Natural meiotic recombination hot spots in the Schizosaccharomyces pombe genome successfully predicted from the simple sequence motif M26

The M26 hot spot of meiotic recombination in Schizosaccharomyces pombe is the eukaryotic hot spot most thoroughly investigated at the nucleotide level. The minimum sequence required for M26 activity was previously determined to be 5'-ATGACGT-3'. Originally identified by a mutant allele, ade6-M26, the M26 heptamer sequence occurs in the wild-type S. pombe genome approximately 300 times, but it has been unclear whether any of these are active hot spots. Recently, we showed that the M26 heptamer forms part of a larger consensus sequence, which is significantly more active than the heptamer alone. We used this expanded sequence as a guide to identify a smaller number of sites most likely to be active hot spots. Ten of the 15 sites tested showed meiotic DNA breaks, a hallmark of recombination hot spots, within 1 kb of the M26 sequence. Among those 10 sites, one occurred within a gene, cds1(+), and hot spot activity of this site was confirmed genetically. These results are, to our knowledge, the first demonstration in any organism of a simple, defined nucleotide sequence accurately predicting the locations of natural meiotic recombination hot spots. M26 may be the first example among a diverse group of simple sequences that determine the distribution, and hence predictability, of meiotic recombination hot spots in eukaryotic genomes.     

Hot Spots of Recombination in Fission Yeast: Inactivation of the M26 Hot Spot by Deletion of the Ade6 Promoter and the Novel Hotspot Ura4-Aim

The M26 mutation in the ade6 gene of Schizosaccharomyces pombe creates a hot spot of meiotic recombination. A single base substitution, the M26 mutation is situated within the open reading frame, near the 5' end. It has previously been shown that the heptanucleotide sequence 5' ATGACGT 3', which includes the M26 mutation, is required for hot spot activity. The 510-bp ade6-delXB deletion encompasses the promoter and the first 23 bp of the open reading frame, ending 112 bp upstream of M26. Deletion of the promoter in cis to M26 abolishes hot spot activity, while deletion in trans to M26 has no effect. Homozygous deletion of the promoter also eliminates M26 hot spot activity, indicating that the heterology created through deletion of the promoter per se is not responsible for the loss of hot spot activity. Thus, DNA sequences other than the heptanucleotide 5' ATGACGT 3', which must be located at the 5' end of the ade6 gene, appear to be required for hot spot activity. While the M26 hotspot stimulates crossovers associated with M26 conversion, it does not affect the crossover frequency in the intervals adjacent to ade6. The flanking marker ura4-aim, a heterology created by insertion of the ura4(+) gene upstream of ade6, turned out to be a hot spot itself. It shows disparity of conversion with preferential loss of the insertion. The frequency of conversion at ura4-aim is reduced when the M26 hot spot is active 15 kb away, indicating competition for recombination factors by hot spots in close proximity.     

A specific DNA sequence is required for high frequency of recombination in the ade6 gene of fission yeast.

The point mutation M26 in the ade6 gene of Schizosaccharomyces pombe increases recombination frequency by an order of magnitude in comparison with other mutations in the same gene. The hypothesis is tested that this hot spot of recombination requires a specific nucleotide sequence at the M26 site. The DNA sequence is altered systematically by in vitro mutagenesis, and the resulting sequences are introduced into the ade6 gene in vivo by gene replacement. It results that any change of the heptanucleotide ATGACGT leads to loss of high frequency of recombination. Thus this oligonucleotide sequence is necessary for high frequency of recombination, but it seems not to be sufficient.     

