Construction of a high-density genetic linkage map and QTL analysis of morphological traits in an F1 Malusdomestica × Malus baccata hybrid

Apple is considered the most commonly grown fruit crop in temperate regions that brings great economic profits to fruit growers. Dwarfing rootstocks have been extensively used in apple breeding as well as commercial orchards, but the molecular and genetic basis of scion dwarfing and other morphological traits induced by them is still unclear. At present, we report a genetic map of Malusdomestica × Malus baccata with high density. The F₁ population was sequenced by a specific length amplified fragment (SLAF). In the genetic map, 5064 SLAF markers spanning 17 linkage groups (LG) were included. Dwarf-related and other phenotypic traits of the scion were evaluated over a 3-year growth period. Based on quantitative trait loci (QTL) evaluation of plant height and trunk diameter, two QTL clusters were found on LG 11, which exhibited remarkable influences on dwarfing of the scion. In this analysis, QTL DW2, which was previously reported as a locus that controls dwarfing, was confirmed. Moreover, three novel QTLs for total flower number and branching flower number were detected on LG2 and LG4, exhibited the phenotypic variation that has been explained by QTL ranging from 8.80% to 34.80%. The findings of the present study are helpful to find scion dwarfing and other phenotypes induced by rootstock in the apple.Supplementary InformationThe online version contains supplementary material available at 10.1007/s12298-021-01069-0.     

High‐density genetic map of Miscanthus sinensis reveals inheritance of zebra stripe

Miscanthus is a perennial C₄ grass that has recently become an important bioenergy crop. The efficiency of breeding improved Miscanthus biomass cultivars could be greatly increased by marker‐assisted selection. Thus, a high‐density genetic map is critical to Miscanthus improvement. In this study, a mapping population of 261 F₁ progeny was developed from a cross between two diploid M. sinensis cultivars, ‘Strictus’ and ‘Kaskade’. High‐density genetic maps for the two parents were produced with 3044 newly developed single nucleotide polymorphisms (SNPs) obtained from restriction site‐associated DNA sequencing, and 138 previously mapped GoldenGate SNPs. The female parent (‘Strictus’) map spanned 1599 cM, with 1989 SNPs on 19 linkage groups, and an average intermarker spacing of 0.8 cM. The length of the male parent (‘Kaskade’) map was 1612 cM, with 1821 SNPs, and an average intermarker spacing of 0.9 cM. The utility of the map was confirmed by locating quantitative trait loci (QTL) for the zebra‐striped trait, which was segregating in this population. Three QTL for zebra‐striped presence/absence (zb1, zb2 on LG 7, and zb3 on LG 10) and three for zebra‐striped intensity (zbi1, zbi2, zbi3 on LGs 7, 10, 3) were identified. Each allele that caused striping was recessive. Incomplete penetrance was observed for each zb QTL, but penetrance was greatest when two or more zb QTL were homozygous for the causative alleles. Similarly, the intensity of striping was greatest when two or more zbi QTL were homozygous for alleles that conferred the trait. Comparative mapping indicated putative correspondence between zb3 and/or zbi2 on LG 10 to previously sequenced genes conferring zebra stripe in maize and rice. These results demonstrate that the new map is useful for identifying marker–trait associations. The mapped markers will become a valuable community resource, facilitating comparisons among studies and the breeding of Miscanthus.     

QTL mapping of economically important traits in Silkworm (<Emphasis Type="Italic">Bombyx mori</Emphasis>)

A backcrossed population(BC1)was derived from a cross between C1AFLP technique was employed for mapping the QTLs.The QTLs for the whole cocoon weight,cocoon shell weight,ratio of cocoon shell,weight of pupae etc.Were analyzed and 11 QTLs were detected based on the constructed linkage map.Two QTLs for whole cocoon weight were localized on linkage group 6 and 19; three QTLs for cocoon shell weight were localized on linkage group 3,14 and 19; three QTLs for ratio of cocoon shell were localized on the linkage group 2,11and 15,and three QTLs for the weight of pupae were localized on linkage 2,14 and 19.All these have laid an important base for the marker assisted breeding of the silkworm.     

