New procedures for glycophorin A purification with high yield and high purity

Glycophorin A (GPA) is the major glycoprotein of the human erythrocyte membrane. It is known to form, in SDS gels as well as in a membrane environment, homodimers, and also heterodimers with the homologous molecule Glycophorin B (GPB). It is shown in this report that the propensity of GPA to dimerize with GPB precludes satisfactory preparation with high yield of pure GPA using classical techniques including SEC and RPLC. It was demonstrated using multiple angle light scattering that GPA is eluted from RPLC columns as dimers. A convenient procedure was devised which allowed us to get pure GPA with high yield. This procedure consists of selectively blocking GPA–GPB heterodimer formation by selective modification of Cysteine 50 of GPB before RPLC.     

X-ray scattering by single-headed heavy meromyosin. Cleavage of the myosin head from the rod does not change its shape

Low angle X-ray scattering from heavy meromyosin (HMM) and from single-headed heavy meromyosin (sHMM) have been examined to determine if the heads of myosin change shape when cleaved from the rod to form subfragment 1 (S1). The scattering intensities of intact HMM and sHMM were compared with those of their chymotryptic digestion products, S1 and subfragment 2 (S2). As the data with HMM were complicated by scattering between the two heads, the more extensive analysis was done with sHMM. Pseudo-Guinier plots of intact and digested sHMM, over the angular range used previously for S1, were linear and showed a difference in apparent radius of gyration (Rg) of only 0.07 +/- 0.04 nm. The absolute apparent Rg value of sHMM was 3.2 +/- 0.2 nm, which is comparable to the radius of gyration reported previously for S1 alone. A plot of the fractional differences in scattering intensities of intact and digested sHMM was flat to a reciprocal spacing of at least 1/3.5 nm-1. These results indicate that the head portions of sHMM and S1 have very similar structures at low resolution. Scattering curves for various models of sHMM and mixtures of S1 and S2 were calculated and the fractional difference plots of scattering intensities were made to determine how sensitive this type of analysis is to changes in the shape of the head. Changes in Rg of 0.1 nm or greater gave detectably non-flat difference plots. Thus, the X-ray scattering of sHMM (and HMM) demonstrated that differences in structure between the head of myosin and isolated S1 are likely to be small. Current controversies over myosin head structure are discussed in light of this result.     

Binding of phosphorylated and dephosphorylated heavy meromyosin to F-actin

The effect of myosin light chain phosphorylation in skeletal muscle was investigated with respect to the binding affinity of phosphorylated and dephosphorylated heavy meromyosin (HMM) for F-actin in the absence of ATP. For phosphorylated HMM the affinity was 2.5-times weaker in the presence of Ca²⁺ as in its absence (HMM divalent binding sites saturated only with Mg). For dephosphorylated HMM the reverse was true, the binding being 2.4-times higher in the presence of Ca²⁺.     

High-throughput laser-mediated in situ cell purification with high purity and yield.

BACKGROUND: Technologies for purification of living cells have significantly advanced basic and applied research in many settings. Nevertheless, certain challenges remain, including the robust and efficient purification (e.g., high purity, yield, and sterility) of adherent and/or fragile cells and small cell samples, efficient cell cloning, and safe purification of biohazardous cells. In addition, existing purification methods are generally open loop and exhibit an inverse relation between cell purity and yield. METHODS: An automated closed-loop (i.e., employing feedback control) cell purification technology was developed by building upon medical laser applications and laser-based semiconductor manufacturing equipment. Laser-enabled analysis and processing has combined high-throughput in situ cell imaging with laser-mediated cell manipulation via large field-of-view optics and galvanometer steering. Laser parameters were determined for cell purification using three mechanisms (photothermal, photochemical, and photomechanical), followed by demonstration of system performance and utility. RESULTS: Photothermal purification required approximately 10(8) W/cm(2) at 523 nm in the presence of Allura Red, resulting in immediate protein coagulation and cell necrosis. Photochemical purification required approximately 10(9) W/cm(2) at 355 nm, resulting in apoptosis induction over 4 to 24 h. Photomechanical purification required more than 10(10) W/cm(2) independent of wavelength, resulting in immediate cell lysis. Each approach resulted in high efficiency purification (>99%) after a single operation, as demonstrated with eight cell types. An automated closed-loop process to re-image and irradiate remaining targets in situ was implemented, resulting in improved purification (99.5-100%) without decreasing cell yield or affecting sterility in this closed system. Efficient purification was demonstrated with B- and T-cell mixtures over a wide range of contaminating cell percentages (0.1-99%) and cell densities (10(4)-10(6)/cm(2)). Efficient cloning of 293T cells based on fluorescence with green fluorescent protein after plasmid transfection was also demonstrated. CONCLUSIONS: In situ laser-mediated purification was achieved with nonadherent and adherent cells on the automated laser-enabled analysis and processing platform. Closed-loop processing routinely enabled greater than 99.5% purity with a greater than 90% cell yield in sample sizes ranging from 10(1) to 10(8) cells. Throughput ranged from approximately 10(3) to 10(5) total cells/s for contaminating percentages ranging from 99% to 0.1%, respectively.     

