Bioavailability of organic and inorganic phosphates adsorbed on short-range ordered aluminum precipitate

A nonreductive community-level study of P availability was conducted using various forms of adsorbed P. Orthophosphate (Pi), inositol hexaphosphate (IHP), and glucose 6-phosphate (G6P) were adsorbed to a short-range ordered Al precipitate. These bound phosphates provided a P source sufficient to support the growth of microbial communities from acidic Brazilian soils (oxisols). Adsorbed IHP, the most abundant form of organic phosphate in most soils, had the lowest bioavailability among the three phosphates studied. Adsorbed G6P and Pi were almost equally available. The amount of adsorbed Pi (1 cmol P kg^–1) required to support microbial growth was at least 30 times less than that of IHP (30 cmol P kg^–1). With increased surface coverage, adsorbed IHP became more bioavailable. This availability was attributed to a change in the structure of surface complexes and presumably resulted from the decreased number of high-affinity surface sites remaining at high levels of coverage. It thus appears that the bioavailability of various forms of adsorbed phosphate was determined primarily by the stability of the phosphate-surface complexes that they formed, rather than by the total amount of phosphate adsorbed. IHP, having the potential to form stable multiple-ring complexes, had the highest surface affinity and the lowest bioavailability. Bioaggregates consisting of bacteria and Al precipitate were observed and may be necessary for effective release of adsorbed P. Bacteria in the genera Enterobacter and Pseudomonas were the predominate organisms selected during these P-limited enrichments. Correspondence to: C. Shang     

Solubilization of organic and inorganic phosphates by three highly efficient soil bacterial isolates

Screening soil samples collected from a diverse range of slightly alkaline soil types, we have isolated 22 competent phosphate solubilizing bacteria (PSB). Three isolates identified as Pantoea agglomerans strain P5, Microbacterium laevaniformans strain P7 and Pseudomonas putida strain P13 hydrolyzed inorganic and organic phosphate compounds effectively. Bacterial growth rates and phosphate solubilization activities were measured quantitatively under various environmental conditions. In general, a close association was evident between phosphate solubilizing ability and growth rate which is an indicator of active metabolism. All three PSB were able to withstand temperature as high as 42°C, high concentration of NaCl upto 5% and a wide range of initial pH from 5 to 11 while hydrolyzing phosphate compounds actively. Such criteria make these isolates superior candidates for biofertilizers that are capable of utilizing both organic and mineral phosphate substrates to release absorbable phosphate ion for plants.     

Enzymic determination of inorganic phosphates, organic phosphates and phosphate-liberating enzymes by use of nucleoside phosphorylase-xanthine oxidase (dehydrogenase)-coupled reactions.

Coupled enzyme assays are described for measuring inorganic phosphates, organic phosphates and phosphate-liberating enzymes in biological material. The assays all determine Pi by its reaction with inosine, catalysed by nucleoside phosphorylase; this yields ribose 1-phosphate and hypoxanthine. The hypoxanthine is oxidized to uric acid by xanthine oxidase, and may be measured either by the absorbance of the uric acid, or by the formazan formed when a tetrazolium salt is used as the oxidant. The coupled enzyme assays are characterized by high sensitivity, quantitative utilization of phosphates and stoichiometric formation of the measurable products, measurement at pH 6.0-8.5, determination of phosphates within a single analytical step, and continuous measurement of phosphohydrolase activity in a corresponding rate assay. Examples include determinations of substrates such as Pi, PPi and AMP, and of enzymes such as 5'-nucleotidase, inorganic pyrophosphatase and glucose-6-phosphatase. Directions for further examples are given.     

A microtiter plate assay for inorganic phosphate

A microtiter assay for the detection of picomolar quantities of inorganic phosphate has been described. The assay, linear between 50 and 1000 pmol of inorganic phosphate, is simple and rapid, with results obtainable in several minutes. Results from 5'-nucleotidase and (Ca2+ + Mg2+)ATPase assays using this method were compared with conventional phosphate assays and showed a high degree of correlation. The high sensitivity of this assay and the small sample size needed allows its widespread use in biochemical studies involving the generation of inorganic phosphate.     

Solubilization of low-grade Indian rock phosphates and inorganic phosphates byBacillus licheniformis

Bacillus licheniformis solubilized a range of inorganic phosphates and five different Indian rock phosphates (low grade) to varying extent in broth culture and in soil. Statistical evaluation indicated that broth cultures alone were inadequate indicators of the potential for microbial solubilization of rock phosphates.     

Nucleotides and inorganic phosphates as potential antioxidants

Highly reactive OH radicals, formed in an iron-ion catalyzed Fenton reaction, are implicated in many pathological conditions. The quest for Fenton reaction inhibitors, either radical scavenger or metal-ion chelator antioxidants, spans the previous decades. Purine nucleotides were previously studied as natural modulators of the Fenton reaction; however, the modulatory role of purine nucleotides remained in dispute. Here, we have resolved this long-standing dispute and demonstrated a concentration-dependent biphasic modulation of the Fenton reaction by nucleotides. By electron spin resonance measurements with 0.1 mM Fe(II), we observed an increase of •OH production at low purine nucleotide concentrations (up to 0.15 mM), while at higher nucleotide concentrations, an exponential decay of •OH concentration was observed. We found that the phosphate moiety, not the nucleoside, determines the pro/antioxidant properties of a nucleotide, suggesting a chelation-based modulation. Furthermore, the biphasic modulation mode is probably due to diverse nucleotide–Fe(II) complexes formed in a concentration-dependent manner. At ATP concentrations much greater than Fe(II) concentrations, multiligand chelates are formed which inhibit the Fenton reaction owing to a full Fe(II) coordination sphere. In addition to natural nucleotides, we investigated a series of base- or phosphate-modified nucleotides, dinucleotides, and inorganic phosphates, as potential biocompatible antioxidants. Ap₅A, inorganic thiophosphate and ATP-γ-S proved highly potent antioxidants with IC₅₀ values of 40, 30, and 10 μM, respectively. ATP-γ-S proved 100 and 20 times more active than ATP and the potent antioxidant Trolox, respectively. In the presence of 30 μM ATP-γ-S no •OH was detected after 5 min in the Fenton reaction mixture. The most potent antioxidants identified inhibit the Fenton reaction by forming full coordination sphere chelates.Patent pending.     

