A rapid method for measuring intracellular pH using BCECF-AM

A rapid intracellular pH (pH(i)) measurement method based on initial rate of increase of fluorescence ratio of 2',7'-bis(2-carboxyethyl)-5,6-carboxyfluorescein upon dye addition to a cell suspension in growth medium is reported. A dye transport model that describes dye concentration and fluorescence values in intracellular and extracellular spaces provides the mathematical basis for the approach. Experimental results of ammonium chloride challenge response of the two suspension cells, Spodoptera frugiperda and Chinese hamster ovary (CHO) cells, successfully compared with results obtained using traditional perfusion method. Since the cell suspension does not require any preparation, measurement of pH(i) can be completed in about 1 min minimizing any potential errors due to dye leakage.     

A novel method for measuring intracellular pH and potassium concentration

The concentration of Na⁺and K⁺ and the pH in the cytoplasm of Lettré cells was measured by monitoring the net flux of H⁺, Na⁺, or K⁺ across the plasma membrane which had been rendered permeable to these ions by the action of Sendal virus. Ion flux was measured directly by analysis of cell composition, or indirectly by observing the change in membrane potential of cells treated with a specific ionophore. Cytoplasmic concentrations of cations were obtained by establishing the concentration of the cation in the medium at which addition of Sendai virus causes no change in cytoplasmic cation content. The value of Lettré-cell pH was confirmed by direct measurement employing 3tp nuclear magnetic resonance, and the values of Na⁺ and K⁺ concentration were confirmed by analysis of cell cation and water content. Lettré cells suspended at 32°C in Hepes-buffered saline at pH 7.3 maintain a cytosolic pH of 7.0 and contain 30 mM Na⁺ and 80 mM K⁺.     

Characteristics of fluoroprobes for measuring intracellular pH

We evaluated four different fluoroprobes to determine their capabilities and limitations in measuring intracellular pH by the fluorescent indicator technique. In vitro, carboxyfluorescein, dimethylcarboxyfluorescein, biscarboxyethyl carboxyfluorescein, and 4-methylumbelliferone (4MU) all showed comparably intense fluorescence and excellent pH sensitivity near their respective pKa values. Major differences were found between 4MU and the fluoresceins in terms of protein binding, concentration effects, bleach rates, and the retention time within cells. Both fluorescence and a fluorescence ratio at pH-sensitive/pH-insensitive excitation wavelengths increased with pH for all compounds, and the ratio completely corrected for large changes in the excitation light intensity. In contrast, the ratio showed large artifactual changes as dye concentration increased because of self-quenching effects and spectral shifts. Protein interactions likewise caused spectral shift and ratio aberrancies, but calcium, magnesium, and oxygen had no effect on the fluorescence ratios. We conclude that measurements of cell pH by fluorescence techniques are subject to artifacts induced by self-quenching and protein binding. Use of the fluorescence ratio technique does not necessarily correct for these artifacts, and in particular the ratio technique does not correct for changes in fluoroprobe concentration. Because the major artifacts cause the ratios for 4MU and for the fluoresceins to move in opposite directions, an experimental maneuver can be shown to cause a true change in pH if the fluorescence and ratios change in the same direction for these two classes of fluoroprobes.     

Dicarboxy-dichlorofluorescein: a new fluorescent probe for measuring acidic intracellular pH

Derivatives of fluorescein sensitive to pH are extensively utilized for the determination of intracellular pH (pHi). Available dyes have pKa values of approximately 7.0, and are not well suited for measuring acidic pHi. We examined the fluorescein derivative, 5 (and 6)-carboxy-2',7'-dichlorofluorescein (CDCF) for its potential in the microspectrofluorometric measurement of pHi during acidic conditions. CDCF showed intense fluorescence and pH sensitivity near its "effective" pKa value of 4.2, using a 495/440 nm dual excitation wave-length ratio method. Protein interactions caused fluorescence ratio deviations which were most pronounced at the extremes of pH, whereas calcium and magnesium concentrations had little effect on the fluorescent ratio intensity. Intracellular calibration performed using nigericin in the presence of high potassium eliminated the need to correct for protein interactions, and the ratio method minimized any variations due to dye concentration differences or instrument fluctuation. Intracellular retention of the dye was high, and 95% of the initial signal remained after 1 h. Fluorescence bleaching was 14.5% after 1 h of continuous excitation and cell survival was not affected by dye loading. We conclude that CDCF is an excellent intracellular pH indicator in the pH range of 4-5.     