DNA sequence analysis of the ade6 gene of Schizosaccharomyces pombe. Wild-type and mutant alleles including the recombination host spot allele ade6-M26

The gene ade6 is located on chromosome III of the fission yeast Schizosaccharomyces pombe. It codes for the enzyme phosphoribosylaminoimidazole carboxylase involved in purine biosynthesis. A DNA fragment of 3043 nucleotides has been sequenced. It complements ade6 mutations when present on plasmids. An uninterrupted open reading frame of 552 amino acid residues was identified. A method for the cloning of chromosomal mutations by repair of gapped replication vectors in vivo has been developed. Twelve ade6 mutant alleles have been isolated. The sequence alterations of four mutant alleles have been determined. Among them are the ade6-M26 recombination hot spot mutation and the nearby ade6-M375 control mutation. Both are G to T base substitutions, converting adjacent glycine codons to TGA termination codons. They are suppressed by defined tRNA nonsense suppressors of the UGA type. The ade6-M26 mutation leads to a tenfold increase of the occurrence of conversion tetrads in comparison with other ade6 mutations. Possible explanations for the M26-induced increase of recombination frequency are discussed in relation to specific features of the nucleotide sequence identified in the region of the M26 mutation.     

Active and Inactive Transplacement of the M26 Recombination Hotspot in Schizosaccharomyces Pombe

The ade6-M26 mutation of the fission yeast Schizosaccharomyces pombe creates a meiotic recombination hotspot that elevates ade6 intragenic recombination ~10-15-fold. A heptanucleotide sequence including the M26 point mutation is required but not sufficient for hotspot activity. We studied the effects of plasmid and chromosomal context on M26 hotspot activity. The M26 hotspot was inactive on a multicopy plasmid containing M26 embedded within 3.0 or 5.9 kb of ade6 DNA. Random S. pombe genomic fragments totaling ~7 Mb did not activate the M26 hotspot on a plasmid. M26 hotspot activity was maintained when 3.0-, 4.4-, and 5.9-kb ade6-M26 DNA fragments, with various amounts of non-S. pombe plasmid DNA, were integrated at the ura4 chromosomal locus, but only in certain configurations relative to the ura4 gene and the cointegrated plasmid DNA. Several integrations created new M26-independent recombination hotspots. In all cases the non-ade6 DNA was located >1 kb from the M26 site, and in some cases >2 kb. Because the chromosomal context effect was transmitted over large distances, and did not appear to be mediated by a single discrete DNA sequence element, we infer that the local chromatin structure has a pronounced effect on M26 hotspot activity.     

A highly polymorphic meiotic recombination mouse hot spot exhibits incomplete repair

The recent mapping of recombination hot spots in the human genome has demonstrated that crossover is a nonrandom process that occurs at well-defined positions along chromosomes. However, the mechanisms that direct hot-spot turnover in complex mammalian genomes are poorly understood. Analyses of the human genome are impaired by the inability to genetically dissect and molecularly manipulate recombinogenic regions to test their roles in regulating hot spots. Here, using the BXD recombinant inbred strains as a crossover library, three new recombination hot spots have been identified on mouse chromosome 19. Analyses of a highly polymorphic recombination hot spot (HS22) revealed that approximately 4% of recombinant molecules display complex and incomplete repair with discontinuous conversion tracts, as well as persistent heteroduplex DNA at crossover sites in mature spermatozoa. Also, sequence analysis of the wild house mouse revealed instability at the center of this hot spot. This suggests that complete repair is not required for completion of mammalian meiosis, a scenario that leaves duplex DNA containing mismatches at crossover sites.     

Preferential strand transfer and hybrid DNA formation at the recombination hotspot ade6-M26 of Schizosaccharomyces pombe.

The ade6-M26 mutation of Schizosaccharomyces pombe stimulates intragenic and intergenic meiotic recombination. M26 is a single base pair change creating a specific heptanucleotide sequence that is crucial for recombination hotspot activity. This sequence is recognized by proteins that may facilitate rate-limiting steps of recombination at the ade6 locus. To start the elucidation of the intermediate DNA structures formed during M26 recombination, we have analyzed the aberrant segregation patterns of two G to C transversion mutations flanking the heptanucleotide sequence in crosses homozygous for M26. At both sites the level of post-meiotic segregation is typical for G to C transversion mutations in S. pombe in general. Quantitative treatment of the data provides strong evidence for heteroduplex DNA being the major recombination intermediate at the M26 site. We can now exclude a double-strand gap repair mechanism to account for gene conversion across the recombination hotspot. Furthermore, the vast majority (> 95%) of the heteroduplexes covering either of the G to C transversion sites are produced by transfer of the transcribed DNA strand. These results are consistent with ade6-M26 creating an initiation site for gene conversion by the introduction of a single-strand or a double-strand break in its vicinity, followed by transfer of the transcribed DNA strands for heteroduplex DNA formation.     

