A simulation of subtractive hybridization.

Various strategies employed in genomic DNA cloning by subtractive hybridization have been examined by computer simulations, with the comparison between the predictions and the published results. The result shows that the efficiency of target sequence enrichment and the sensitivity to experimental conditions depend strongly on the enrichment strategy employed. The strategy selecting only tester/tester after hybridization can be very efficient to enrich targets. For successful target enrichment, however, the strategy requires a highly efficient subtraction method and proper hybridization conditions. The strategy also requires that the selected DNA be amplified by polymerase chain reaction (PCR) after each or each alternate subtraction. By contrast, the strategy selecting tester/tester plus single-stranded tester is less sensitive to various experimental factors, compared with the strategy selecting only tester/tester. However, it is not as efficient. With this strategy, the tester DNA selected may or may not be amplified by PCR before the next round. In the case of the strategy selecting single-stranded tester, the target DNA can be successfully enriched only when the selected DNA is directly used without PCR amplification in the next round. The strong features of existing methods can be combined to develop a protocol that is more efficient and more reliable.     

Simple and efficient subtractive hybridization screening.

A method of subtractive hybridization screening is presented that does not rely on the availability of large amounts of poly(A)+ RNA. The usefulness of this method is demonstrated by the isolation of cDNA clones that are unique or present at enhanced levels in cDNA libraries derived from a psoriatic skin cell line. A very high level of enrichment for rare cDNA sequences is possible as shown by the isolation of cDNA clones present at a frequency of less than one in one hundred thousand (0.001%). This method is particularly useful in experimental systems where the amount of RNA available is limited.     

Optimization of subtractive hybridization in construction of subtractive cDNA libraries

The efficiency of subtraction, integrity of residual single-stranded cDNA, and efficient recovery of nanogram quantities of double-stranded cDNA are the three most important factors affecting quality of subtractive hybridization reactions prior to subtractive cDNA library construction. Techniques for efficient isolation of single-stranded cDNA, after subtraction, have greatly improved from early protocols based on hydroxylapatite chromatography to phenol-chloroform extraction of biotin-streptavidin-crosslinked polynucleotides or oligo(dA)-cellulose affinity chromatography. Factors affecting mRNA stability at the hybridization step, however, also have consequences that directly affect the complexity of the library and the length of cDNAs recovered. We have optimized the subtractive hybridization step in subtractive cDNA library construction to ensure that single-stranded cDNAs survive hybridization as near to full length as possible. These improvements have enabled successful construction of subtractive cDNA libraries from the nanogram quantities of single-stranded cDNA remaining after extensive liquid hybridization to high calculated C_ot values.     

Identification by subtractive hybridization of sequences specific for Salmonella enterica serovar enteritidis.

Salmonella enterica serovar Enteritidis, a major cause of food poisoning, can be transmitted to humans through intact chicken eggs when the contents have not been thoroughly cooked. Infection in chickens is asymptomatic; therefore, simple, sensitive, and specific detection methods are crucial for efforts to limit human exposure. Suppression subtractive hybridization was used to isolate DNA restriction fragments present in Salmonella serovar Enteritidis but absent in other bacteria found in poultry environments. Oligonucleotide primers to candidate regions were used in polymerase chain reactions to test 73 non-Enteritidis S. enterica isolates comprising 34 different serovars, including Dublin and Pullorum, two very close relatives of Enteritidis. A primer pair to one Salmonella difference fragment (termed Sdf I) clearly distinguished serovar Enteritidis from all other serovars tested, while two other primer pairs only identified a few non-Enteritidis strains. These primer pairs were also useful for the detection of a diverse collection of clinical and environmental Salmonella serovar Enteritidis isolates. In addition, five bacterial genera commonly found with Salmonella serovar Enteritidis were not detected. By treating total DNA with an exonuclease that degrades sheared chromosomal DNA but not intact circular plasmid DNA, it was shown that Sdf I is located on the chromosome. The Sdf I primers were used to screen a Salmonella serovar Enteritidis genomic library and a unique 4,060-bp region was defined. These results provide a basis for developing a rapid, sensitive, and highly specific detection system for Salmonella serovar Enteritidis and provide sequence information that may be relevant to the unique characteristics of this serovar.     

Improved PCR-based subtractive hybridization strategy for cloning differentially expressed genes

An improved PCR-based subtractive hybridization strategy was used to clone apoptosis-related genes induced by all-trans retinoic acid (ATRA) from human promyelocytic leukemia cell line HL-60 cells. The protocol used the cap-finder method, long-distance PCR, streptavidin magnetic bead-mediated subtraction and spin column chromatography. Twenty-seven clones related to apoptosis were identified by reverse dot blot assay. Seventeen were known genes, of which seven have been reported to be apoptosis related. The remaining 10 were unknown genes, five of which were sequenced and named apr-1 to apr-5. apr-1, apr-2, apr-3 and TNF were reidentified by reverse dot blot, and it is suggested that they might be related to apoptosis. The results suggest that this strategy might be efficient for large-scale cloning of differentially expressed genes in target cells.     