Improved method for measuring intracellular Ca++ with fluo-3

The accuracy of flow cytometric measurement of intracellular calcium with fluo-3 is compromised by variation in basal fluorescence intensity due to heterogeneity in dye uptake or compartmentalization. We have loaded cells simultaneously with fluo-3 and SNARF-1. When SNARF-1 fluorescence is collected at approximately 600 nm, its intensity does not change upon cell activation. Furthermore, fluo-3 and SNARF-1 fluorescence signals exhibit a linear relationship. The ratio of fluo-3 to SNARF-1 eliminates a significant proportion of variation in fluorescence intensity caused by variation in fluo-3 uptake and thus can be used as a sensitive parameter for measuring changes in [Ca2+]i.     

Fluorescence emission spectroscopy of 1,4-dihydroxyphthalonitrile. A method for determining intracellular pH in cultured cells.

We have developed new methodology for measuring intracellular pH (pHi) in cultured cell monolayers and epithelia by analyzing the emission spectra of the trapped fluorescent pH probe, 1,4-dihydroxyphthalonitrile (1,4-DHPN). This compound is unique since both its acid and base forms possess different fluorescence emission characteristics that can be used to quantitate pHi. The fluorescence difference spectrum between an acid and alkaline solution of 1,4-DHPN has a maximum at 455 nm and a minimum at 512 nm. By determining the ratio of the intensity at these two wavelengths as a function of pH, a calibration curve was constructed. Since the two intensities are determined simultaneously, the measurement is independent of dye concentration, bleaching, and intensity fluctuation of the excitation source. Furthermore, analysis of the emission spectra permitted the detection of light scattering, binding effects, and chemical modification of the probe. A microspectrofluorometer was constructed to analyze low light level emission spectra from intracellular 1,4-DHPN. The instrument consists of a modified Leitz inverted microscope (E. Leitz, Inc., Rockleigh, NJ) with a Ploem illuminator adapted for broadband excitation and objective focusing capability. The emission spectra were collected by focusing the fluorescence from the cell onto the entrance slit of an imaging monochromator, which was scanned by a SIT camera interfaced with a computer. This permitted the acquisition of fluorescence emission spectra extending from 391-588 nm in approximately 33 ms. pHi measured in the cultured toad kidney epithelial cell line, A6, was 7.49 +/- 0.04 (n = 12) with an external pH of 7.6. A6 cells were found to regulate pHi in response to both acute acid and alkali loads and maintained pHi relatively constant over a wide range of external pH values. The technique described in this report overcomes several of the difficulties encountered with other fluorescent pH probes where excitation spectroscopy is required to monitor pH.     

An in vivo method for measuring turbulence in mechanical prosthesis leakage jets

This work introduces a method for the in vivo measurement and analysis of turbulence within the leakage of a mechanical heart valve. Several analysis techniques were applied to ultrasound measurements acquired within the atrium of a pig, and error associated with these techniques was analyzed. The technique chosen applies cyclic averaging to mean and maximum velocity measurements within small, normalized phase windows to calculate Reynolds normal stresses in the direction of the ultrasound beam. Maximum shear stresses are estimated from these normal stresses using an analytical technique. The stresses observed were smaller than those reported from previous in vitro simulations.     

Cell-cell contacts alter intracellular pH.

Intracellular pH, an important regulatory factor for many cellular activities, was shown to be modulated by cell adhesion to the solid substratum. In the present work we have shown that cell-cell contacts also affect intracellular pH. pH(i) depends on how many contacts the cell has established with the substratum and the neighboring cells. pH(i) is low in single cells, not contacting each other. It increased with the increase of cell density. pH(i) is again decreased in confluent (topoinhibited) monolayers. pH(i)-shifts triggered by cell-cell contacts seem to be mediated by Na+/H(+)-antiporter. Dependence of pH(i) on cell density could be simulated by different concentration of Arg-Gly-Asp--which is part of the site of extracellular matrix proteins involved in integrin binding. The dependence of pH(i) on cell-cell contacts is discussed in relation to the phenomena of topoinhibition.     

Rapid method for measuring ScFv thermal stability by yeast surface display

We have characterized a simplified method to determine the relative thermal stability of single-chain antibodies by following the irreversible denaturation of scFv fusions on the surface of yeast by flow cytometry. The method was highly reproducible and correlated well with other methods used to monitor thermal denaturation of the soluble proteins. We found a range of thermal stabilities for wild-type single-chain antibodies with half-maximum denaturation temperatures between 43 and 61 degrees C. The ability to quantitate thermal stability of antibodies or other proteins that are immobilized on the surface of yeast allows rapid comparisons of primary structural information with stability. Thermal denaturation could be a useful parameter to consider in the choice of scFv fragments for various applications.     

