Cycle characteristics in a temporary immersion bioreactor affect regeneration,morphology, water and mineral status of coffee (<Emphasis Type="Italic">Coffea arabica</Emphasis>) somatic embryos

Mass regeneration of Coffea arabica L. somatic embryos using a temporary immersion bioreactor was improved by optimizing the immersion cycles, i.e. both the duration and the frequency of immersions. It was demonstrated that increasing the frequency of short immersions (1 min immersions every 24, 12 and 4 h) stimulated embryo production (480, 2,094 and 3,081 embryos/1-l bioreactor, respectively) and improved quality (60, 79 and 85 of torpedo shaped embryos, respectively). On the other hand, an increase in the immersion duration (1, 5 and 15 min) inhibited embryo regeneration (from 2,094 to 428 embryos per 1-l bioreactor) and negatively affected their morphological quality (from 79 to 49 torpedo-shaped embryos) and the conversion of embryos into plants (from 70 to 33). A 15 min immersion duration applied every 4 h produced hyperhydric symptoms in 90 of the embryos. Hyperhydric embryos were characterized by higher fresh weight and water content, more negative values for water potential and higher K⁺ content when compared to normal torpedo-shaped embryos. Micrographs showed structural problems in the globular stage, such as the existence of an irregular epidermis and an absence of reserves. Whatever the immersion cycle used, the somatic embryos exhibited water and mineral characteristics very different from those of their zygotic counterparts. The use of 1 min immersions every 4 h led to the production of the largest quantities of torpedo-shaped embryos without hyperhydricity that succeeded in regenerating plants (75 conversion).     

Elicitation with methyl jasmonate combined with cultivation in the Plantform™ temporary immersion bioreactor highly increases the accumulation of selected centellosides and phenolics in Centella asiatica (L.) Urban shoot culture

Centella asiatica (L.) Urban is an important pharmacopoeial plant used not only in medicine but also in cosmetology. C. asiatica agitated shoot cultures were established to study the influence of ethephon, methyl jasmonate, L ‐phenylalanine (Eth 50 µM, MeJa 50 µM, L‐Phe 2.4 g/L of medium, respectively; seven variants of the supplementation) on the accumulation of secondary metabolites: the main centellosides (asiaticoside and madecassoside) and selected phenolic acids, and flavonoids in the biomass. Microshoots were harvested two and six days after the supplementation. Secondary metabolites were analyzed in methanolic extracts by UPLC‐MS/MS (centellosides) and by HPLC‐DAD (phenolics). In comparison with the reference cultures, the concentrations of individual secondary metabolites increased as follows: centellosides up to 5.6‐fold (asiaticoside), phenolic acids up to 122‐fold (p‐coumaric acid) and flavonoids up to 22.4‐fold (kaempherol). The highest production increase of individual compounds was observed for different variants of supplementation. Variant C (50 µM MeJa), the most optimal for centellosides and flavonoid accumulation, was selected for the experiment with bioreactors. Bioreactor Plantform?, compared to RITA^® system and agitated cultures, appeared to be the most advantageous for secondary metabolites production in C. asiatica shoot cultures. The phenolic acid, flavonoid, centelloside, and total secondary metabolite productivity in Plantform? system is 1.8‐fold, 1.7‐fold, 2.8‐fold, 2.1‐fold, respectively, higher than in MeJa elicitated agitated cultures, and 4.3‐fold, 7.3‐fold, 12.2‐fold, 7.2‐fold, respectively, higher than in control agitated cultures.     

A plant cell bioreactor with medium-perfusion for control of somatic embryogenesis in liquid cell suspensions

The Braun Biostat BF2 bioreactor system employs a novel aeration and agitation system, designed to enhance gaseous exchange and reduce shear stresses on submerged cell suspension cultures. The Biostat BF2 bioreactor employs a central pivoting spindle, around which the aeration tubing is wound forming a large paddle-type structure suspended from the top-plate and swung in a circle by a solid-state magnetic stirrer.The aeration tubing is a polypropylene capillary membrane, which has a unique microporous structure and is ideal for aeration, permitting two-way, bubble-free, gaseous exchange of the medium. This tubing can be rendered porous and can be used in the perfusion of aqueous solutions, enabling cell-free media exchange to be conducted. Thin-walled silicone rubber tubing, although gas permeable to a degree, cannot be made porous to aqueous solutions.The bioreactor was inoculated with a suspension culture of Sitka spruce (Picea sitchensis [Bong.] Carr.) known to be embryogenic and capable of maturing to plantlets on solidified medium. The perfusion capability of the bioreactor was employed to replace the inital proliferation medium with maturation medium in order to induce the development of the somatic embryos in submerged cell culture. The size ratio of the somatic embryo heads was monitored over 7 weeks. This cell line was found to mirror just the initial elongation, previously observed in shake-flask culture.Abbreviations BAP 6-benzylaminopurine - 2,4-D 2,4-dichlorophenoxyacetic acid - SSPM Selby Sitka proliferation medium - SSMM Selby Sitka maturation medium The following was presented at the NERC TBLG '95 Meeting as the Bioreactor Workshop     

Polymer characterization and optimization of conditions for the enhanced bioproduction of benzaldehyde by Pichia pastoris in a two‐ ;phase partitioning bioreactor