抑制性扣除杂交技术(SSH)及其研究进展

一般认为,真核生物基因总数为100,000个左右。但在一定发育阶段,在某一类型的细胞当中,则只有15%左右的基因得以表达[1]。而生物体几乎所有的生命活动过程包括病理的变化,从本质上讲均是基因表达变化的结果。因此,关于真核生物发育过程中基因的表达与调控的研究已引起人们的高度重视。过去,人们对差异表达基因的分离主要依赖于示差筛选和差别杂交技术,但它们又存在着重复性差、敏感度低等缺点。近几年,随着ＰＣＲ技术的出现,涌现了许多基于ＰＣＲ的分离有差别表达基因的新方法。1992年ＬｉａｎｇＰ等[2]提出ｍＲＮＡ差异显示技术(ｍＲＮＡｄ…     

A kinetic model for binding protein-mediated arabinose transport.

A kinetic model is presented based on the simplest plausible mechanism for bacterial binding protein-dependent transport. The transport phenotypes of the 18 variant arabinose-binding proteins analyzed by Kehres and Hogg (1992, Protein Sci. 1, 1652-1660) (wild type and 17 mutants) are interpreted to mean that in wild-type arabinose uptake the forward transport rate (k(for)) greatly exceeds the dissociation rate (kund) of a binding protein docked with the AraG:AraH membrane complex, and that k(for) dominance is preserved in all of the binding protein surface mutants. The assumptions and predictions of the model are consistent with existing data from other periplasmic transport systems.     

A model for oscillatory kinetic systems

A kinetic model is proposed for oscillatory kinetic phenomena. The exact analytic solution is exhibited and shown to account for several features exhibited by oscillatory chemical and biological systems.     

A kinetic model for glutamate dehydrogenase

A model for the glutamate dehydrogenase reaction has been obtained that contains the reported intermediates suggested by binding and equilibrium isotope exchange methods. Calculated steady state-initial velocity rates using this model are quantitatively consistent with a wide range of nonlinear experimental data in both directions.     

A kinetic model for plasmid curing

A simple mathematical model of drug-induced plasmid elimination (curing) considering density-dependent growth rates and plasmid transfers is presented. It describes nonlinear population dynamics of conjugative plasmids during in vitro curing experiments in batch culture. The model was tested on kinetics of acridine orange curing of F'lac plasmid. Effects of density dependence, plasmid elimination, selection for plasmidless segregants, conjugation, initial and maximal population density, and postsegregational killing on curing kinetics are simulated and discussed.     

A kinetic model for calcium distribution

Models for the distribution of minerals in the body are of interest as they allow researchers to trace the effect of a dose on mineral levels in plasma, storage and other compartments. Limited models are available in the literature for tracing the distribution of a calcium dose through a short time period. We propose a more general kinetic model which includes both limited absorption through the gut and loss of calcium via excretion. This new method has the advantages of giving reasonable results over moderate time periods, and allowing the extrapolation of calcium levels in extracellular fluid and storage. We fit the model to published data in order to obtain typical parameter values. These values are then used to analyze the implications of the model regarding the effect of calcium dose on calcium levels in various compartments.     

抑制性差减杂交技术在蚊虫研究中的应用

抑制性差减杂交技术(suppression subtractive hybridization)是在差减杂交和抑制性PCR技术的基础上发展起来的鉴别差异表达基因的实验方法,用于分离2种具有相同或者相似遗传背景,但是表型上有差异的生物样品中差异表达的基因。这项技术在蚊虫许多研究领域,如抗药性、病原体感染、生理特性等得到广泛的应用。本文对抑制性差减杂交技术在蚊虫各研究领域的应用情况进行了综述。     

A kinetic model for cell agglutination

A model of concanavalin A (ConA) mediated cell agglutination kinetics is proposed, in which the binding of the lectin, the agglutination of cells and the disintegration of cell clumps are discussed. This resulted in a differential equation, which is solved in terms of the average number of cells per cell clump as a function of time.     

Microplate subtractive hybridization to enrich for bacteroidales genetic markers for fecal source identification

The ability to identify sources of fecal pollution plays a key role in the analysis of human health risk and the implementation of water resource management strategies. One approach to this problem involves the identification of bacterial lineages or gene sequences that are found exclusively in a particular host species or group. We used subtractive hybridization to enrich for target host-specific fecal Bacteroidales rRNA gene fragments that were different from those of very closely related reference (subtracter) host sources. Target host rRNA gene fragments were hybridized to subtracter rRNA gene fragments immobilized in a microplate well, and target sequences that did not hybridize were cloned and sequenced for PCR primer design. The use of microplates for DNA immobilization resulted in a one-step subtractive hybridization in which the products could be directly amplified with PCR. The new host-specific primers designed from subtracted target fragments differentiated among very closely related Bacteroidales rRNA gene sequences and distinguished between similar fecal sources, such as elk and cow or human and domestic pet (dog).     

A competitive kinetic model of nucleic acid surface hybridization in the presence of point mutants

Microarray analysis has become increasingly complex due to the growing size of arrays and the inherent cross-binding of targets. In this work, we explore the effects of matched and mismatched target species concentrations, temperature, and the time of hybridization on sensing specificity in two-component systems. A finite element software is used to simulate the diffusion of DNA through a microfluidic chamber to the sensing surface where hybridization of DNA is modeled using the corresponding kinetic equation. Comparison between a single-component system, where only one target is allowed to bind to a specific zone, and a two-component system, where more than one target can hybridize in a sensing zone, uncovers significant kinetic disparities during the transitory state; however, at thermodynamic equilibrium a modified Langmuir isotherm governs the bound amount of both species. The results presented suggest that it may be more appropriate to consider collective rather than quasi-independent interaction of targets in multicomponent systems.