An optical multifrequency phase-modulation method using microbeads for measuring intracellular oxygen concentrations in plants

A technique has been developed to measure absolute intracellular oxygen concentrations in green plants. Oxygen-sensitive phosphorescent microbeads were injected into the cells and an optical multifrequency phase-modulation technique was used to discriminate the sensor signal from the strong autofluorescence of the plant tissue. The method was established using photosynthesis-competent cells of the giant algae Chara corallina L., and was validated by application to various cell types of other plant species.     

A nondestructive method for measuring electrical conductivity of intracellular matter of tissue in situ

Summary A nondestructive method has been developed for measuring electrical conductivity of intracellular matter. The method is based on easily measurable electric parameters of cells in suspension. Experiments were made using suspensions of erythrocytes in a physiological salt solution. Results confirmed suitability of the method for determining conductance of the cytoplasm and were in close agreement with those reported by other authors. The method allows the determination of intracellular conductivity in tissue as well.     

A new solid-state microelectrode for measuring intracellular chloride activities.

Solid-state microelectrodes from measuring intracellular Cl activity (alphaiCl) were made by sealing the tips of tapered glass capillaries (tip diameter 0.3 mum), coating them under vacuum with a 0.2-0.3 mum thick layer of spectrscopic grade silver, and sealing them (except for the terminal 2-5 mum of the tip) inside tapered glass shields. 106 microelectrodes had an average slope of 55.0+/- 0.6 m V (S,E,) per decade c hange in alphaCl. Tip resistance was (77.1+/- 3.1) x 10(9) omega(n=30). Electrode response was rapid (10-20 s), was unaffected by HCO3, H2PO4, HPO42 or protein, and remained essentially unchanged over a 24-h period. AlphaiCl in frog sartorius muscle fibers and epithelial cells of bullfrog small intestine was measured in vitro. In both tissues, alphaiCl significantly exceeded the value corresponding to equlibrium ditribution of Cl across the cell membrane.     

Comparison of DMO and flow cytometric methods for measuring intracellular pH and the effect of hyperthermia on the transmembrane pH gradient

Intracellular pH (pHi) was measured in both unheated and heated cells by the distribution of the weak acid, 5,5-dimethyl-2,4-oxazolidinedione-2-14C (14C-DMO), and by the fluorescence intensity ratio (I530/I630) of the pH sensitive fluorescent dye, 2',7'-bis(carboxyethyl)-5,6-carboxy-fluorescein (BCECF), analyzed by flow cytometry (FCM). BCECF-loaded Chinese hamster ovary (CHO) cells were analyzed by FCM after they had incubated in fresh medium at 37 degrees C for 90 min, during which time a decrease in fluorescence ratio stabilized. After stabilization, the pHi determined for CHO cells by the FCM method at pHe values of 6.0-8.1 agreed-within 0.1 pH units with that determined by the 14C-DMO method. There is a pH gradient across the plasma membrane that is not affected by heat. In CHO cells, the gradient, determined by DMO and FCM, is less or greater than pHe by 0.30 and 0.15 pH units at pHe 7.4 and 6.3, respectively, and in NG108-15 cells, the gradient determined by DMO increases to 0.50 pH units at pHe 6.3. Both cells maintained their pH gradients for at least 4 h after heating, although 99.9% of the cells were reproductively dead (survival of 10(-3)) after heating at 45.5 degrees C either at the normal pHe of 7.4 or at a low pHe of 6.4-6.7.     

Rapid fluorescence assessment of intracellular pH as a viability indicator of Clavibacter michiganensis subsp. michiganensis

The viability of Clavibacter michiganensis subsp. michiganensis (Cmm) was determined by measuring the intracellular pH (pHin) as a viability parameter. This was based on the observation that growth of Cmm was inhibited at pH 5.5 and below. Therefore, viable cells should maintain their pHin above this pH value. The pHin of Cmm was determined using the fluorescent probe 5(and 6-)-carboxyfluorescein succinimidyl ester (cFSE). The pHin of Cmm cells exposed to acid treatments was determined using fluorescence spectrofluorometry, and for cells exposed to elevated temperatures, the pHin was determined using fluorescence spectrofluorometry and flow cytometry (FCM). A good correlation was found between the presence of a pH gradient and the number of colony-forming units (cfu) observed in plate counts. However, with the spectrofluorometry technique, the analysis is based on the whole cell population and the detection sensitivity of this technique is rather low, i.e., cell numbers of at least 107 cfu ml-1 are needed for the analysis. Using FCM, heat-treated and non-treated Cmm cells could be distinguished based on the absence and presence of a pH gradient, respectively. The major advantage of FCM is its high sensitivity, allowing analysis of microbial populations even at low numbers, i.e., 102-103 cfu ml-1.