Trajectory of aerosol droplets from a sprayed bacterial suspension.

Simulated droplet trajectories of a polydispersed microbial aerosol in a laminar air flow regimen were compared with observed dispersal patterns of aerosolized Bacillus subtilis subsp. niger spores in quasilaminar airflow. Simulated dispersal patterns could be explained in terms of initial droplet sizes and whether the droplets evaporated to residual aeroplanktonic size before settling to the ground. For droplets that evaporated prior to settling out, a vertical downwind size fractionation is predicted in which the microbial residue of the smallest droplets settles the least, and is found in the airstream at about sprayer height, and progressively larger droplet residues settle to progressively lower heights. Observations of spore particle size distributions downwind from a spray source support the simulation. Droplet and particle size distributions near the source had three size fractions: one containing large, presumably nonevaporated droplets of greater than or equal to 7 microns in diameter, and two smaller fractions, with diameters of 2 to 3 microns (probably the residue of droplets containing more than one spore) and 1 to 2 microns (probably the residue from single-spore droplets). As predicted by the simulation, the aerosol settled and progressed downwind, with the number of small droplets and particles increasing in proportion to the height and distance downwind.     

Settling of fixed erythrocyte suspension droplets

The fractionation of micron-size particles according to physical properties of size, density and surface characteristics by centrifugation and electrophoresis is hindered when the particles behave collectively rather than individually. The formation and sedimentation of droplets containing particles is an extreme example of collective behavior and a major problem for these separation methods when large quantities of particles need to be fractionated. In this paper, experiments that measured droplet sizes and settling rates for a variety of particles and droplets are described. Expressions are developed relating the particle concentration in a drop to measurable quantities of the fluids and particles. The number of particles in each droplet was then estimated along with the effective droplet density and certain trends are noted. Since a major application of this work is the purification of biological cells in the range of 10 microns, for which monodisperse inert particles are not available, red blood cells from different animals fixed in glutaraldehyde provided model particle groups with the necessary size range, visibility and stability for these fluid dynamical studies.     

Temperature changes of extracellular media state on a bacterial suspension

Within temperature intervals 30-40 degrees C for bacterial suspension of E. coli and 24-34 degrees C for B. flavum the extracellular medium exists in a specific state. Water in the extracellular medium is stabilized by increased hydrophobicity of extracellular protein molecules surface due to proteins conformational change. The total amount of UV-absorbing metabolites is decreased as a result of activation of microorganisms transport systems. The temperature intervals of these processes are different for both types of the microorganisms and coincide with their temperature optima of vital activity.     

Structure of an Escherichia coli bacterial suspension]

The structure of bacterial suspensions of Escherichia coli M-17 at the counting concentrations of the cells 10(7), 10(8), 10(9) i/ml and in the temperature range of (18-50) degrees C has been investigated by means of orientational conductometric, electron microscopic and UV-spectroscopic methods. On the basis of experimental relationships of the anisotropy of suspensions electric conductivity upon the intensity of a sinusoidal electric field and relaxation of anisotropy after switching off the field the function of the distribution of bacteria with respect to their sizes was evaluated at different temperatures and concentrations. The conductometric function of bacteria distribution is in a good agreement with the analogous function obtained with the help of the electron microscope. In accordance with the functions the suspension of E. coli contained three kinds of cells: high electronic density, low electronic density bacteria and bacteria aggregates. Relative amounts of every kind of bacteria depended on temperature and concentration of cells. The minimum of bacteria aggregates and maximum of low electronic density cells were obtained in the temperature range of (32-42) degrees C. This fact could be explained by the activation of the transport membrane systems in this temperature range. This hypothesis was confirmed by the UV-spectroscopic method.     

