteomics for clinical studies

1. Download : Download high-res image (102KB)
2. Download : Download full-size image

     

Kinetic schemes for post-synchronized single molecule dynamics

Recordings from single molecule experiments can be aggregated to determine average kinetic properties of the system under observation. The kinetics after a synchronized reaction step can be interpreted using all of the standard tools developed for ensemble perturbation experiments. The kinetics leading up to a synchronized event, determined by the lifetimes of the preceding states; however, are not as obvious if the reaction has reversible steps or branches. Here we describe a general procedure for dealing with these situations.     

Force spectroscopy of barnase-barstar single molecule interaction

Results of the single molecule force spectroscopy study of specific interactions between ribonuclease barnase and its inhibitor barstar are presented. Experimental data obtained for the force loading rate ranging 2-70 nN/s are well approximated by a single straight line, from which the dissociation barrier of the width of 0.12 nm and height of 0.75-0.85 × 10(-19)J can be inferred. The measured value of specific interaction does not depend on the NaCl concentration. This apparently contradicts the well-known dependence of the binding energy of this pair on the salt concentration, but such a "contradiction" is explained by the insensitivity of the force spectroscopy data to the relatively long-range electrostatic interaction. The latter essentially contributes to the value of barnase-barstar binding energy revealed by biochemical measurements, and it is exactly this electrostatic interaction which is influenced by the salt concentration.     

Highly efficient single molecule detection in microstructures

For DNA single molecule sequencing, the complete detection of all dye-labeled monomers which are cleaved off during the sequencing reaction is an essential requirement. In this work we address the feasibility of single molecule detection in microstructures with a confocal multi element set-up. We present statistical data on single molecule recognition and explain a refined data evaluation technique for single molecule burst analysis. From these data the signal-to-noise ratio in microstructures is evaluated as well as the overall detection efficiency. So far, detection efficiencies of single molecule events of up to 60% have been shown in microstructures.     

Three-dimensional molecular modeling with single molecule FRET

Single molecule fluorescence energy transfer experiments enable investigations of macromolecular conformation and folding by the introduction of fluorescent dyes at specific sites in the macromolecule. Multiple such experiments can be performed with different labeling site combinations in order to map complex conformational changes or interactions between multiple molecules. Distances that are derived from such experiments can be used for determination of the fluorophore positions by triangulation. When combined with a known structure of the macromolecule(s) to which the fluorophores are attached, a three-dimensional model of the system can be determined. However, care has to be taken to properly derive distance from fluorescence energy transfer efficiency and to recognize the systematic or random errors for this relationship. Here we review the experimental and computational methods used for three-dimensional modeling based on single molecule fluorescence resonance transfer, and describe recent progress in pushing the limits of this approach to macromolecular complexes.     

Comparative energy measurements in single molecule interactions

Single molecule experiments have opened promising new avenues of investigations in biology, but the quantitative interpretation of results remains challenging. In particular, there is a need for a comparison of such experiments with theoretical methods. We experimentally determine the activation free energy for single molecule interactions between two synaptic proteins syntaxin 1A and synaptobrevin 2, using an atomic force microscope and the Jarzynski equality of nonequilibrium thermodynamics. The value obtained is shown to be reasonably consistent with that from single molecule reaction rate theory. The temperature dependence of the spontaneous dissociation lifetime along with different pulling speeds is used to confirm the approach to the adiabatic limit. This comparison of the Jarzynski equality for intermolecular interactions extends the procedure for calculation of activation energies in nonequilibrium processes.     

活细胞单分子实时视见研究

我们对细胞生物学与分子生物学中有关分子事件和相互作用的认识,大部分都是集团平均水平研究的结果,并且基于所有的分子在给定时间内以完全相同的方式运动这样一种不真实的假设。现在,激光技术和全内反射显微镜的应用,以及绿色荧光蛋白(green fluorescent proteins,GFPs)等新的分子荧光探针的出现,使得显示活细胞单个生物分子的运动行为和轨迹成为可能。单分子水平的研究将会加深人们对分子和细胞生物学的基本概念的认识。     

Challenges in quantitative single molecule localization microscopy

Single molecule localization microscopy (SMLM), which can provide up to an order of magnitude improvement in spatial resolution over conventional fluorescence microscopy, has the potential to be a highly useful tool for quantitative biological experiments. It has already been used for this purpose in varied fields in biology, ranging from molecular biology to neuroscience. In this review article, we briefly review the applications of SMLM in quantitative biology, and also the challenges involved and some of the solutions that have been proposed. Due to its advantages in labeling specificity and the relatively low overcounting caused by photoblinking when photo-activable fluorescent proteins (PA-FPs) are used as labels, we focus specifically on Photo-Activated Localization Microscopy (PALM), even though the ideas presented might be applicable to SMLM in general. Also, we focus on the following three quantitative measurements: single molecule counting, analysis of protein spatial distribution heterogeneity and co-localization analysis.     

