Peak triceps surae muscle activity is not specific to knee flexion angles during MVIC

There is limited research on peak activity of the separate triceps surae muscles in select knee flexion (KF) positions during a maximum voluntary isometric contraction (MVIC) used to normalize EMG signals. The aim of this study was to determine how frequent peak activity occurred during an MVIC for soleus (SOL), gastrocnemius medialis (GM), and gastrocnemius lateralis (GL) in select KF positions, and if these peaks were recorded in similar KF positions. Forty-eight healthy individuals performed unilateral plantar-flexion MVIC in standing with 0°KF and 45°KF, and in sitting with 90°KF. Surface EMG of SOL, GM, and GL were collected and processed in 250 ms epochs to determine peak root-mean-square amplitude. Peak activity was most frequently captured in standing and rarely in sitting, with no position selective to SOL, GM or GL activity. Peak GM and GL activity was more frequent in 0°KF than 45°KF, and more often in similar KF positions than not. Peak SOL activity was just as likely in 45°KF as 0°KF, and more in positions similar to GM, but not GL. The EMG amplitudes were at least 20% greater in positions that captured peak activity over those that did not. The overall findings support performing an MVIC in more than one KF position to normalize triceps surae EMG. It is emphasized that no KF position is selective to SOL, GM, or GL alone.     

EMG signal amplitude normalization technique in stretch-shortening cycle movements

Analysis of functional movements using surface electromyography (EMG) often involves recording both eccentric and concentric muscle activity during a stretch-shorten cycle (SSC). The techniques used for amplitude normalization are varied and are independent of the type of muscle activity involved. The purpose of this study was: (i) to determine the effect of 11 amplitude normalization techniques on the coefficient of variation (CV) during the eccentric and concentric phases of the SSC; and (ii) to establish the effect of the normalization techniques on the EMG signal under variable load and velocity. The EMG signal of the biceps brachii of eight normal subjects was recorded under four SSC conditions and three levels of isometric contraction. The 11 derived normalization values were total rms, mean rms and peak rms (100 ms time constant) for the isometric contractions and the mean rms and peak rms values of the ensemble values for each set of isotonic contractions. Normalization using maximal voluntary isometric contractions (MVIC), irrespective of rms processing (total, mean or peak), demonstrated greater CV above the raw data for both muscle actions. Mean ensemble values and submaximal isometric recordings reduced the CV of concentric data. No amplitude normalization technique reduced the CV for eccentric data under loaded conditions. An ANOVA demonstrated significant (P < 0.01) main effects for load and velocity on concentric raw data and an interaction (P < 0.05) for raw eccentric data. No significant effects were demonstrated for changes in velocity when the data were normalized using mean rms values. The reduction of the CV should not be at the expense of true biological variance and current normalization techniques poorly serve the analysis of eccentric muscle activity during the SSC.     

A comparison of electrical activity in the triceps surae at maximum isometric contraction with the knee and ankle at various angles

The purpose of this study was to test the endurance of the soleus muscle, and to examine the joint position at which it is most active, while simultaneously suppressing the activity of the gastrocnemius. Ten young males performed maximum isometric contraction of the triceps surae for 100 s, and the endurance and plantar flexion torque of this muscle were measured at various angles of the knee and ankle joints. The electromyogram was measured simultaneously and subsequently converted into integrated electromyogram (IEMG) values. With the knee flexed at 130 degrees, the rate of change in IEMG values for the soleus (0.454% x s(-1)) with the ankle in a neutral position was significantly higher than that for the medial and lateral gastrocnemius. Both with the ankle dorsiflexed at 10 degrees and in the neutral position, the rate of change in IEMG for the soleus was significantly higher with the knee flexed at 90 degrees and 130 degrees than with the knee fully extended. With the knee flexed at 90 degrees and 130 degrees, the IEMG activity of the soleus during the initial (5-10 s) and final 5 s tended to be higher than those for the medial and lateral gastrocnemius, regardless of the ankle joint position. We conclude that the position in which the soleus acts most selectively during a sustained maximum isometric contraction of the triceps surae is with the ankle in a neutral position and the knee flexed at 130 degrees.     