Benzaldehyde, with its apricot and almond‐like aroma, is the second most abundantly used molecule in the flavor industry, and is most commonly produced via chemical routes, such as by the oxidation of toluene. Biologically produced benzaldehyde, whether by extraction of plant material or via microbial biotransformation, commands a substantial price advantage, and greater consumer acceptance. Methylotrophic yeast, such as Pichia pastoris, contain the enzyme alcohol oxidase (AOX), which, in the presence of alcohols other than methanol, are able to yield aldehydes as dead‐end products, for example, benzaldehyde from benzyl alcohol. In this work, we have determined that benzaldehyde, and not benzyl alcohol, is inhibitory to the transformation reaction by P. pastoris, prompting the development of a selection strategy for identifying sequestering polymers for use in a partitioning bioreactor that was based on the ratio of partition coefficients (PCs) for the two target molecules. Additionally, we have now confirmed for the first time, that the mechanism of solute uptake by amorphous polymers is via absorption, not adsorption. Finally, we have adopted a common strategy used for the production of heterologous proteins by P. pastoris, namely the use of a mixed methanol/glycerol feed for inducing the required AOX enzyme, while reducing the time required for high density biomass generation. All of these components were combined in a final experiment in which 10% of the polymer Kraton D1102K, whose PC ratio of benzaldehyde to benzyl alcohol was 14.9, was used to detoxify the biotransformation in a 5 L partitioning bioreactor, resulting in a 3.4‐fold increase in benzaldehyde produced (14.4 g vs. 4.2 g) relative to single phase operation, at more than double the volumetric productivity (97 mg L^?1 h^?1 vs. 41 mg L^?1 h^?1). Biotechnol. Bioeng. 2013; 110: 1098–1105. © 2012 Wiley Periodicals, Inc.     

A new bio-formulation containing plant growth promoting rhizobacterial mixture for the management of sheath blight and enhanced grain yield in rice

Three plant growth promoting rhizobacterial (PGPR) strains, PF1,FP7 and PB2, were tested alone and in combinations for suppression ofrice sheath blight disease and promotion of plant growth underglasshouse and field conditions. The mixture of PGPR strainssignificantly reduced the sheath blight incidence when applied as eitherbacterial suspension through seed, root, foliar and soil application inglasshouse conditions, or as talc-based formulation under fieldconditions, compared to the respective individual strains. The averagemean of disease reduction was 29.2% for single strains and45.1% for mixtures. In addition to disease suppression, treatmentwith mixture of PGPR strains promoted plant growth in terms of increasedplant height and number of tillers, and ultimately grain yield. Theaverage increases in yield for single strains were 17.7%, and25.9% in case of mixture. Mixture of three PGPR strains reduceddisease and promoted growth to a level equivalent to two strainmixtures. Though seed treatment of either single strain or strainmixtures alone could reduce the disease, subsequent application to root,leaves or soil further reduced the disease and enhanced the plantgrowth. The mixture consisting of PF1 plus FP7 was the most effective inreducing the disease and in promoting plant growth and grainyield.     

Biological control potential of plant growth‐promoting rhizobacteria suppression of Meloidogyne incognita on cotton and Heterodera glycines on soybean: A review

Over the past decade, we have seen an increasing market for biopesticides and an increase in number of microbial control studies directed towards plant‐parasitic nematodes. This literature survey provides an overview of research on biological control of two economically important plant‐parasitic nematodes, Meloidogyne incognita (Kofoid & White) Chitwood (southern root‐knot nematode) and Heterodera glycines Ichinohe (soybean cyst nematode) using spore‐forming plant growth‐promoting rhizobacteria (PGPR). In this review, the current biological control strategies for the management of those cotton and soybean nematodes, the mechanism of using BacillusPGPR for biological control of plant‐parasitic nematode including induced systemic resistance and antagonism and the future of biological control agents on management of plant‐parasitic nematodes are covered.     

Hollow fiber-based liquid phase microextraction with factorial design optimization and gas chromatography–tandem mass spectrometry for determination of cannabinoids in human hair

A new method, based on hollow fiber liquid-phase microextraction (HF-LPME) and gas chromatography–tandem mass spectrometry (GC–MSMS), was developed for determination of Δ⁹-tetrahydrocannabinol (THC), cannabidiol (CBD) and cannabinol (CBN) in samples of human hair. Since hair is a solid matrix, the samples were subjected to alkaline digestion using NaOH. The aqueous solutions obtained were extracted using a 6 cm polypropylene fiber (600 μm i.d., 200 μm wall thickness, 0.2 μm pore size) for each extraction. A 2⁵⁻¹ fractional factorial design for screening, and a central composite design for optimization of significant variables, was applied during development of the extraction method. The variables evaluated were the type of extraction solvent, pH, stirring speed, extraction time, and acceptor phase volume. The optimized conditions for the proposed extraction procedure were 10 mg of hair sample; 20 μL of butyl acetate; aqueous (pH 14) donor phase containing 6.8% NaCl; 600 rpm stirring speed; 20 min extraction time. A linear response was obtained in the ranges 1–500 pg mg⁻¹ (CBD and CBN) and 20–500 pg mg⁻¹ (THC), with regression coefficients >0.99. Precision, determined as the relative standard deviation, was 3.3–8.9% (intra-day) and 4.4–13.7% (inter-day). Absolute recoveries varied in the ranges 4.4–4.8% (CBD), 7.6–8.9% (THC) and 7.7–8.2% (CBN). Limits of detection (LOD, S/N = 3) and quantification (LOQ, S/N = 10) were 0.5–15 pg mg⁻¹ and 1–20 pg mg⁻¹, respectively. The method was successfully used to determine CBD, THC and CBN in hair samples from patients in a drug dependency rehabilitation center. Concentrations varied in the ranges 1–18 pg mg⁻¹ (CBD), 20–232 pg mg⁻¹ (THC) and 9–107 pg mg⁻¹ (CBN), confirming the suitability of the method for monitoring studies.