Present status of the theory of relativistic plasma microwave electronics

Theoretical research on high-power microwave sources based on stimulated emission from relativistic election beams in plasma waveguides and resonators is reviewed. Both microwave amplifiers and oscillators are investigated. Two mechanisms for stimulated emission—resonant Cherenkov emission from a relativistic electron beam in a plasma and nonresonant Pierce emission arising from the onset of a high-frequency Pierce instability—are studied theoretically. The theory developed here is motivated by recent experiments carried out at the Institute of General Physics of the Russian Academy of Sciences and is aimed at creating high-power pulsed plasma microwave sources [both narrowband (Δω/ω<0.1) and broadband (or noisy, Δω/ω≈1)] based on high-current relativistic electron beams. Although the paper is devoted to theoretical problems, all analytic estimates and numerical calculations are made with real experiments in mind and theoretical results are compared with reliable experimental data. Special attention is paid to the opportunity to progress to short (millimeter) and long (decimeter) wavelength ranges. Some factors that influence the formation of the wave spectra excited by relativistic electron beams in plasma sources are discussed.     

Plasma relativistic microwave amplifier with smooth frequency tuning from 2.4 to 3.2 GHz

Earlier, it was shown that the plasma relativistic microwave amplifier can operate at two frequencies, 2 and 3.2 GHz. In the present work, it is shown that, by varying the plasma density from one microwave pulse to another, it is possible to amplify the input signals to a power of 50?C80 MW at any frequency in the range 2.4?C3.2 GHz.     

Normal Doppler effect in experiments on the interaction of relativistic electron beams with plasma: Plasma relativistic microwave amplifier

The Cherenkov interaction of a high-current relativistic electron beam with a spatially bounded plasma was studied experimentally. In the generation of electromagnetic radiation, an important role is played by the counterpropagating plasma wave produced due to the reflection from the end of the plasma column. It is shown that, at the resonant value of the magnetic field, the normal Doppler effect occurs and the amplitude of the counterpropagating wave decreases. This effect was used to design and create a plasma relativistic microwave amplifier in which 10% of the beam energy is converted into radiation. The radiation frequency is 9.1 GHz, and the radiation spectrum width (±0.17%) is determined by the microwave-pulse duration. The maximum radiation power is 100 MW, the gain factor being 32 dB.     

Tunable plasma relativistic microwave amplifier

A stable regime of the amplification of a slow plasma wave in a plasma waveguide during the injection of a high-current relativistic electron beam is obtained. For an input-signal frequency of 9.1 GHz, there exists a range of plasma densities in which the spectrum of the output microwave radiation lies in a 0.5-GHz-wide band. For a 40-kW input power at a frequency of 9.1 GHz, the maximum output power is 8 MW. It is shown experimentally for the first time that the beam-plasma amplifier can operate at frequencies of 9.1 GHz and 12.9 GHz. The range of plasma densities in which the regime of amplification is observed agrees with the results of calculations based on linear theory.     

Visualization of the microwave beam generated by a plasma relativistic microwave amplifier

A method based on the detection of emission of a dielectric screen with metal microinclusions in open air is applied to visualize the transverse structure of a high-power microwave beam. In contrast to other visualization techniques, the results obtained in this work provide qualitative information not only on the electric field strength, but also on the structure of electric field lines in the microwave beam cross section. The interpretation of the results obtained with this method is confirmed by numerical simulations of the structure of electric field lines in the microwave beam cross section by means of the CARAT code.     

Noise characteristics of a plasma relativistic microwave amplifier

Reasons for the occurrence of microwave noise at the output of a plasma relativistic amplifier have been analyzed. It is found that, in the absence of an input signal, the emission spectrum of the plasma relativistic microwave amplifier is similar to that of an electron beam in vacuum. It is concluded that microwave noise at the output of the amplifier appears as a result of amplification of the intrinsic noise of the electron beam. The emission characteristics of a relativistic electron beam formed in a magnetically insulated diode with an explosive emission cathode in vacuum have been studied experimentally for the first time. An important point is that, in this case, there is no virtual cathode in the drift space.     

