Equilibrium and metastable states in lecithin films.

We have considered whether lecithin surface films below the gel-liquid crystal transition temperature, Tc, are in unique physical states. In general, below Tc, equilibrium films do not exist when surface pressures, pi, exceed about 0.1 dyn/cm. Since surface pressure-surface area isotherms of lecithin films below Tc always encompass pi's much greater than 0.1 dyn/cm, the film states are metastable. We show that the film properties under these conditions depend strongly on the history of the film, particularly the method of film formation. Lecithin surface films below Tc are thus in arbitrary metastable states, so that pi-area isotherms are difficult to interpret. The physical significance of such isotherms remains to be determined. The utility of pure lecithin surface layers below Tc as models for biological systems is also challenged by our results.     

Antimicrobial films produced from chitosan.

Antimicrobial films were prepared by dissolving chitosan into hydrochloric, formic, acetic, lactic and citric acid solutions. Below 40 degrees C, the counter ions could be classified into two groups based on their effect on zero-shear-rate viscosity in 2% solutions of organic acids. Chloride and citrate produced solutions with much lower viscosities than formate, acetate and lactate. At higher temperatures, these differences vanished, and the activation energies of viscous flow were all similar between 40 and 60 degrees C. Films prepared from these solutions were evaluated in tension for Young's modulus, stress and elongation at yield and break points. Films made from hydrochloric, formic and acetic acids were hard and brittle, whereas those from lactic and citric acids were soft and could be stretched. Good correlation was found between Young's modulus and volume of the counter ion. Film properties are essentially governed by the volume of the counter ion and not by the interactions between this counter ion and the macromolecule. Results suggest that acetate has the maximum molecular volume above which the film strength decreases very rapidly.     

Survival of microbial films in the microwave oven.

Air-dried films of Escherichia coli, Saccharomyces cerevisiae, and Bacillus subtilis spores on membrane filters, exposed to 10 min full power (650 W, 2450 MHz) irradiation in a Toshiba model ER776BT microwave oven, showed a 5-, 2-, and 0-log reduction of viable organisms respectively. Suspensions of cells or spores in phosphate buffer treated under similar conditions showed 8 logs of killing within 30 s (S. cerevisiae), 45 s(E. coli), and by 10 min (B. subtilis spores) of exposure.     

X-ray-induced luminescence and optical absorption in DNA films.

For DNA films, X-irradiated at 77 K, a comparative study was performed on (a) light emission (fluorescence and phosphorescence) during irradiation, (b) afterglow and thermoluminescence, (c) optical absorption after irradiation, and (d) free-radical reactions in similar gamma-irradiatied DNA samples. Spectra are reported for the various kinds of light emission and for the optical absorption. From temperature-dependence studies, it was concluded that the light-emission phenomena are unrelated to the reactions of the free radicals as studied by electron paramagnetic resonance. The optical absorption on the other hand, is strongly correlated to the presence of free radicals in the DNA. Some mechanisms possibly involved in the observed luminescence reactions are discussed.     

Photovoltaic effect in pigment films in contact with an electrolytes. V. Theory of the Becquerel photovoltaic effect in porous films of phthalocyanine]

In accordance with literature and our experimental data a theoretical analysis of the model system metal-porous film of the pigment-electrolyte was carried out at stationary illumination in the regimes of photocurrent and photopotential. The main properties and positions of the model are supported experimentally. Specific behaviour of the photovoltaic system considered resides in the discovered dependence of the transfer mechanism on the value of catode potential of the electrode.     

Cell death in the thin films of bursting bubbles.

A sparged gas bubble floating at the liquid interface has a liquid film which drains and thins until the film spontaneously ruptures at a point. This causes rapid retraction of the film, forming a rim of collected fluid. This rim moves at a constant velocity of about 3 m/s and any cells in the bubble film are rapidly accelerated to this velocity in the moving rim. Half of the surface energy originally in the thin film is converted to kinetic energy of the rim, while the rest is dissipated in this rim. The rate of energy dissipation per mass of rim fluid is approximately 9000 m2/s3, which corresponds to a Kolmogorov eddy size of 3.2 microns in fully developed turbulence or a shear stress of 95 N/m2 in laminar flow. Either of these limiting cases presents an environment in which rapid cell death would be expected. Experiments with Sf-9 insect cells suggest that the cell concentration in these thin films is 0.6 times the bulk liquid concentration and that about 20% of these cells are killed when the film ruptures. An equation based on this mechanism accurately predicts the death rate.     

