Transposition of TnA does not generate deletions

Summary We have examined the incidence of loss of the TnA unit, Tn801, from RP1 under conditions where transposition of Tn801 to another replicon, R388, was readily detected. We found that the frequency of transposition of Tn801 from RP1 to R388 exceeded, by at least a factor of one hundred, the frequency at which it was deleted from RP1. We conclude that, in general, transposition of Tn801 does not generate derivatives of the donor plasmid which specifically lack Tn801. The relevance of these findings to the mechanism of transposition is discussed.     

Insertion element IS1 can generate a 10-base pair target duplication

Transposable element IS1 is known to generate mainly 9-bp and occasionally 8-bp target duplications upon transposition. We have isolated a plasmid pBR322 derivative having IS1 inserted into a site between the promoter and the structural gene for tetracycline resistance. DNA sequence analysis revealed that integration of this IS1 resulted in a 10-bp target duplication.     

Colicin V-treated Escherichia coli does not generate membrane potential.

Colicin V-treated Escherichia coli was inhibited in its capacity to carry out active transport of proline and was unable to generate a membrane potential. Colicin V also prevented membrane potential formation by isolated cytoplasmic membrane vesicles. We conclude that a primary effect of this colicin involves the cytoplasmic membrane as a target.     

IS1 insertion generates duplication of a nine base pair sequence at its target site.

Three independent integrations of the E. coli insertion sequence, IS1, into the gal operon have been analyzed. DNA sequences of portions of the wild-type galT gene which act as the target sites for these insertions, as well as the corresponding gal/IS1 junctions, are reported. Two features are particularly noteworthy. First, similar sequences appearing in inverted orientation consitute the ends of IS1: 18 of the terminal 23 base pairs at each end are identical. Second, in all three insertions, a 9 base pair segment found once in the wild-type sequence at the site of insertion is duplicated and appears in the same orientation at each end of the inserted element. The sequence of this 9 base pair repeat is different for each insertion analyzed. No homology between the inverted repeat sequences at the ends of IS1 and the sequences of the target sites is observed. Models for the mechanism of IS1 insertion are proposed.     

Transposition and target specificity of the typical IS30 family element IS1655 from Neisseria meningitidis

We have analysed the transposition and target selection strategy of IS1655, a typical IS30 family member resident in Neisseria meningitidis. We have redefined IS1655 as a 1080 bp long element with 25 bp imperfect inverted repeats (IRs), which generates a 3 bp target duplication and have shown that it transposes using an intermediate with abutted IRs separated by 2 bp. IS1655 exhibits bipartite target specificity inserting preferentially either next to sequences similar to its IRs or into an unrelated but well defined sequence. IR-targeting leads to the formation of a new junction in which the targeted IR and one of the donor IRs are separated by 2 bp. The non-IR targets were characterized as an imperfect 19 bp palindrome in which the central five positions show slight GC excess and the distal region is AT-rich. Artificial targets designed according to the consensus were recognized by the element as hot spots for insertion. The organization of IS1655 is similar to that of other IS30 family members. Moreover, it shows striking similarity to IS30 in transposition strategy even though their transposases differ in their N-terminal regions, which, for IS30, appears to determine target specificity. Comparative analysis of the transposases and the evolutionary aspects of sequence variants are also briefly discussed.     

Integration of IS3 into IS2 generates a short sequence duplication.

Summary The Gal⁺ allele IS2-43 is known to segregate Gal^- clones. Among 11 Gal^- segregants, one was shown to be due to the integration of IS3 into IS2-43. Precise excision of the integrated IS3 element occured at a rate of 5x10^-9/cell/generation. DNA sequence analysis revealed that the termini of the IS3 element have the relation of imperfect inverted repeats and it is now flanked by a 3bp or 4bp duplication, a size which has not been seen before with other elements.     

Transposition of the IS21-related element IS1415 in Rhodococcus erythropolis.

Three copies of the IS21-related transposable element IS1415 were identified in Rhodococcus erythropolis NI86/21. Adjacent to one of the IS1415 copies, a 47-bp sequence nearly identical to the conserved 5' end of integrons was found. Accurate transposition of IS1415 carrying a chloramphenicol resistance gene (Tn5561) was demonstrated following delivery from a suicide vector to R. erythropolis SQ1.     