Plasma electronics and plasma acceleration of charged particles

Preliminary results are summarized from studies on plasma electronics and plasma acceleration of charged particles, recent advances in this field are analyzed, and the challenging problems are outlined.     

Experimental study and numerical simulations of a plasma relativistic microwave amplifier

The dependences of the radiation parameters of a plasma relativistic microwave amplifier on the external factors have been studied both experimentally and numerically. The calculated dependences are found to agree qualitatively with the measured ones. In contrast to experimental studies, numerical simulations make it possible to examine physical processes occurring inside the plasma waveguide. Good agreement between the measured and calculated dependences of the radiation parameters on the external factors shows that information provided by numerical simulations of the processes occurring inside the plasma waveguide can be considered quite reliable. The electromagnetic field structure and electron beam dynamics inside the plasma waveguide have been investigated.     

Control over the radiation spectrum of a microwave plasma relativistic oscillator

General features of the operation of microwave oscillators based on the Cherenkov resonance interaction of a high-current relativistic electron beam with a preformed plasma are considered. Emphasis is placed on the presence of longitudinal modes of the plasma-beam resonator that make it possible to tune the radiation frequency. Methods by which the radiation frequency can be varied severalfold continuously or in discrete controlled steps and the width of the spectrum of simultaneously generated frequencies can be changed substantially are described. The results of numerical simulations are compared with available experimental data.     

Output power variations in a plasma relativistic microwave amplifier during a 500-ns relativistic electron beam current pulse

A relativistic plasma microwave amplifier with a gain of about 30 dB and an output power of about 60–100 MW in the frequency range from 2.4 to 3.2 GHz is studied experimentally. The total duration of the output microwave pulse is equal to the duration of the current pulse of the driving relativistic electron beam (500 ns); however, the maximum output power is observed only within 200 ns. It is shown that variations in the output microwave power during the current pulse of the annular relativistic electron beam are caused by variations in the beam radius and thickness. Analysis of the experimental data and results of numerical simulations show that the thickness of the electron beam is determined by the density of the cathode emission current.     

The use of a high-current electron beam in plasma relativistic microwave oscillators

Relativistic microwave electronics faces the problem of using high currents of relativistic electron beams; i.e., it is possible to use beams the current of which is lower than that of actually existing high-current accelerators. We show the possibility of increasing the power of radiation generated in a plasma relativistic microwave oscillator (PRMO) due to an increase in the absolute value of current. For the beam currents close to the value of limiting vacuum current, the efficiency of microwave generation decreases; therefore, we study PRMO schemes with a high value of limiting vacuum current, i.e., schemes with a small gap between a hollow relativistic electron beam and the waveguide wall. The results of the experiment and numerical simulation are discussed.     

Repetitively rated plasma relativistic microwave oscillator with a controllable frequency in every pulse

A repetitively rated microwave oscillator whose frequency can be varied electronically from pulse to pulse in a predetermined manner is created for the first time. The microwave oscillator has a power on the order of 10⁸ W and is based on the Cherenkov interaction of a high-current relativistic electron beam with a plasma preformed before each pulse. Electronic control over the plasma properties allows one to arbitrarily vary the microwave frequency from pulse to pulse at a pulse repetition rate of up to 50 Hz.     

