Plasmid and chromosomally encoded luminescence marker systems for detection of Pseudomonas fluorescens in soil

Luminescent strains of Pseudomonas fluorescens 10586 were constructed in which luciferase production was constitutive by introduction of Vibrio fischeri luxABE genes on the chromosome and on a multicopy plasmid. Light production in liquid batch culture was directly proportional to biomass concentration during exponential growth and enabled detection by luminometry of 1.7 × 10³ and 8.9 × 10⁴ cells/ml for the plasmid and chromosomally marked strains, respectively. Luminescent colonies of both strains were detectable by eye, enabling viable cell enumeration on solid media against a background of non-luminescent strains. Following inoculation into sterile and non-sterile soil lower levels of detection were increased but detection of 8.1–59 × 10³and 2.2–30 × 10³ cells per g of soil was possible for plasmid and chromosomally marked strains. Maximum specific growth rate in liquid culture was unaffected by introduction of lux marker genes on the chromosome, but was reduced in the plasmid marked strain. The chromosomally encoded marker was stable in both liquid culture and in soil, but the plasmid was unstable during continuous subculturing in liquid medium and during growth in soil. The chromosomally encoded luminescence-marker system therefore provides a convenient, non-extractive technique for quantification of genetically modified soil microbial inocula.     

Luminometric measurement of population activity of genetically modified Pseudomonas fluorescens in the soil

Genetically modified cells of Pseudomonas fluorescens, chromosomally marked with genes for bioluminescence, were inoculated into sterile soil microcosms. During incubation for 90 days, viable cell concentration did not change significantly but light output, measured by luminometry, decreased, indicating reduced metabolic activity due to lack of substrates. Amendment with nutrients resulted in parallel increases in both luminescence and dehydrogenase activity. Luminometry therefore enables rapid monitoring of the activity of populations of luminescence-marked microbial inocula in the soil, with greater sensitivity and selectivity than traditional techniques.     

革兰氏阴性细菌外膜主要成分的跨膜转运机制研究进展

革兰氏阴性细菌的外膜由脂多糖、磷脂、外膜蛋白和脂蛋白等成分组成,是细菌抵御外界有害物质的首要物理屏障,与细菌致病性和耐药性密切相关.外膜各组分依赖特定的系统进行跨膜转运,包括脂多糖转运系统(lipopolysaccharide transport, Lpt)、脂质不对称维持系统(maintenance of lipid asymmetry, Mla)、β-桶状装配机器(β-barrel assembly machinery,Bam)以及脂蛋白定位系统(localization of lipoprotein,Lol).这些系统能够保证细菌外膜的完整与稳定,被视为维持细菌生命活动的"命门".因此,本文系统地综述革兰氏阴性细菌外膜主要成分的跨膜转运系统结构与功能,并对其未来研究方向进行展望,为新型靶向抗菌类药物研发提供新的思路.     

向日葵茎芯多糖的提取工艺优化及其体外抗肿瘤活性研究

研究了向日葵茎芯中主要活性物质多糖的提取工艺,并对此工艺进行了优化,选取的提取方法为水提醇沉法,以多糖含量作为指标,采用单因素试验研究了提取次数、原料颗粒的大小（目数）、料液比、提取时间、提取温度对向日葵茎芯多糖含量的影响。用苯酚-硫酸法测定提取液中多糖的含量,得出向日葵茎芯中多糖的最佳提取工艺条件为：提取次数2次,原料颗粒的大小（目数）60~80目,料液比（g·mL^-1）1：50,提取时间3.0 h,提取温度90℃,在最优提取条件下,多糖的提取得率为6.56%,多糖的含量为266.03 mg·g^-1。本文也对多糖的体外抗肿瘤活性进行了研究,结果表明向日葵茎芯多糖的体外抗肿瘤活性较弱。这些条件的确定为向日葵茎芯的深入研究奠定了基础。     