The development of single molecule environmental sensors

The participants at the meeting reflected the broad range of expertise that is required to realize improved methods for extremely high sensitivity or single molecule detection. It is quite clear that the answers lie at the interface of biology, chemistry, engineering and molecular design.     

Gene expression analysis using single molecule detection

Recent developments of single molecule detection techniques and in particular the introduction of fluorescence correlation spectroscopy (FCS) led to a number of important applications in biological research. We present a unique approach for the gene expression analysis using dual-color cross-correlation. The expression assay is based on gene-specific hybridization of two dye-labeled DNA probes to a selected target gene. The counting of the dual-labeled molecules within the solution allows the quantification of the expressed gene copies in absolute numbers. As detection and analysis by FCS can be performed at the level of single molecules, there is no need for any type of amplification. We describe the gene expression assay and present data demonstrating the capacity of this novel technology. In order to prove the gene specificity, we performed experiments with gene-depleted total cDNA. The biological application was demonstrated by quantifying selected high, medium and low abundant genes in cDNA prepared from HL-60 cells.     

Interlaced optical force-fluorescence measurements for single molecule biophysics

Combining optical tweezers with single molecule fluorescence offers a powerful technique to study the biophysical properties of single proteins and molecules. However, such integration into a combined, coincident arrangement has been severely limited by the dramatic reduction in fluorescence longevity of common dyes under simultaneous exposure to trapping and fluorescence excitation beams. We present a novel approach to overcome this problem by alternately modulating the optical trap and excitation beams to prevent simultaneous exposure of the fluorescent dye. We demonstrate the dramatic reduction of trap-induced photobleaching effects on the common single molecule fluorescence dye Cy3, which is highly susceptible to this destructive pathway. The extension in characteristic fluorophore longevity, a 20-fold improvement when compared to simultaneous exposure to both beams, prolongs the fluorescence emission to several tens of seconds in a combined, coincident arrangement. Furthermore, we show that this scheme, interlaced optical force-fluorescence, does not compromise the trap stiffness or single molecule fluorescence sensitivity at sufficiently high modulation frequencies. Such improvement permits the simultaneous measurement of the mechanical state of a system with optical tweezers and the localization of molecular changes with single molecule fluorescence, as demonstrated by mechanically unzipping a 15-basepair DNA segment labeled with Cy3.     

Thermophilic topoisomerase I on a single DNA molecule

Control of DNA topology is critical in thermophilic organisms in which heightened ambient temperatures threaten the stability of the double helix. An important role in this control is played by topoisomerase I, a member of the type IA family of topoisomerases. We investigated the binding and activity of this topoisomerase from the hyperthermophilic bacterium Thermotoga maritima on duplex DNA using single molecule techniques, presenting it with various substrates such as (+) plectonemes, (-) plectonemes, and denaturation bubbles. We found the topoisomerase inactive on both types of plectonemes, but active on denaturation bubbles produced at increased stretching forces in underwound DNA. The relaxation rate depended sensitively on the applied force and the protein concentration. These observations could be understood in terms of a preference of the topoisomerase for single-stranded DNA over double-stranded DNA and allowed for a better understanding of activity of the topoisomerase in bulk experiments on circular plasmids. Binding experiments on a single duplex molecule using a mutant unable to perform cleavage confirmed this interpretation and suggested that T.maritima topoisomerase I behaves like an SSB by lowering the denaturation threshold of underwound DNA. Finally, experiments with a unique single-stranded DNA showed that both ends of the cleaved DNA are tightly maintained by the enzyme, supporting an enzyme-bridged mechanism for this topoisomerase.     

Bacteriophage strain typing by rapid single molecule analysis

Rapid characterization of unknown biological samples is under the focus of many current studies. Here we report a method for screening of biological samples by optical mapping of their DNA. We use a novel, one-step chemo-enzymatic reaction to covalently bind fluorophores to DNA at the four-base recognition sites of a DNA methyltransferase. Due to the diffraction limit of light, the dense distribution of labels results in a continuous fluorescent signal along the DNA. The amplitude modulations (AM) of the fluorescence intensity along the stretched DNA molecules exhibit a unique molecular fingerprint that can be used for identification. We show that this labelling scheme is highly informative, allowing accurate genotyping. We demonstrate the method by labelling the genomes of λ and T7 bacteriophages, resulting in a consistent, unique AM profile for each genome. These profiles are also successfully used for identification of the phages from a background phage library. Our method may provide a facile route for screening and typing of various organisms and has potential applications in metagenomics studies of various ecosystems.