Plasma corticosterone in hemorrhaged Japanese quail after microwave irradiation in ovo

1. Sexually immature male and female Japanese quail were divided within each sex into three treatment groups: hemorrhaged by jugular puncture; immobilized for 2 min, but not hemorrhaged (shams); and neither immobilized nor hemorrhaged (controls). 2. Hemorrhage resulted in increased plasma corticosterone levels in both sexes. Corticosterone levels in shams were higher than in controls. 3. In another experiment, Japanese quail eggs were irradiated during incubation with 2.45 GHz CW microwave radiation. Nonirradiated eggs were incubated under identical conditions without irradiation. After hatching, juvenile males and females were hemorrhaged. 4. After hemorrhage, irradiated males had higher plasma corticosterone levels than nonirradiated males. No effect of irradiation on females was found. 5. The results of these two experiments indicate that male quail respond to blood loss with increased adrenocortical activity and that this response is modified in male quail after irradiation with microwaves during embryogeny.     

Electron cyclotron resonance acceleration of electrons to relativistic energies by a microwave field in a mirror trap

Results are presented from experiments on the acceleration of electrons by a 2.45-GHz microwave field in an adiabatic mirror trap under electron cyclotron resonance conditions, the electric and wave vectors of the wave being orthogonal to the trap axis. At a microwave electric field of ≥10 V/cm and air pressures of 10^?6–10^?4 Torr (the experiments were also performed with helium and argon), a self-sustained discharge was initiated in which a fraction of plasma electrons were accelerated to energies of 0.3–0.5 MeV. After the onset of instability, the acceleration terminated; the plasma decayed; and the accelerated electrons escaped toward the chamber wall, causing the generation of X-ray emission. Estimates show that electrons can be accelerated to the above energies only in the regime of self-phased interaction with the microwave field, provided that the electrons with a relativistically increased mass penetrate into the region with a higher magnetic field. It is shown that the negative-mass instability also can contribute to electron acceleration. The dynamic friction of the fast electrons by neutral particles in the drift space between the resonance zones does not suppress electron acceleration, so the electrons pass into a runaway regime. Since the air molecules excited by relativistic runaway electrons radiate primarily in the red spectral region, this experiment can be considered as a model of high-altitude atmospheric discharges, known as “red sprites.”     

Toward molecular electronics

One-dimensional polyelectrolytes are proposed as molecular devices based on soliton propagation. The use of such “molecular wires” as delay lines or shift registers raises the problem of their electrical screening, because, when a large number of these wires are densely packed, cross-talking between them might occur. In order to overcome such a drawback, a detailed study of the polyelectrolyte behavior in an ionic solution has been developed, under equilibrium conditions. The results bring into evidence a condensation process, around each molecular wire, of the mobile ions in the solution. The consequent self-screening effect could be relevant in reducing cross-talking.     

DNA detection by integrable electronics

This paper presents a new electronic methodology to detect DNA hybridization for rapid identification of diseases, as well as food and environmental monitoring on a genetic base. The proposed solution exploits a new (electrical) capacitive measurement circuit, not requiring any prior labeling of the DNA (as it is often the case with the commonly employed optical detection). The sensitivity, the reliability, and the reproducibility of this device have been evaluated by experiments performed with a (non-integrated) prototype implementation, easily integrable in IC and/or micro-fabricated lab-on-a-chip.     

Boundary conditions for the electromagnetic field in a waveguide with a thin-walled annular plasma in the context of application to plasma microwave electronics

Effective boundary conditions for the electromagnetic field of the slow surface waves of a thinwalled annular plasma in a metal waveguide are derived and justified. With the boundary conditions obtained, there is no need to solve field equations in the plasma region of the waveguide, so that the dispersion properties of plasma waveguides can be investigated analytically for an arbitrary strength of the external magnetic field. Examples are given that show how to use the effective boundary conditions in order to describe surface waves with a normal and an anomalous dispersion. The boundary conditions are then employed to construct a theory of the radiative Cherenkov instabilities of a thin-walled annular electron beam in a waveguide with a thinwalled annular plasma. The single-particle and collective Cherenkov effects associated with low-and high-frequency surface waves in an arbitrary external magnetic field are studied analytically. The method of the effective boundary conditions is justified in the context of application to the problems of plasma relativistic microwave electronics.