应用活细胞RNA检测纳米技术检测乳腺上皮细胞MCF-10A及乳腺癌细胞MCF-7中miR-142-3p的表达

传统的核酸检测技术如放射性核素、荧光、化学修饰的探针以及核酸扩增等技术无法检测活细胞中核酸的表达量。而活细胞RNA纳米检测技术和传统的检测技术相比,利用纳米金颗粒为探针能对活细胞进行检测,实验步骤更为简单,可以在自然的、无扩增的条件下观察RNA,这可真实地反应基因表达与表型之间的关系。miRNA是一类非编码RNA,其长度为20～24个碱基,在生命活动中起重要的作用。本文应用活细胞RNA检测纳米技术结合荧光定量PCR分别检测正常的乳腺上皮细胞系及乳腺上皮癌细胞系中内源性miR-142-3p的表达,发现乳腺癌细胞系内源性miR-142-3p的表达显著高于正常乳腺上皮细胞系中miR-142-3p的表达,结果提示miR-142-3p可能在乳腺癌细胞发生发展中起到调控作用。     

Evidence for the transmission of information through electric potentials in injured avocado trees

Electrical excitability and signaling, frequently associated with rapid responses to environmental stimuli, have been documented in both animals and higher plants. The presence of electrical potentials (EPs), such as action potentials (APs) and variation potentials (VPs), in plant cells suggests that plants make use of ion channels to transmit information over long distances. The reason why plants have developed pathways for electrical signal transmission is most probably the necessity to respond rapidly, for example, to environmental stress factors.We examined the nature and specific characteristics of the electrical response to wounding in the woody plant Persea americana (avocado). Under field conditions, wounds can be the result of insect activity, strong winds or handling injury during fruit harvest. Evidence for extracellular EP signaling in avocado trees after mechanical injury was expressed in the form of variation potentials. For tipping and pruning, signal velocities of 8.7 and 20.9 cm/s, respectively, were calculated, based on data measured with Ag/AgCl microelectrodes inserted at different positions of the trunk. EP signal intensity decreased with increasing distance between the tipping and pruning point and the electrode. Recovery time to pre-tipping or pre-pruning EP values was also affected by the distance and signal intensity from the tipping or pruning point to the specific electrode position. Real time detection of remote EP signaling can provide an efficient tool for the early detection of insect attacks, strong wind damage or handling injury during fruit harvest.Our results indicate that electrical signaling in avocado, resulting from microenvironment modifications, can be quantitatively related to the intensity and duration of the stimuli, as well as to the distance between the stimuli site and the location of EP detection. These results may be indicative of the existence of a specific kind of proto-nervous system in plants.     

Titration of the binding sites for the oligomycin-sensitivity conferring protein in beef heart submitochondrial particles

The binding parameters of the oligomycin-sensitivity conferring protein (OSCP) in inside-out particles from beef heart mitochondria have been tested by means of two assays, the oligomycin-sensitive ATP-Pi exchange, and the oligomycin-sensitive ATP hydrolysis. The total number of OSCP binding sites in A particles was equal to 220 pmol/mg particle protein. Each mole of ATPase active site was able to bind 1.1 +/- 0.5 mol OSCP with Kd 1.7 nM.     

Enhancement of YD spin relaxation by the CaMn4 cluster in photosystem II detected at room temperature: A new probe for the S-cycle

The long-lived, light-induced radical Y_D^• of the Tyr161 residue in the D2 protein of Photosystem II (PSII) is known to magnetically interact with the CaMn₄ cluster, situated ∼ 30 Å away. In this study we report a transient step-change increase in Y_D^• EPR intensity upon the application of a single laser flash to S₁ state-synchronised PSII-enriched membranes from spinach. This transient effect was observed at room temperature and high applied microwave power (100 mW) in samples containing PpBQ, as well as those containing DCMU. The subsequent decay lifetimes were found to differ depending on the additive used. We propose that this flash-induced signal increase was caused by enhanced spin relaxation of Y_D^• by the OEC in the S₂ state, as a consequence of the single laser flash turnover. The post-flash decay reflected S₂ → S₁ back-turnover, as confirmed by their correlations with independent measurements of S₂ multiline EPR signal and flash-induced variable fluorescence decay kinetics under corresponding experimental conditions. This flash-induced effect opens up the possibility to study the kinetic behaviour of S-state transitions at room temperature using Y_D^• as a probe.     

