Numerical simulation of a surface barrier discharge in air

The development of a surface barrier discharge in air at atmospheric pressure under the action of a constant voltage of different polarity is simulated numerically. When the polarity of the high-voltage electrode is negative, the discharge develops as an ionization wave that moves along the dielectric surface. When the polarity is positive, the discharge develops as a streamer that first moves above the dielectric surface and then comes into contact with and continues to develop along it. In the case of a high-voltage electrode of positive polarity, the discharge zone above the dielectric surface is approximately five times thicker than that in the case of negative polarity. The characteristic aspects of numerical simulation of the streamer phase of a surface barrier discharge are discussed. The numerical results on the density of the charge stored at the dielectric surface and on the length of the discharge zone agree with the experimental data.     

Specific features of a single-pulse sliding discharge in neon near the threshold for spark breakdown

Experimental data on the spatial structure of a single-pulse sliding discharge in neon at voltages below, equal to, and above the threshold for spark breakdown are discussed. The experiments were carried at gas pressures of 30 and 100 kPa and different polarities of the discharge voltage. Photographs of the plasma structure in two discharge chambers with different dimensions of the discharge zone and different thicknesses of an alumina dielectric plate on the surface of which the discharge develops are inspected. Common features of the prebreakdown discharge and its specific features depending on the voltage polarity and gas pressure are analyzed. It is shown that, at voltages below the threshold for spark breakdown, a low-current glow discharge with cathode and anode spots develops in the electrode gap. Above the breakdown threshold, regardless of the voltage polarity, spark channels directed from the cathode to the anode develop against the background of a low-current discharge.     

Structure of the surface streamers of an AC barrier corona in argon

Results are presented from experimental studies of the structure of an ac surface discharge excited by a metal needle over a plane dielectric surface. A barrier corona discharge was ignited in atmospheric-pressure argon at frequencies of the applied sinusoidal voltage from 50 Hz to 30 kHz. In experiments, the area of a dielectric covered with the discharge plasma increased with applied voltage. The discharge structure in diffuse and streamer modes was recorded using a digital camera and a high-speed image tube operating in a frame mode. It is found that, in the positive and negative half-periods of the applied voltage, the structure of the surface discharge is substantially different. The statistical characteristics of the branching surface streamers in the positive and negative half-periods are determined as functions of the voltage frequency. The most intense lines in the emission spectrum of the barrier corona are determined for both half-periods. The correlation between the dynamics of the emission intensity and the dynamics of the discharge current and voltage is investigated.     

The Memory Effect of Microdischarges in the Barrier Discharge in Airflow

Plasma Physics Reports - The paper devoted to the research of the microdischarge dynamics in the dielectric barrier discharge. The discharge between rail electrodes in airflow along the electrodes...     

Study of the surface barrier discharge generated by electrodes in the form of a series of parallel metal strips

A surface discharge in a system where metal electrodes in the form of a series of parallel strips are positioned on the dielectric surface is studied. Analytical formulas for calculating the spatial distribution of the potential and the electric field in a discharge cell are derived. It is shown that the geometry of the metal electrodes should be taken into account (along with physical and chemical characteristics of the dielectric, the voltage applied to the electrodes, and other parameters of the system) for generation of the electric field with optimal configuration in the discharge cell. The obtained results are also applicable for analysis of discharge cells with a coplanar barrier discharge where metal electrodes are positioned in the dielectric at small depths. The results are of interest since a barrier discharge is one of the efficient methods for generating non-equilibrium plasma at high pressures for a variety of technological applications.     

Observation and Investigation of “Reverse Breakdown” in a Discharge Tube

A discharge operating in a 80-cm-long discharge tube with an inner diameter of 15 mm, filled with a 3 : 1 neon–argon mixture at a pressure of 1 Torr, was investigated experimentally. Square voltage pulses with a period of 1 s were supplied to one of the tube electrodes, the second electrode being ungrounded. The initial stage of breakdown—the primary breakdown between the high-voltage (active) electrode and the tube wall, accompanied by the propagation of the prebreakdown ionization wave—was the same as in the conventional scheme with a grounded low-voltage electrode. Since the discharge gap was not closed, the discharge was not ignited. An essentially new effect was observed after the end of the voltage pulse. After a certain time interval, voltage spikes of opposite polarity, the amplitude and shape of which were close to those observed during the primary breakdown, appeared in the voltage and current waveforms of the active electrode. Simultaneously, a radiation pulse from the region adjacent to the active electrode was observed and an ionization wave began to propagate toward the second electrode. This work is dedicated to investigating this effect (which was named “reverse breakdown”) and analyzing its mechanism. A conclusion is made on the similarity of this phenomenon to the processes occurring in atmospheric-pressure dielectric barrier discharges.     