测定菌体浓度的简便方法

为了简便地测定测定JIS L 1902标准所规定的菌液浓度,以单位体积菌落数与吸光度(ABS值)的相关性,制成标准曲线,利用标准曲线快速准确地判断菌液浓度。     

One explanation for the variability of the bacterial suspension test

Disinfection kinetic studies of sodium dodecyl sulphate, benzalkonium chloride and sodium hypochlorite against Staphylococcus aureus revealed that when a higher inoculum level of Staph. aureus than normal was used (approximately 1 log higher), the efficacy of disinfection was severely attenuated. Kinetic analysis using the Hom model for experiments carried out on tests using 3 x 108 organisms ml-1 were unable to account for the large increase in disinfection power observed when smaller inoculum levels were used. Since the inoculum was the same in every way except for the numbers used, the large variations in the log reduction/time curves could not be explained by a variation in the resistance of the population to the biocide, as identical log reduction-time curves should have resulted. The level of disinfection achieved for a given concentration of biocide was found to be approximately linearly related to the cell number ml-1 of test solution and not to the log number. The variation observed is believed to occur due to intrinsic self-quenching of the biocide by the microbes during the course of the disinfection test. As the level of free biocide decreases, the rate of reaction decreases, giving the tails of the log reduction/time curves. Such intrinsic self-quenching could explain the large variations known to occur in the legally required disinfection suspension tests.     

Measurement of the change in aerosol size distribution with bacterial growth in a pilot scale fermentor

A number of industrial processes require the addition of materials to the fermentation broth that are hazardous to health and environment. Agitation of broths inoculated with microorganisms can potentially release aerosols large enough to carry the microorganisms. The influence of agitation, air flow, and bacterial growth on aerosol size distribution, air flow, and bacterial growth on aerosol size distribution was investigated in an industrial pilot scale fermentor. A decrease in particle concentration was observed with increase in bacterial growth; this change was more pronounced in the size range above 2 mum. The aerosol size distribution was found to be practically independent of air flow rate and agitation rate for sizes less than 2 mum. However, for particles largar than 2 mum, the concentration was found to increase with an increase in air flow rate and agitation rate.     

Rubber-degrading enzyme from a bacterial culture

Rubber-degrading activity was found in the extracellular culture medium of Xanthomonas sp. strain 35Y which was grown on natural rubber latex. Natural rubber in the latex state was degraded by the crude enzyme, and two fractions were separately observed by gel permeation chromatography of the reaction products. One fraction was of higher molecular weight (HMW) with a very wide MW distribution from 10 to 10, and the other fraction was of lower molecular weight (LMW) with a MW of a few hundred. H-nuclear magnetic resonance spectra of the partially purified fractions were those expected of cis-1,4-polyisoprene mixtures with the structure OHC-CH(2)-(-CH(2)-C(-CH(3)) = CH-CH(2)-)(n)-CH(2)-C(=O)-CH(3), with average values of n of about 113 and 2 for HMW and LMW fractions, respectively. The LMW fraction consisted mostly of one component in gas-liquid chromatography as well as in gel permeation chromatography, and the main component was identified as 12-oxo-4,8-dimethyl trideca-4,8-diene-1-al (acetonyl diprenyl acetoaldehyde, A(l)P(2)A(t)) by C-nuclear magnetic resonance and gas chromatography-mass spectra. Not only the latices of natural and synthetic isoprene rubber, but also some kinds of low-MW polyisoprene compounds of cis-1,4 type, were degraded by the crude enzyme. The rubber-degrading reaction was found to be at least partly oxygenase catalyzed from the incorporation of O into A(l)P(2)A(t) under an O(2) atmosphere.     

Callus formation from protoplasts of a sugarbeet cell suspension culture

Protoplasts of sugarbeet (Beta vulgaris L.) were isolated from cell suspension cultures and cultured in modified PGo medium. Conditions required for the efficient division of the protoplasts were investigated.The optimal combination of phytohormones was found to be 1 mg/l NAA, 0.2 mg/l 2,4-D, 0.5 mg/l zeatin. Protoplast division was also considerably stimulated by the addition of 250 mg/l casein hydrolysate, 200 mg/l yeast extract, and 20% v/v conditioned culture medium to the protoplast culture medium. The highest division rate (up to 35% of the protoplasts) was achieved at a density of 4×10⁴- 1×10⁵ protoplasts/ml. From the colonies callus and suspension cultures were readily obtained.Abbreviations BAP 6-Benzylaminopurine - 2,4-D 2,4-dichlorophenoxyacetic acid - IAA Indole-3-acetic acid - Kin 6-Furfurylaminopurine (kinetin) - NAA -Naphtalenacetic acid - Zea Zeatin