The Ade6-M26 Mutation of Schizosaccharomyces Pombe Increases the Frequency of Crossing over

The ade6-M26 mutation of Schizosaccharomyces pombe increases conversion frequency in comparison with the nearby mutation ade6-M375. In order to investigate the effect of ade6-M26 on crossover frequency, heteroallelic ade6 duplications were constructed by integration of plasmids carrying the marker gene ura4. One ade6 gene carries either of the mutations M26 or M375 while the other ade6 copy carries the L469 mutation in both duplications. The duplication with ade6-M26 yields Ade(+) recombinants at significantly higher frequencies in meiosis, but not in mitosis. Tetrad analysis and physical characterization of spore clones from recombination tetrads demonstrate that conversions, unequal crossovers and intrachromatid exchanges occur at higher frequencies but with unaltered proportions among them. The conversion events show a pronounced bias when M26 is involved: they take place preferentially at the M26 allele. Thus the ade6-M26 mutation not only enhances conversion frequency as demonstrated before, but also crossover frequency. It displays the properties expected for a preferred site of initiation of general meiotic recombination. The duplications also yielded new information on ectopic recombination in S. pombe: ectopic crossovers occur in the duplications at much higher frequency than among naturally dispersed homologous sequences.     

Genetic and Physical Analysis of the M26 Recombination Hotspot of Schizosaccharomyces Pombe

The ade6-M26 mutation of Schizosaccharomyces pombe has previously been reported to stimulate ade6 intragenic meiotic recombination. We report here that the ade6-M26 mutation is a single G----T nucleotide change, that M26 stimulated recombination within ade6 but not at other distinct loci, and that M26 stimulated meiotic but not mitotic recombination. In addition, M26 stimulated recombination within ade6 when M26 is homozygous; this result demonstrates that a base-pair mismatch at the M26 site was not required for the stimulation. These results are consistent with the ade6-M26 mutation creating a meiotic recombination initiation site.     

Detecting spatial hot spots in landscape ecology

Hot spots are typically locations of abundant phenomena. In ecology, hot spots are often detected with a spatially global threshold, where a value for a given observation is compared with all values in a data set. When spatial relationships are important, spatially local definitions – those that compare the value for a given observation with locations in the vicinity, or the neighbourhood of the observation – provide a more explicit consideration of space. Here we outline spatial methods for hot spot detection: kernel estimation and local measures of spatial autocorrelation. To demonstrate these approaches, hot spots are detected in landscape level data on the magnitude of mountain pine beetle infestations. Using kernel estimators, we explore how selection of the neighbourhood size (τ) and hot spot threshold impact hot spot detection. We found that as τ increases, hot spots are larger and fewer; as the hot spot threshold increases, hot spots become larger and more plentiful and hot spots will reflect coarser scale spatial processes. The impact of spatial neighbourhood definitions on the delineation of hot spots identified with local measures of spatial autocorrelation was also investigated. In general, the larger the spatial neighbourhood used for analysis, the larger the area, or greater the number of areas, identified as hot spots.     

Molecular features of meiotic recombination hot spots

Meiotic recombination occurs preferentially at certain regions called hot spots and is important for generating genetic diversity and proper segregation of chromosomes during meiosis. Hot spots have been characterized most extensively in yeast, mice and humans. The development of methods based on sperm typing and population genetics has facilitated rapid and high-resolution mapping of hot spots in mice and humans in recent years. With increasing information becoming available on meiotic recombination in different species, it is now possible to compare several molecular features associated with hot-spot loci. Further, there have been advances in our knowledge of the factors influencing hot-spot activity and the role that they play in structuring the genome into haplotype blocks. We review the molecular features associated with hot spots in terms of their properties and mechanisms underlying their function and distribution. A large number of these features seem to be shared among hot spots from different species suggesting common mechanisms for their formation and function.