Transposition of IS50L activates downstream genes.

A transposition system constructed to detect the transposition of Tn5 to a site upstream of the lacZ gene has revealed that transposition of IS50L can activate downstream genes. Expression is apparently mediated by the NPTII promoter. Transposase produced either by IS50R or by the suppressed IS50L catalyzed transposition of IS50L.     

IS870 requires a 5'-CTAG-3' target sequence to generate the stop codon for its large ORF1.

The TB regions of the Agrobacterium vitis octopine/cucumopine Ti plasmids constitute a family of related structures. All contain a bacterial insertion element downstream of the TB-iaaM gene, IS870.1. Whereas 43 isolates with octopine/cucumopine Ti plasmids carry only one IS870 copy, strain Ag57 carries a second copy (IS870.2) 3.9 kb to the right of IS870.1 and part of the same TB region. Two other octopine/cucumopine strains carry an IS870 copy on their chromosome (IS870.3). A study of the unmodified insertion sites of IS870.2 and IS870.3, cloned from closely related strains, enabled us to delimit the IS870 elements. IS870 has a size of 1,152 bp and is terminated by inverted repeats. It contains a large open reading frame without a stop codon. However, a stop codon is generated by insertion into the target sequence 5'-CTAG-3'. IS870 is related to five other insertion sequence elements. For two of these, the stop codon of the largest open reading frame is also created by insertion into a CTAG target site.     

Polo-like kinase 4 controls centriole duplication but does not directly regulate cytokinesis

Centrioles organize the centrosome, and accurate control of their number is critical for the maintenance of genomic integrity. Centrioles duplicate once per cell cycle, and duplication is coordinated by Polo-like kinase 4 (Plk4). We previously demonstrated that Plk4 accumulation is autoregulated by its own kinase activity. However, loss of heterozygosity of Plk4 in mouse embryonic fibroblasts has been proposed to cause cytokinesis failure as a primary event, leading to centrosome amplification and gross chromosomal abnormalities. Using targeted gene disruption, we show that human epithelial cells with one inactivated Plk4 allele undergo neither cytokinesis failure nor increase in centrosome amplification. Plk4 is shown to localize exclusively at the centrosome, with none in the spindle midbody. Substantial depletion of Plk4 by small interfering RNA leads to loss of centrioles and subsequent spindle defects that lead to a modest increase in the rate of cytokinesis failure. Therefore, Plk4 is a centriole-localized kinase that does not directly regulate cytokinesis.     

Transposition of IS10R in Lactococcus lactis

Aims:  To characterize the transposition mechanism of the IS-element IS 10 R and study how this element is involved in gene disruption in Lactococcus lactis .
Methods and Results:  The gene flciA confers immunity against lactococcin A in lactococci. However, the immunity function was lost when flciA was co-expressed with the regulator gene nisR on a plasmid in L. lactis NZ9000. By PCR and DNA sequencing, it was revealed that flciA in immune-negative transformants was disrupted by the IS-element IS 10 R. Such gene disruption did not occur when flciA was expressed alone nor when the plasmid-located nisR was mutated, suggesting that nisR is directly involved in the transposition. The sequence 5'-CACTTAACC-3', which was found in flciA and at both ends of the inserted IS 10 R, was identified as target site by site-directed mutagenesis.
Conclusions:  IS 10 R transposes in L. lactis NZ9000 in a nisR -dependent fashion and employs the sequence 5'-CACTTAACC-3' as integration site.
Significance and Impact of the Study:  To our knowledge, this is the first time IS 10 R and aspects of its transposition are described in the industrial important bacterium L. lactis . The highly controllable insertion of IS 10 R into a target site might present a great potential as a gene disruption system.     