Constructing a high-density linkage map for Gossypium hirsutum × Gossypium barbadense and identifying QTLs for lint percentage

To introgress the good fiber quality and yield from Gossypium barbadense into a commercial Upland cotton variety, a high-density simple sequence repeat(SSR) genetic linkage map was developed from a BC1F1 population of Gossypium hirsutum×Gossypium barbadense. The map comprised 2,292 loci and covered 5115.16 centi Morgan(c M) of the cotton AD genome, with an average marker interval of 2.23 c M. Of the marker order for 1,577 common loci on this new map, 90.36% agrees well with the marker order on the D genome sequence genetic map. Compared with five published high-density SSR genetic maps, 53.14% of marker loci were newly discovered in this map. Twenty-six quantitative trait loci(QTLs) for lint percentage(LP) were identified on nine chromosomes. Nine stable or common QTLs could be used for marker-assisted selection. Fifty percent of the QTLs were from G. barbadense and increased LP by 1.07%–2.41%. These results indicated that the map could be used for screening chromosome substitution segments from G. barbadense in the Upland cotton background, identifying QTLs or genes from G. barbadense, and further developing the gene pyramiding effect for improving fiber yield and quality.     

A high‐density linkage map enables a second‐generation collared flycatcher genome assembly and reveals the patterns of avian recombination rate variation and chromosomal evolution

Detailed linkage and recombination rate maps are necessary to use the full potential of genome sequencing and population genomic analyses. We used a custom collared flycatcher 50 K SNP array to develop a high‐density linkage map with 37 262 markers assigned to 34 linkage groups in 33 autosomes and the Z chromosome. The best‐order map contained 4215 markers, with a total distance of 3132 cM and a mean genetic distance between markers of 0.12 cM . Facilitated by the array being designed to include markers from most scaffolds, we obtained a second‐generation assembly of the flycatcher genome that approaches full chromosome sequences (N50 super‐scaffold size 20.2 Mb and with 1.042 Gb (of 1.116 Gb) anchored to and mostly ordered and oriented along chromosomes). We found that flycatcher and zebra finch chromosomes are entirely syntenic but that inversions at mean rates of 1.5–2.0 event (6.6–7.5 Mb) per My have changed the organization within chromosomes, rates high enough for inversions to potentially have been involved with many speciation events during avian evolution. The mean recombination rate was 3.1 cM /Mb and correlated closely with chromosome size, from 2 cM /Mb for chromosomes >100 Mb to >10 cM /Mb for chromosomes <10 Mb. This size dependence seemed entirely due to an obligate recombination event per chromosome; if 50 cM was subtracted from the genetic lengths of chromosomes, the rate per physical unit DNA was constant across chromosomes. Flycatcher recombination rate showed similar variation along chromosomes as chicken but lacked the large interior recombination deserts characteristic of zebra finch chromosomes.     

Construction of a comprehensive PCR-based marker linkage map and QTL mapping for fiber quality traits in upland cotton (Gossypium hirsutum L.)

To facilitate marker assisted selection, there is an urgent need to construct a saturated genetic map of upland cotton (Gossypium hirsutum L.). Four types of markers including SSR, SRAP, morphological marker, and intron targeted intron–exon splice junction (IT-ISJ) marker were used to construct a linkage map with 270 F_2:7 recombinant inbred lines derived from an upland cotton cross (T586 × Yumian 1). A total of 7,508 SSR, 740 IT-ISJ and 384 SRAP primer pairs/combinations were used to screen for polymorphism between the two mapping parents, and the average polymorphisms of three types of molecular markers represented 6.8, 6.6 and 7.0%, respectively. The polymorphic primer pairs/combinations and morphological markers were used to genotype 270 recombinant inbred lines, and a map including 604 loci (509 SSR, 58 IT-ISJ, 29 SRAP and 8 morphological loci) and 60 linkage groups was constructed. The map spanned 3,140.9 cM with an average interval of 5.2 cM between two markers, approximately accounting for 70.6% of the cotton genome. Fifty-four of 60 linkage groups were ordered into 26 chromosomes. Multiple QTL mapping was used to identify QTL for fiber quality traits in five environments, and thirteen QTL were detected. These QTL included four for fiber length (FL), two for fiber strength (FS), two for fiber fineness (FF), three for fiber length uniformity (FU), and two for fiber elongation (FE), respectively. Each QTL explained between 7.4 and 43.1% of phenotypic variance. Five out of thirteen QTL (FL1 and FU1 on chromosome 6, FL2, FU2 and FF1 on chromosome7) were detected in five environments, and they explained more than 20% of the phenotypic variance. Eleven QTL were distributed on A genome, while the other two on D genome.     