Comparison of the AC barrier corona with DC positive and negative coronas and barrier discharge

Results are presented from experimental studies of ac corona discharges between a point electrode and a dielectric-coated plate in nitrogen, argon, helium, and air in the voltage frequency range f=50 Hz–50 kHz. The characteristic features of this type of discharge are compared with the well-known features of dc positive and negative coronas and a barrier discharge between plane electrodes. It is shown that the presence of a dielectric barrier on the plane electrode significantly changes the electric characteristics and spatial structure of the corona, whereas the main phases of the discharge evolution remain unchanged as the voltage increases. With a point electrode, the breakdown voltage of the barrier corona decreases substantially as compared to the breakdown voltage of a barrier discharge with plane electrodes. This leads to softer conditions for the streamer formation in a barrier corona, which becomes more stable against spark generation.     

Analytical Model of a Surface Barrier Discharge Development

Plasma Physics Reports - The propagation of the front of a single surface dielectric barrier microdischarge is studied using an analytical model based on the charge balance equation. The model...     

Study of electric discharges between moving electrodes in air

A barrier electric discharge excited between a fixed electrode and a rotating electrode covered with a dielectric layer in atmospheric-pressure air is studied experimentally. A distinctive feature of this type of discharge is that it operates at a constant voltage between the electrodes. An advantage of the proposed method for plasma generation in the boundary layer of the rotating electrode (e.g., for studying the influence of plasma on air flows) is the variety of forms of the discharge and conditions for its initiation, simplicity of the design of the discharge system, and ease of its practical implementation     

Mechanism of streamer stopping in a surface dielectric barrier discharge

Two-dimensional numerical simulations of streamer development in a surface dielectric barrier discharge excited by a voltage pulse with a duration of 30–50 ns in atmospheric air show that the streamer propagation velocity is mainly governed by the velocity of potential diffusion along streamer channels. The calculated streamer length substantially exceeds the experimentally observed one due to the long-term conservation of the conductivity of these channels. A hypothesis on the three-dimensional character of the decay of the surface streamer channel is proposed. The model account of this effect in two-dimensional simulations reduces the calculated time of streamer development and the calculated streamer length to the experimentally observed values.     

Pulsed submicrosecond multichannel sliding discharges of opposite polarities: Filling of the discharge gap with spark channels

Results are presented from measurements of the discharge current and the factor of the discharge gap filling with spark channels during pulsed sliding discharges of opposite polarities in Ne, Ar, and Xe on an aluminum oxide ceramic surface. The measurements were performed in the regime of single pulses of submi-crosecond duration at discharge voltages of 0?C12 kV with two discharge chambers with different thicknesses of the ceramic plate (0.4 and 0.17 cm) and different electrode gap lengths (4 and 10.3 cm) at gas pressures of 30 and 100 kPa. The results obtained for discharges of opposite polarities are compared with one another, and common features of discharges in three gases are revealed. It is shown that the filling of the discharge gap with spark channels in the gases under study is more efficient in the case of the positive polarity of the discharge voltage, except Xe at a pressure of 100 kPa in the electrode gap of length 10.3 cm. The quasi-homogeneous regime of discharge in each of the three gases is attained easier at lower gas pressures. Comparison of the data on the filling factors of the discharge gap and the peak currents of opposite-polarity discharges for each gas at a given pressure indicates that the higher the discharge current, the more densely the discharge gap is filled with spark channels.     

Effects of Electrode Material on the Voltage of a Tree-Based Energy Generator

The voltage between a standing tree and its surrounding soil is regarded as an innovative renewable energy source. This source is expected to provide a new power generation system for the low-power electrical equipment used in forestry. However, the voltage is weak, which has caused great difficulty in application. Consequently, the development of a method to increase the voltage is a key issue that must be addressed in this area of applied research. As the front-end component for energy harvesting, a metal electrode has a material effect on the level and stability of the voltage obtained. This study aimed to preliminarily ascertain the rules and mechanisms that underlie the effects of electrode material on voltage. Electrodes of different materials were used to measure the tree-source voltage, and the data were employed in a comparative analysis. The results indicate that the conductivity of the metal electrode significantly affects the contact resistance of the electrode-soil and electrode-trunk contact surfaces, thereby influencing the voltage level. The metal reactivity of the electrode has no significant effect on the voltage. However, passivation of the electrode materials markedly reduces the voltage. Suitable electrode materials are demonstrated and recommended.     

Electric characteristics of a surface barrier discharge with a plasma induction electrode

Static and dynamic current-voltage and charge-voltage characteristics of a surface barrier discharge with a plasma induction electrode have been investigated experimentally. The dependences of the discharge current on both the gas pressure in the induction electrode tube and the winding pitch of the corona electrode, as well as of the discharge power efficiency on the applied voltage, have been measured.     

A powerful electrohydrodynamic flow generated by a high-frequency dielectric barrier discharge in a gas

Theoretical and experimental studies of an electrohydrodynamic flow induced by a high-frequency dielectric barrier discharge distributed over a dielectric surface in a gas have been conducted. Dependences of the ion current, the gas flow velocity, and the spatial distributions thereof on the parameters of the power supply of the plasma ion emitter and an external electric field determined by the collector grid voltage have been described.     