A new conformation-specific infrared band of A-DNA in films.

A band at 1185 cm-1 occurs in the infrared spectra of nucleic acids in their A-type conformation which has been reproduced in the literature, too. The absorbance of this band is proportional to the fraction of the A form of DNA samples containing a mixture of different forms. The 1185 cm-1 band has been assigned tentatively to a vibration of the sugar-phosphate backbone with a fairly high contribution from the sugar moiety. Drastic dehydration of the DNA films is accompanied by a continuous intensity decrease of the 1185 cm-1 band indicating a collapse of the A form.     

Retention of bacteria in liquid films at agar surfaces.

The number of bacteria retained by agar dipslides immersed in bacterial suspensions was dependent solely on suspension population density and was unaffected by the nutrient status of the agar surface or liquid, disturbance of the liquid, or bacterial motility and chemotaxis.     

Retention of bacteria in liquid films at agar surfaces.

The number of bacteria retained by agar dipslides immersed in bacterial suspensions was dependent solely on suspension population density and was unaffected by the nutrient status of the agar surface or liquid, disturbance of the liquid, or bacterial motility and chemotaxis.     

Lateral phase separation in interfacial films of pulmonary surfactant.

To determine if lateral phase separation occurs in films of pulmonary surfactant, we used epifluorescence microscopy and Brewster angle microscopy (BAM) to study spread films of calf lung surfactant extract (CLSE). Both microscopic methods demonstrated that compression produced domains of liquid-condensed lipids surrounded by a liquid-expanded film. The temperature dependence of the pressure at which domains first emerged for CLSE paralleled the behavior of its most prevalent component, dipalmitoyl phosphatidylcholine (DPPC), although the domains appeared at pressures 8-10 mN/m higher than for DPPC over the range of 20-37 degrees C. The total area occupied by the domains at room temperature increased to a maximum value at 35 mN/m during compression. The area of domains reached 25 +/- 5% of the interface, which corresponds to the predicted area of DPPC in the monolayer. At pressures above 35 mN/m, however, both epifluorescence and BAM showed that the area of the domains decreased dramatically. These studies therefore demonstrate a pressure-dependent gap in the miscibility of surfactant constituents. The monolayers separate into two phases during compression but remain largely miscible at higher and lower surface pressures.     

A disposable optrode using immobilized tyrosinase films.

A disposable fiber-optic sensor based on the immobilized tyrosinase enzyme in a composite biopolymer and its application for the detection of 3,4-dihydroxyphenyalanine (L-dopa) and its analog are described. The enzymatic oxidation product of L-dopa was stabilized through formation of an adduct with 3-methyl-2-benzothiazoline hydrazone resulting in enhanced accuracy and sensitivity of the measurements. The response was found to be linear and concentration dependent in the range of 5 x 10(-5) to 4 x 10(-4) M (r(2) = 0.9307) for the substrate l-dopa over the pH range 5.8 to 7.2 with response times of 8 min. The immobilized enzyme films are stable for 4 months when stored under moisture-free conditions at 4 degrees C.     

Lipid mono- and bilayer supported on polymer films: composite polymer-lipid films on solid substrates.

We report the deposition of lipid monolayers and bilayers on polyacrylamide films deposited by radical chain reaction onto solid substrates in aqueous solutions. Polymer films of various degrees of monomer density and cross-linking are prepared. Lateral diffusion and fluorescent probe permeation measurements yield insight into the continuity of the lipid layers and show that monolayers exposed to air are much less sensitive towards polymer heterogeneities than bilayers below water, which is explained in terms of the wetting laws. The diffusion studies of lipid and lipopeptide probes yield absolute values of the frictional coefficients between the lipid layer and the polymer films and allow one to estimate the surface viscosity of the polymer film. The potential applications of supported membranes on soft thin polymer films for the preparation of biofunctionalized surfaces or biocompatible receptive surfaces for biosensors are discussed.