High‐precision genetic mapping of behavioral traits in the diversity outbred mouse population

Historically our ability to identify genetic variants underlying complex behavioral traits in mice has been limited by low mapping resolution of conventional mouse crosses. The newly developed Diversity Outbred (DO) population promises to deliver improved resolution that will circumvent costly fine‐mapping studies. The DO is derived from the same founder strains as the Collaborative Cross (CC), including three wild‐derived strains. Thus the DO provides more allelic diversity and greater potential for discovery compared to crosses involving standard mouse strains. We have characterized 283 male and female DO mice using open‐field, light–dark box, tail‐suspension and visual‐cliff avoidance tests to generate 38 behavioral measures. We identified several quantitative trait loci (QTL) for these traits with support intervals ranging from 1 to 3 Mb in size. These intervals contain relatively few genes (ranging from 5 to 96). For a majority of QTL, using the founder allelic effects together with whole genome sequence data, we could further narrow the positional candidates. Several QTL replicate previously published loci. Novel loci were also identified for anxiety‐ and activity‐related traits. Half of the QTLs are associated with wild‐derived alleles, confirming the value to behavioral genetics of added genetic diversity in the DO. In the presence of wild‐alleles we sometimes observe behaviors that are qualitatively different from the expected response. Our results demonstrate that high‐precision mapping of behavioral traits can be achieved with moderate numbers of DO animals, representing a significant advance in our ability to leverage the mouse as a tool for behavioral genetics .     

Genome‐wide association study of six quality traits reveals the association of the TaRPP13L1 gene with flour colour in Chinese bread wheat

Flour colour, kernel hardness, grain protein content and wet gluten content are important quality properties that determine end use in bread wheat. Here, a wheat 90K genotyping assay was used for a genome‐wide association study (GWAS) of the six quality‐related traits in Chinese wheat cultivars in eight environments over four years. A total of 846 significant single nucleotide polymorphisms (SNPs) were identified, explaining approximately 30% of the phenotypic variation on average, and 103 multienvironment‐significant SNPs were detected in more than four environments. Quantitative trait loci (QTL) mapping in the biparent population confirmed some important SNP loci. Moreover, it was determined that some important genes were associated with the six quality traits, including some known functional genes and annotated unknown functional genes. Of the annotated unknown functional genes, it was verified that TaRPP13L1 was associated with flour colour. Wheat cultivars or lines with TaRPP13L1‐B1a showed extremely significantly higher flour redness and lower yellowness than those with TaRPP13L1‐B1b in the Chinese wheat natural population and the doubled haploid (DH) population. Two tetraploid wheat lines with premature stop codons of the TaRPP13L1 gene mutagenized by ethyl methanesulfonate (EMS) showed extremely significantly higher flour redness and lower yellowness than wild type. Our data suggest that the TaRPP13L1 gene plays an important role in modulating wheat flour colour. This study provides useful information for further dissection of the genetic basis of flour colour and also provides valuable genes or genetic loci for marker‐assisted selection to improve the process of breeding quality wheat in China.     

Genome‐wide association study for 13 agronomic traits reveals distribution of superior alleles in bread wheat from the Yellow and Huai Valley of China

Bread wheat is a leading cereal crop worldwide. Limited amount of superior allele loci restricted the progress of molecular improvement in wheat breeding. Here, we revealed new allelic variation distribution for 13 yield‐related traits in series of genome‐wide association studies (GWAS) using the wheat 90K genotyping assay, characterized in 163 bread wheat cultivars. Agronomic traits were investigated in 14 environments at three locations over 3 years. After filtering SNP data sets, GWAS using 20 689 high‐quality SNPs associated 1769 significant loci that explained, on average, ~20% of the phenotypic variation, both detected already reported loci and new promising genomic regions. Of these, repetitive and pleiotropic SNPs on chromosomes 6AS, 6AL, 6BS, 5BL and 7AS were significantly linked to thousand kernel weight, for example BS00021705_51 on 6BS and wsnp_Ex_c32624_41252144 on 6AS, with phenotypic variation explained (PVE) of ~24%, consistently identified in 12 and 13 of the 14 environments, respectively. Kernel length‐related SNPs were mainly identified on chromosomes 7BS, 6AS, 5AL and 5BL. Plant height‐related SNPs on chromosomes 4DS, 6DL, 2DS and 1BL were, respectively, identified in more than 11 environments, with averaged PVE of ~55%. Four SNPs were confirmed to be important genetic loci in two RIL populations. Based on repetivity and PVE, a total of 41 SNP loci possibly played the key role in modulating yield‐related traits of the cultivars surveyed. Distribution of superior alleles at the 41 SNP loci indicated that superior alleles were getting popular with time and modern cultivars had integrated many superior alleles, especially for peduncle length‐ and plant height‐related superior alleles. However, there were still 19 SNP loci showing less than percentages of 50% in modern cultivars, suggesting they should be paid more attention to improve yield‐related traits of cultivars in the Yellow and Huai wheat region. This study could provide useful information for dissection of yield‐related traits and valuable genetic loci for marker‐assisted selection in Chinese wheat breeding programme.