Linear correlation between fractal dimension of EEG signal and handgrip force

Fractal dimension (FD) has been proved useful in quantifying the complexity of dynamical signals in biology and medicine. In this study, we measured FDs of human electroencephalographic (EEG) signals at different levels of handgrip forces. EEG signals were recorded from five major motor-related cortical areas in eight normal healthy subjects. FDs were calculated using three different methods. The three physiological periods of handgrip (command preparation, movement and holding periods) were analyzed and compared. The results showed that FDs of the EEG signals during the movement and holding periods increased linearly with handgrip force, whereas FD during the preparation period had no correlation with force. The results also demonstrated that one method (Katz’s) gave greater changes in FD, and thus, had more power in capturing the dynamic changes in the signal. The linear increase of FD, together with results from other EEG and neuroimaging studies, suggest that under normal conditions the brain recruits motor neurons at a linear progress when increasing the force.     

Medial gastrocnemius muscle-tendon interaction and architecture change during exhaustive hopping exercise

Background: Previous literature has shown in vivo changes in muscle-tendon interaction during exhaustive stretch-shortening cycle (SSC) exercise. It is unclear whether these changes in muscle-tendon length during exhaustive SSC exercise are associated with changes in mechanical efficiency (ME). The purpose of the study was to investigate whether changes in platarflexor contractile component (CC) length, tendon length, and changes in plantarflexor muscle activity could explain reduction in ME during exhaustive SSC exercise. Methods: Eight males participated in an exhaustive hopping task to fatigue. Mechanical work and energy expenditure were calculated at different time-points during the hopping task. Furthermore, hopping kinetics and kinematics, medial gastrocnemius (MG) muscle activity, and in vivo ultrasound of the MG were also collected at different time-points throughout the hopping task. Results: ME did not change during the hopping protocol despite shorter tendon and longer CC lengths as subjects approached exhaustion. Percent decreases in pennation angle and muscle thickness were most strongly correlated to time to exhaustion (r = 0.94, p ⩽ 0.05; r = 0.87, p ⩽ 0.05; respectively). Percent changes in CC length change and pennation angle were strongly correlated to percent decrease in maximal voluntary isometric plantarflexion (MVIP) force (r = −0.71, p ⩽ 0.04; r = 0.70, p ⩽ 0.05; respectively). Braking/push-off EMG ratio increased from initial pre-fatigue values to all other time points showing neuromuscular adaptations to altered muscle lengths. Conclusion: Findings from the current study suggest that changes in CC and tendon lengths occur during repetitive hopping to exhaustion, with the amount change strongly related to time to exhaustion. ME of hopping remained unchanged in the presence of altered CC and tendon lengths.     

Repeatability of maximal voluntary force and of surface EMG variables during voluntary isometric contraction of quadriceps muscles in healthy subjects

The repeatability of initial values and rate of change of EMG signal mean spectral frequency (MNF), average rectified values (ARV), muscle fiber conduction velocity (CV) and maximal voluntary contraction (MVC) was investigated in the vastus medialis obliquus (VMO) and vastus lateralis (VL) muscles of both legs of nine healthy male subjects during voluntary, isometric contractions sustained for 50 s at 50% MVC. The values of MVC were recorded for both legs three times on each day and for three subsequent days, while the EMG signals have been recorded twice a day for three subsequent days. The degree of repeatability was investigated using the Fisher test based upon the ANalysis Of VAriance (ANOVA), the Standard Error of the Mean (SEM) and the Intraclass Correlation Coefficient (ICC).

Data collected showed a high level of repeatability of MVC measurement (normalized SEM from 1.1% to 6.4% of the mean). MNF and ARV initial values also showed a high level of repeatability (ICC>70% for all muscles and legs except right VMO). At 50% MVC level no relevant pattern of fatigue was observed for the VMO and VL muscles, suggesting that other portions of the quadriceps might have contributed to the generated effort. These observations seem to suggest that in the investigation of muscles belonging to a multi-muscular group at submaximal level, the more selective electrically elicited contractions should be preferred to voluntary contractions.     