Interaction of anthracycline antibiotics with actin and heavy meromyosin.

For the purpose of elucidating the biochemical mechanism of anthracycline cardiomyopathy, the interaction with actin and heavy meromyosin (HMM) was studied. HMM and acto-HMM Mg²⁺-ATPase reactions were inhibited by daunorubicin and adriamycin; but not significantly by aclacinomycin A. The three antibiotics induced G-actin polymerization. Difference absorption spectra showed a direct interaction of adriamycin or aclacinomycin A with actin or HMM. Equilibrium dialysis and spectrofluorometric studies indicated that actin monomer possesses one binding site for adriamycin or aclacinomycin A with the same order of association constants (1.4 – 7.2 × 10⁴ M^?1). Adriamycin exhibited significantly higher affinity for HMM than aclacinomycin A.     

Interaction of actin with myosin A and heavy meromyosin.

Ca2+ "free" actomyosin suspensions as well as actin heavy meromyosin (HMM) solutions in the presence of Ca2+ showed no contractile response (superprecipitation) and had low steady-state Mg2+-ATPase activity. Under the same experimental conditions both the enzymatic activity increased and contractile response was restored if the solubility of the proteins was depressed by the addition of polyethylene glycol 4000 (PEG-4000). The stability of the enzymatically active actomyosin or actin HMM complexes was 10 times lower in cleared solutions than in the insoluble actomyosin or actin HMM suspensions. It was concluded that soluble actomyosin or actin HMM solutions are inadequate test tube models for studying muscular contraction.     

Rapid purification of EGFP, EYFP, and ECFP with high yield and purity

Most current high throughput purification procedures for the green fluorescent protein (GFP) suffer from poor yields and low purity. An improved purification procedure that delivers highly pure protein (>95% homogeneity) in high yields (>70% of the initial fluorescent protein content) has been developed. The purification procedure requires only two steps: the cell lysate is heated to 60 degrees C for 4 min in ammonium sulfate and triethylamine, followed by hydrophobic interaction chromatography using isopropanol during the elution phase. The resulting pure product exhibits the same fluorescence profile as the crude sample. This procedure has been demonstrated on three commercial variants of GFP from Aequorea victoria, enhanced green, enhanced yellow, and enhanced cyan fluorescent protein (Becton-Dickinson). The yield and purity of material are superior to other recently described methods.     

Preparation of distinct ubiquitin chain reagents of high purity and yield

The complexity of protein ubiquitination signals derives largely from the variety of polyubiquitin linkage types that can modify a target protein, each imparting distinct functional consequences. Free ubiquitin chains of uniform linkages and length are important tools in understanding how ubiquitin-binding proteins specifically recognize these different polyubiquitin modifications. While some free ubiquitin chain species are commercially available, mutational analyses and labeling schemes are limited to select, marketed stocks. Furthermore, the multimilligram quantities of material required for detailed biophysical and/or structural studies often makes these reagents cost prohibitive. To address these limitations, we have optimized known methods for the synthesis and purification of linear, K11-, K48-, and K63-linked ubiquitin dimers, trimers, and tetramers on a preparative scale. The high purity and relatively high yield of these proteins readily enables material-intensive experiments and provides flexibility for engineering specialized ubiquitin chain reagents, such as fluorescently labeled chains of discrete lengths.     

Differential scanning calorimetry of a conformational transition in heavy meromyosin

We have investigated the potential use of differential scanning calorimetry (DSC) to characterize conformational changes in proteins with emphasis on a conformational change in the myosin head which may be related to the power-stroke providing force production in muscle contraction. Simulations indicate that two-state conformational transitions with enthalpy changes greater than approximately 30 kcal/mol should be observable by DSC. We present here differential scanning calorimetric studies of a predenaturation structural change in heavy meromyosin. The high concentration of protein required for these experiments leads to potential contributions from intermolecular interactions. The technical difficulties associated with studying conformational transitions by DSC are discussed.     

On the enthalpy of binding of ADP to heavy meromyosin

The binding of ADP to heavy meromyosin has been studied by microcalorimetry. Minute amounts of myokinase interfere with binding measurements, but by selection of appropriate conditions, we can estimate that the value of the apparent ΔH_binding lies between −1.0 and −3.0 kcal per mole of ADP bound (0.3 M KCl, 2 mM MgCl₂, 20 mM Tris, pH 8.00, 20°C). Values of ΔH_binding reported to date are an order of magnitude larger, and we suggest that these values are artifactual results due to myokinase contamination.