Pre-labeling of diverse protein samples with a fixed amount of Cy5 for sodium dodecyl sulfate–polyacrylamide gel electrophoresis analysis

A pre-labeling protocol based on Cy5 N-hydroxysuccinimide (NHS) ester labeling of proteins has been developed for one-dimensional sodium dodecyl sulfate–polyacrylamide gel electrophoresis (SDS–PAGE) analysis. We show that a fixed amount of sulfonated Cy5 can be used in the labeling reaction to label proteins over a broad concentration range—more than three orders of magnitude. The optimal amount of Cy5 was found to be 50 to 250 pmol in 20 μl using a Tris–HCl labeling buffer at pH 8.7. Labeling protein samples with a fixed amount of dye in this range balances the requirements of sub-nanogram detection sensitivity and low dye-to-protein (D/P) ratios for SDS–PAGE. Simulations of the labeling reaction reproduced experimental observations of both labeling kinetics and D/P ratios. Two-dimensional electrophoresis was used to examine the labeling of proteins in a cell lysate using both sulfonated and non-sulfonated Cy5. For both types of Cy5, we observed efficient labeling across a broad range of molecular weights and isoelectric points.     

Analysis of oligonucleotide microarrays by 3' end labeling using fluorescent nucleotides and terminal transferase

A simple enzymatic labeling procedure is described to determine spot quality in oligonucleotide microarrays. By using fluorescently labeled dideoxynucleotides or ribonucleotides as substrate for terminal deoxynucleotidyl transferase (TdT), a single fluorophore can be covalently attached at the 3' end of each oligonucleotide probe molecule in the spot. Fluorescein-12-ddUTP CyTM3-ddUTP Cy5-UTP, and Cy3-UTP were compared as TdT substrates for 3' end labeling an array of 1273 hexamer probes. Cy5-UTP was found to show minimal bias toward probe base composition and is therefore well suited for quantitative analysis of microarray spots where the oligonucleotide probes are coupled via a 5' end linkage to the solid phase.     

Long wavelength fluorophores and cell-by-cell correction for autofluorescence significantly improves the accuracy of flow cytometric energy transfer measurements on a dual-laser benchtop flow cytometer

BACKGROUND: Flow cytometric fluorescence resonance energy transfer (FCET) is an efficient method to map associations between biomolecules because of its high sensitivity to changes in molecular distances in the range of 1-10 nm. However, the requirement for a dual-laser instrument and the need for a relatively high signal-to-noise system (i.e., high expression level of the molecules) pose limitations to a wide application of the method. METHODS: Antibodies conjugated to cyanines 3 and 5 (Cy3 and Cy5) were used to label membrane proteins on the cell surface. FCET measurements were made on a widely used benchtop dual-laser flow cytometer, the FACSCalibur, by using cell-by-cell analysis of energy transfer efficiency.ResultsTo increase the accuracy of FCET measurements, we applied a long wavelength donor-acceptor pair, Cy3 and Cy5, which beneficially affected the signal-to-noise ratio in comparison with the classic pair of fluorescein and rhodamine. A new algorithm for cell-by-cell correction of autofluorescence further improved the sensitivity of the technique; cell subpopulations with only slightly different FCET efficiencies could be identified. The new FCET technique was tested on various direct and indirect immunofluorescent labeling strategies. The highest FCET values could be measured when applying direct labeling on both (donor and acceptor) sides. Upon increasing the complexity of the labeling scheme by introducing secondary antibodies, we detected a decrease in the energy transfer efficiency. CONCLUSIONS: We developed a new FCET protocol by applying long wavelength excitation and detection of fluorescence and by refining autofluorescence correction. The increased accuracy of the new method makes cells with low receptor expression amenable to FCET investigation, and the new approach can be implemented easily on a commercially available dual-laser flow cytometer, such as a FACSCalibur.     

Direct and sensitive miRNA profiling from low-input total RNA

We have developed a sensitive, accurate, and multiplexed microRNA (miRNA) profiling assay that is based on a highly efficient labeling method and novel microarray probe design. The probes provide both sequence and size discrimination, yielding in most cases highly specific detection of closely related mature miRNAs. Using a simple, single-vial experimental protocol, 120 ng of total RNA is directly labeled using Cy3 or Cy5, without fractionation or amplification, to produce precise and accurate measurements that span a linear dynamic range from 0.2 amol to 2 fmol of input miRNA. The results can provide quantitative estimates of the miRNA content for the tissues studied. The assay is also suitable for use with formalin-fixed paraffin-embedded clinical samples. Our method allows rapid design and validation of probes for simultaneous quantitative measurements of all human miRNA sequences in the public databases and to new miRNA sequences as they are reported.     

两种标记方法对60mer寡核苷酸芯片背景信号影响的初步分析

研究两种不同的样本标记方法对人全基因组高密度60mer寡核苷酸芯片背景信号的影响。收集5对患病与健康人外周血单个核细胞,分别提取总RNA后,采用限制性显示技术（restriction display,RD）进行样本双色（Cy3/Cy5）荧光标记,与5张Agilent 60mer高密度（22K）Human 1B寡核苷酸芯片进行杂交。芯片全部杂交点分3组：基因探针组、阳性对照组和阴性对照组。阳性对照采用荧光标记寡核苷酸直接掺入法进行标记。对全部杂交信号点的Cy3和Cy5背景信号值,用SPSS软件进行数据转换、正态性检验、方差齐性检验、变异系数分析和重复数据的方差分析。数据分析结果显示,Cy3 标记的背景信号值均高于 Cy5标记的背景信号值。重复测量数据的方差分析表明,在Cy3 和Cy5标记中,两种不同标记方法间的背景信号值的差异极显著（PCy3＜0.01, PCy5＜0.01）,且RD标记点的背景信号平均值低于荧光标记寡核苷酸直接掺入标记法标记的阳性对照点。RD标记方法是一种有用的低背景信号的高密度长链寡核苷酸芯片样本标记方法。     

Design and application of an oligonucleotide microarray for the investigation of compost microbial communities

A microarray consisting of oligonucleotide probes targeting variable regions of the 16S rRNA gene was designed and tested for the investigation of microbial communities in compost. Probes were designed for microorganisms that have been previously reported in the composting process and for plant, animal and human pathogens. The oligonucleotide probes were between 17 and 25 bp in length and included mostly species-specific sequences. Validation of probe specificity and optimization of hybridization conditions were conducted using fluorescently labeled 16S rRNA gene PCR products of pure culture strains. A labeling method employing a Cy3 or Cy5-labeled forward primer together with a phosphate-conjugated reverse primer for the production of single stranded DNA after a digestion step was optimised and used to label target DNA. A combination of two different DNA extraction methods using both physical and chemical lysis was found to give the best DNA yields. Increased hybridization signal intensities were obtained for probes modified with a 12 mer T-spacer. The microarray was found to have a detection limit of 10(3) cells, although in compost spiking experiments, the detection limit was reduced to 10(5) cells. The application of the microarray to compost samples indicated the presence of Streptococcus, Acinetobacter lwoffii, and Clostridium tetani in various compost samples. The presence of A. lwoffii in those compost samples was confirmed by PCR using primers specific for the organism. The aim of this study was to develop a molecular tool that would allow screening for the presence or absence of different microorganisms within compost samples.