Radial Distribution of the Nanosecond Dielectric Barrier Discharge Current in Atmospheric-Pressure Air

Experimental results on the radial distribution of the nanosecond dielectric barrier discharge (DBD) current in flat millimeter air gaps under atmospheric pressure and natural humidity of 40–60% at a voltage rise rate at the electrodes of 250 V/ns are presented. The time delay of the appearance of discharge currents was observed to increase from the center to the periphery of the air gap at discharge gap heights above 3 mm, which correlated with the appearance of constricted channels against the background of the volume DBD plasma. Based on the criterion of the avalanche-streamer transition, it is found out that the development of a nanosecond DBD in air gaps of 1–3 mm occurs by the streamer mechanism.     

Self-Rotation of Cells in an Irrotational AC E-Field in an Opto-Electrokinetics Chip

The use of optical dielectrophoresis (ODEP) to manipulate microparticles and biological cells has become increasingly popular due to its tremendous flexibility in providing reconfigurable electrode patterns and flow channels. ODEP enables the parallel and free manipulation of small particles on a photoconductive surface on which light is projected, thus eliminating the need for complex electrode design and fabrication processes. In this paper, we demonstrate that mouse cells comprising melan-a cells, RAW 267.4 macrophage cells, peripheral white blood cells and lymphocytes, can be manipulated in an opto-electrokinetics (OEK) device with appropriate DEP parameters. Our OEK device generates a non-rotating electric field and exerts a localized DEP force on optical electrodes. Hitherto, we are the first group to report that among all the cells investigated, melan-a cells, lymphocytes and white blood cells were found to undergo self-rotation in the device in the presence of a DEP force. The rotational speed of the cells depended on the voltage and frequency applied and the cells'' distance from the optical center. We discuss a possible mechanism for explaining this new observation of induced self-rotation based on the physical properties of cells. We believe that this rotation phenomenon can be used to identify cell type and to elucidate the dielectric and physical properties of cells.     

Study of spatiotemporal dynamics of a nanosecond atmospheric-pressure dielectric barrier discharge in millimeter-long air gaps

The spatiotemporal dynamics of a nanosecond atmospheric-pressure dielectric barrier discharge in 1- to 3-mm-long air gaps was studied experimentally. By using a segmented electrode, data on the time evolution of the discharge in different regions of the discharge gap were obtained. The uniformity of the discharge over the cross section is estimated by analyzing the spatial distribution of its glow.     

Modeling of a Ne/Xe dielectric barrier discharge excilamp for improvement of VUV radiation production

This work is devoted to excimer lamp efficiency optimization by using a homogenous discharge model of a dielectric barrier discharge in a Ne?Xe mixture. The model includes the plasma chemistry, electrical circuit, and Boltzmann equation. In this paper, we are particularly interested in the electrical and kinetic properties and light output generated by the DBD. Xenon is chosen for its high luminescence in the range of vacuum UV radiation around 173 nm. Our study is motivated by interest in this type of discharge in many industrial applications, including the achievement of high light output lamps. In this work, we used an applied sinusoidal voltage, frequency, gas pressure, and concentration in the ranges of 2–8 kV, 10–200 kHz, 100–800 Torr, and 10–50%, respectively. The analyzed results concern the voltage V _p across the gap, the dielectric voltage V _d, the discharge current I, and the particles densities. We also investigated the effect of the electric parameters and xenon concentration on the lamp efficiency. This investigation will allow one to find out the appropriate parameters for Ne/Xe DBD excilamps to improve their efficiency.     

Plasmachemical and heterogeneous processes in ozonizers with oxygen activation by a dielectric barrier discharge

Plasmachemical and heterogeneous processes of generation and loss of ozone in the atmosphericpressure dielectric barrier discharge in oxygen are studied theoretically. Plasmachemical and electronic kinetics in the stage of development and decay of a single plasma filament (microdischarge) are calculated numerically with and without allowance for the effects of ozone vibrational excitation and high initial ozone concentration. The developed analytical approach is applied to determine the output ozone concentration taking into account ozone heterogeneous losses on the Al₂O₃ dielectric surface. Using the results of quantummechanical calculations by the method of density functional theory, a multistage catalytic mechanism of heterogeneous ozone loss based on the initial passivation of a pure Al₂O₃ surface by ozone and the subsequent interaction of O₃ molecules with the passivated surface is proposed. It is shown that the conversion reaction 2O₃ → 3O₂ of a gas-phase ozone molecule with a physically adsorbed ozone molecule can result in the saturation of the maximum achievable ozone concentration at high specific energy depositions, the nonstationarity of the output ozone concentration, and its dependence on the prehistory of ozonizer operation.     

Numerical Study of the Voltage Waveform Effect on the Spatiotemporal Characteristics of a Dielectric Barrier Microdischarge in Argon

The effect of the shape of the feeding voltage on the spatiotemporal characteristics of an atmospheric- pressure barrier microdischarge in argon is demonstrated using numerical simulations based on an extended fluid model. Results of simulations performed for sinusoidal and square feeding voltages are analyzed.