Recombinase-mediated cassette exchange (RMCE) — A rapidly-expanding toolbox for targeted genomic modifications

Starting in 1991, the advance of Tyr-recombinases Flp and Cre enabled superior strategies for the predictable insertion of transgenes into compatible target sites of mammalian cells. Early approaches suffered from the reversibility of integration routes and the fact that co-introduction of prokaryotic vector parts triggered uncontrolled heterochromatization. Shortcomings of this kind were overcome when Flp-Recombinase Mediated Cassette Exchange entered the field in 1994. RMCE enables enhanced tag-and-exchange strategies by precisely replacing a genomic target cassette by a compatible donor construct. After “gene swapping” the donor cassette is safely locked in, but can nevertheless be re-mobilized in case other compatible donor cassettes are provided (“serial RMCE”). These features considerably expand the options for systematic, stepwise genome modifications. The first decade was dominated by the systematic generation of cell lines for biotechnological purposes. Based on the reproducible expression capacity of the resulting strains, a comprehensive toolbox emerged to serve a multitude of purposes, which constitute the first part of this review. The concept per se did not, however, provide access to high-producer strains able to outcompete industrial multiple-copy cell lines. This fact gave rise to systematic improvements, among these certain accumulative site-specific integration pathways. The exceptional value of RMCE emerged after its entry into the stem cell field, where it started to contribute to the generation of induced pluripotent stem (iPS-) cells and their subsequent differentiation yielding a variety of cell types for diagnostic and therapeutic purposes. This topic firmly relies on the strategies developed in the first decade and can be seen as the major ambition of the present article. In this context an unanticipated, potent property of serial Flp-RMCE setups concerns the potential to re-open loci that have served to establish the iPS status before the site underwent the obligatory silencing process. Other relevant options relate to the introduction of composite Flp-recognition target sites (“heterospecific FRT-doublets”), into the LTRs of lentiviral vectors. These “twin sites” enhance the safety of iPS re-programming and -differentiation as they enable the subsequent quantitative excision of a transgene, leaving behind a single “FRT-twin”. Such a strategy combines the established expression potential of the common retro- and lentiviral systems with options to terminate the process at will. The remaining genomic tag serves to identify and characterize the insertion site with the goal to identify genomic “safe harbors” (GOIs) for re-use. This is enabled by the capacity of “FRT-twins” to accommodate any incoming RMCE-donor cassette with a compatible design.     

Synthetic biology and metabolic engineering of actinomycetes for natural product discovery

Actinomycetes are one of the most valuable sources of natural products with industrial and medicinal importance. After more than half a century of exploitation, it has become increasingly challenging to find novel natural products with useful properties as the same known compounds are often repeatedly re-discovered when using traditional approaches. Modern genome mining approaches have led to the discovery of new biosynthetic gene clusters, thus indicating that actinomycetes still harbor a huge unexploited potential to produce novel natural products. In recent years, innovative synthetic biology and metabolic engineering tools have greatly accelerated the discovery of new natural products and the engineering of actinomycetes. In the first part of this review, we outline the successful application of metabolic engineering to optimize natural product production, focusing on the use of multi-omics data, genome-scale metabolic models, rational approaches to balance precursor pools, and the engineering of regulatory genes and regulatory elements. In the second part, we summarize the recent advances of synthetic biology for actinomycetal metabolic engineering including cluster assembly, cloning and expression, CRISPR/Cas9 technologies, and chassis strain development for natural product overproduction and discovery. Finally, we describe new advances in reprogramming biosynthetic pathways through polyketide synthase and non-ribosomal peptide synthetase engineering. These new developments are expected to revitalize discovery and development of new natural products with medicinal and other industrial applications.