Phosphorylation of uridine with inorganic phosphates

Phosphorylation of uridine by heating with inorganic orthophosphates can take place through reaction of nucleoside with thermally produced polyphosphate or direct reaction of nucleoside with orthophosphate or a combination of both. The relative importance of the two pathways varies with the orthophosphate and temperature.     

A continuous-flow automated assay for iodometric estimation of hydroperoxides

An iodometric method for the analysis of hydroperoxides has been automated to allow analysis of aqueous biological samples (containing less than 20 mg/ml protein) and lipid hydroperoxide extracts. The evolution of triiodide ions is measured spectrophotometrically at 360 nm. Dependent on the type of sample, 30-60 samples can be analyzed per hour and the system allows detection of less than 100 pmol of peroxide. The assay is linear over a range of 100 pmol to 25 nmol. The sample volume used routinely was 80 microliters.     

A microcolorimetric assay of inorganic pyrophosphatase

A procedure is described for the assay of inorganic pyrophosphatase in tissues by a microcolorimetric procedure, taking advantage of the marked color intensification of phosphomolybdate by malachite green. Conditions are described for optimum enzyme activity, color stability, and sensitivity. With 1-cm cuvettes the AM660 is 100,000, allowing accurate measurement of Pi in the 1-nmol range. Reaction is conducted at 25 degrees C for 10 min in 0.5 ml of a 50 mM histidine buffer, pH 7.2, containing 0.2 mM inorganic pyrophosphate and 4 mM Mg2+, terminated by addition of 0.05 ml 2.4 M HClO4, cooled in ice, and 0.45 ml of color reagent is added. After standing 10 min at 0 degrees C, the contents are transferred to 1-cm cuvettes and the absorbance is read at 660 nm. Blanks are low, nonenzymatic hydrolysis of PPi is negligible, and color is stable without addition of detergents. The high sensitivity makes this procedure well-adapted to measurement of optimal activities in crude tissue preparations.     

Modifications in the enzymatic assay for inorganic phosphate.

A recent publication from this laboratory (1) described an enzymatic assay for inorganic phosphate (P_i) which eliminates the need for standards and, through mild reaction conditions, avoids the hydrolysis of labile organic phosphates. Those features are advantageous, particularly for P_i measurements in biological samples. However, subsequent inquiries from other laboratories and our own experience indicated that the assay, as described (1), does not perform well. Specifically, it was found that the assay range was 10-fold narrower than that reported, completion times were 3- to 5-fold longer, and the reaction with P_i standards was only 90–95% complete.Because of these deficiencies we have systematically evaluated every aspect of the assay and have found that the difficulties are eliminated and the assay is improved and simplified by the following changes; (i) Triethanolamine is used in place of Tris as the assay buffer; (ii) triose phosphate isomerase is eliminated and the levels of other enzymes are adjusted to obtain optimum reaction conditions; (iii) ammonium sulfate is removed from the analytical enzymes. The modified procedure described below is more convenient, is linear up to P_i concentrations of 0.1 μmol/ml in the assay, gives complete reaction of P_i standards and quantitative recovery of P_i added to biological extracts, and comes to stable endpoints in 30 min or less (depending on the amount of P_i in the assay).     

Inhibition of NADH-methemoglobin reductase by organic phosphates.

The organic phosphate allosteric effectors of hemoglobin, inositol hexaphosphate, 2,3-diphosphoglycerate, and ATP, interact with NADH-methemoglobin reductase (NADH-diaphorase). Significant inhibitory effects on the enzyme were found when dichlorophenolindophenol, or ferricyanide were used as electron acceptors in place of methemoglobin. In contrast, apparent stimulation of enzyme activity was observed when adult human methemoglobin was used as the electroganic phosphate on the rate of reaction due to its interaction with the substrate methemoglobin to produce the favored T type of quaternary conformation. The inhibitory effect of inositol hexaphosphate on the enzyme is associated with a perturbation in the reactivity of essential sulfhydryl group(s) on the enzyme. It is suggested that the interaction of the organic phosphate with the enzyme as well as with the substrate is significant in determining the overall rate of methemoglobin reduction.     

A multi-well filtration assay for quantitation of inositol phosphates in biological samples

The quantitation of inositol phosphates (IPs), mediators of certain signal transduction processes, typically involves laborious and time consuming conventional ion-exchange chromatography procedures. We have developed a high throughput microtiter plate-based IP assay that utilizes vacuum rather than gravitational flow and has significant advantages over existing methods. The response of recombinant HEK-293 cells expressing human LHRH receptor cDNA to LHRH agonists was used as a model system to develop the assay conditions. Cell lysates containing labeled IPs were applied in 96-well plates fitted with filtration discs containing regenerated Dowex AGI-X8 resin. Specifically bound inositol phosphates were eluted with 1 M ammonium formate in 0.1 M formic acid directly into a fresh 96-well plate and an aliquot of the eluate from each well is transferred into a 96-well plate and counted. The results were comparable to those obtained with the conventional column method and the variation among replicates was significantly improved. This assay facilitates rapid quantitation of inositol phosphates from a large number of samples with relative ease and reduced generation of radioactive waste.