Developments in techniques for the isolation,enrichment, main culture conditions and identification of spermatogonial stem cells

The in vitro culture system of spermatogonial stem cells (SSCs) provides a basis for studies on spermatogenesis, and also contributes to the development of new methods for the preservation of livestock and animal genetic modification. In vitro culture systems have mainly been established for mouse SSCs, but are lacking for farm animals. We reviewed and analyzed the current progress in SSC techniques such as isolation, purification, cultivation and identification. Based on the published studies, we concluded that two-step enzyme digestion and magnetic-activated cell sorting are fast becoming the main methods for isolation and enrichment of SSCs. With regard to the culture systems, serum and feeders were earlier thought to play an important role in the self-renewal and proliferation of SSCs, but serum- and feeder-free culture systems as a means of overcoming the limitations of SSC differentiation in long-term SSC culture are being explored. However, there is still a need to establish more efficient and ideal culture systems that can also be used for SSC culture in larger mammals. Although the lack of SSC-specific surface markers has seriously affected the efficiency of purification and identification, the transgenic study is helpful for our identification of SSCs. Therefore, future studies on SSC techniques should focus on improving serum- and feeder-free culture techniques, and discovering and identifying specific surface markers of SSCs, which will provide new ideas for the optimization of SSC culture systems for mice and promote related studies in farm animals.     

QTL‐seq for rapid identification of candidate genes for 100‐seed weight and root/total plant dry weight ratio under rainfed conditions in chickpea

Terminal drought is a major constraint to chickpea productivity. Two component traits responsible for reduction in yield under drought stress include reduction in seeds size and root length/root density. QTL‐seq approach, therefore, was used to identify candidate genomic regions for 100‐seed weight (100SDW) and total dry root weight to total plant dry weight ratio (RTR) under rainfed conditions. Genomewide SNP profiling of extreme phenotypic bulks from the ICC 4958 × ICC 1882 population identified two significant genomic regions, one on CaLG01 (1.08 Mb) and another on CaLG04 (2.7 Mb) linkage groups for 100SDW. Similarly, one significant genomic region on CaLG04 (1.10 Mb) was identified for RTR. Comprehensive analysis revealed four and five putative candidate genes associated with 100SDW and RTR, respectively. Subsequently, two genes (Ca_04364 and Ca_04607) for 100SDW and one gene (Ca_04586) for RTR were validated using CAPS/dCAPS markers. Identified candidate genomic regions and genes may be useful for molecular breeding for chickpea improvement.     

Normalising surface EMG of ten upper-extremity muscles in handcycling: Manual resistance vs. sport-specific MVICs

Muscular activity in terms of surface electromyography (sEMG) is usually normalised to maximal voluntary isometric contractions (MVICs). This study aims to compare two different MVIC-modes in handcycling and examine the effect of moving average window-size. Twelve able-bodied male competitive triathletes performed ten MVICs against manual resistance and four sport-specific trials against fixed cranks. sEMG of ten muscles [M. trapezius (TD); M. pectoralis major (PM); M. deltoideus, Pars clavicularis (DA); M. deltoideus, Pars spinalis (DP); M. biceps brachii (BB); M. triceps brachii (TB); forearm flexors (FC); forearm extensors (EC); M. latissimus dorsi (LD) and M. rectus abdominis (RA)] was recorded and filtered using moving average window-sizes of 150, 200, 250 and 300 ms. Sport-specific MVICs were higher compared to manual resistance for TB, DA, DP and LD, whereas FC, TD, BB and RA demonstrated lower values. PM and EC demonstrated no significant difference between MVIC-modes. Moving average window-size had no effect on MVIC outcomes. MVIC-mode should be taken into account when normalised sEMG data are illustrated in handcycling. Sport-specific MVICs seem to be suitable for some muscles (TB, DA, DP and LD), but should be augmented by MVICs against manual/mechanical resistance for FC, TD, BB and RA.