The variant rpoS allele of S. enteritidis strain 27655R does not affect virulence in a chick model nor constitutive curliation but does generate a cold-sensitive phenotype

Adherence of pathogenic Escherichia coli and Salmonella spp. to host cells is in part mediated by curli fimbriae which, along with other virulence determinants, are positively regulated by RpoS. Interested in the role and regulation of curli (SEF17) fimbriae of Salmonella enteritidis in poultry infection, we tested the virulence of naturally occurring S. enteritidis PT4 strains 27655R and 27655S which displayed constitutive and null expression of curli (SEF17) fimbriae, respectively, in a chick invasion assay and analysed their rpoS alleles. Both strains were shown to be equally invasive and as invasive as a wild-type phage type 4 strain and an isogenic derivative defective for the elaboration of curli. We showed that the rpoS allele of 27655S was intact even though this strain was non-curliated and we confirmed that a S. enteritidis rpoS::str^r null mutant was unable to express curli, as anticipated. Strain 27655R, constitutively curliated, possessed a frameshift mutation at position 697 of the rpoS coding sequence which resulted in a truncated product and remained curliated even when transduced to rpoS::str^r. Additionally, rpoS mutants are known to be cold-sensitive, a phenotype confirmed for strain 27655R. Collectively, these data indicated that curliation was not a significant factor for pathogenesis of S. enteritidis in this model and that curliation of strains 27655R and 27655S was independent of RpoS. Significantly, strain 27655R possessed a defective rpoS allele and remained virulent. Here was evidence that supported the concept that different naturally occurring rpoS alleles may generate varying virulence phenotypic traits.     

The IS1 elements in Shigella boydii: horizontal transfer,vertical inactivation and target duplication

IS1(SB) and its two variants were identified as the major and minor IS1 elements in Shigella boydii. The nucleotide sequences of IS1(SB), IS1(O157:H7) from Escherichia coli O157:H7 and IS1F from E. coli K12 suggest that these IS1 elements had been horizontally transferred among S. boydii and E. coli O157:H7 and K12. The two IS1(SB) variants and IS1(O157:H7) have transposition activities 7- to 86-fold less than that of IS1(SB), whereas IS1F has little transposition activity. Analysis of the flanking sequences of IS1(SB) and its two variants in S. boydii revealed the nature of regional specificity of the target sites and the sequence dependence of 8 and 9 bp target duplications, for which a model is presented.     

Base substitutions in transposable element IS1 cause DNA duplication of variable length at the target site for plasmid co-integration.

We demonstrate that base substitutions in the IS1 sequence affect the length of the nucleotide sequence which is duplicated during IS1-mediated co-integration. IS1K, an IS1 variant present in the Escherichia coli chromosome, has seven base substitutions in its sequence as compared with that of IS1R derived from the plasmid R100. All substitutions are located in the internal region of IS1K. We have constructed plasmids containing IS1R, IS1K and hybrids between them: one contains four base substitutions causing an amino acid substitution in the insA gene and the other has three substitutions producing an amino acid substitution in the insB gene. We have isolated co-integrate plasmids formed by each IS1 and analysed nucleotide sequences of the target sites duplicated at the co-integration junctions. The results show that IS1K generates duplications of 8 or 14 bp as well as 9 bp, while IS1R exclusively generates the 9-bp duplications. Both hybrid IS1s also create 8- or 7-bp target duplications in addition to 9-bp duplications. These results indicate that the base substitutions in either insA or insB are sufficient for the occurrence of unusual target duplications, suggesting that both genes are involved in the target duplication.     

Low level of Hox1.3 gene expression does not preclude the use of promoterless vectors to generate a targeted gene disruption. off.

A variety of experimental approaches have been devised recently to mutate mammalian genes by homologous recombination. In this report, we describe the disruption of the Hox1.3 locus by using two of these approaches, namely, positive-negative selection and activation of a promoterless gene. Interestingly, we observe similarly high frequencies of targeted disruption with both procedures. The high frequency of targeted disruption with a promoterless vector was unexpected given the extremely low level of Hox1.3 expression in the embryonic stem cell line used for these studies. These data indicate that minimal expression of the target gene is required to enrich for homologous recombination events with promoterless vectors and thus enhance the promoterless gene approach as a general strategy to mutate mammalian genes by homologous recombination.