Echocardiographic measurement of cardiac output in rats

The systematic evaluation of different transthoracic echocardiographic (TTE) methods to determine cardiac output (CO) and the effect of changes in intravascular volume on echocardiographically determined indexes of cardiovascular structure in the rat has not been documented. With the use of 11 Wistar rats, simultaneous echocardiographic and thermodilution measurements of CO were compared at baseline and after blood withdrawal or transfusion at 43 different levels of intravascular volume and using 10 different echocardiographic approaches. The best correlation (r = 0.93; P < 0.0001), least bias (-3 ml/min), and best precision (16 ml/min) between thermodilution and echocardiographic methods were obtained at the level of aortic annulus using pulsed Doppler. In conclusion, CO could be accurately assessed in rats using TTE and pulsed Doppler at the level of the aortic annulus. This annulus was demonstrated to remain stable, but pulmonary annulus, thoracic aorta, mitral valve, and left ventricular diameters were found to be more modifiable during volumic changes.     

Modelflow underestimates cardiac output in heat-stressed individuals

An estimation of cardiac output can be obtained from arterial pressure waveforms using the Modelflow method. However, whether the assumptions associated with Modelflow calculations are accurate during whole body heating is unknown. This project tested the hypothesis that cardiac output obtained via Modelflow accurately tracks thermodilution-derived cardiac outputs during whole body heat stress. Acute changes of cardiac output were accomplished via lower-body negative pressure (LBNP) during normothermic and heat-stressed conditions. In nine healthy normotensive subjects, arterial pressure was measured via brachial artery cannulation and the volume-clamp method of the Finometer. Cardiac output was estimated from both pressure waveforms using the Modeflow method. In normothermic conditions, cardiac outputs estimated via Modelflow (arterial cannulation: 6.1 ± 1.0 l/min; Finometer 6.3 ± 1.3 l/min) were similar with cardiac outputs measured by thermodilution (6.4 ± 0.8 l/min). The subsequent reduction in cardiac output during LBNP was also similar among these methods. Whole body heat stress elevated internal temperature from 36.6 ± 0.3 to 37.8 ± 0.4°C and increased cardiac output from 6.4 ± 0.8 to 10.9 ± 2.0 l/min when evaluated with thermodilution (P < 0.001). However, the increase in cardiac output estimated from the Modelflow method for both arterial cannulation (2.3 ± 1.1 l/min) and Finometer (1.5 ± 1.2 l/min) was attenuated compared with thermodilution (4.5 ± 1.4 l/min, both P < 0.01). Finally, the reduction in cardiac output during LBNP while heat stressed was significantly attenuated for both Modelflow methods (cannulation: -1.8 ± 1.2 l/min, Finometer: -1.5 ± 0.9 l/min) compared with thermodilution (-3.8 ± 1.19 l/min). These results demonstrate that the Modelflow method, regardless of Finometer or direct arterial waveforms, underestimates cardiac output during heat stress and during subsequent reductions in cardiac output via LBNP.     

The 2-bodied continuous cardiac output catheter

Continuous cardiac output (CCO) pulmonary artery catheters (PACs) are used in cardiac surgical patients for hemodynamic monitoring. This is an invasive technique; therefore, it has well-known mechanical and infectious complications related to its use. Associated problems, more commonly noticed, are catheter malfunctions and malpositions. We present a case in which a CCO catheter appeared to have a double body on radiologic diagnosis. This resulted in extra radiography for rechecking and careful clinical reevaluation of the monitored data.     

Fiberoptic ear densitometer for measurement of cardiac output

This study presents theory, operation, and evaluation of a new earpiece method for measurement of cardiac output using the multichannel fiberoptic system recently described. The system includes an earpiece of simple design and small size suitable for applications in all subjects regardless of their age or size. The method requires no withdrawal and analysis of blood samples for calibration. Compared with earlier techniques the present method, based on measurements in three distinct absorption bands in the infrared, provides an increase in accuracy of the estimations. This accuracy was tested in children undergoing routine cardiac catheterization. Comparisons were made in 39 instances (25 subjects) between simultaneously carried out determinations by the earpiece and cuvette densitometer methods. The agreement was good (r = 0.97, p less than 0.001), with a standard deviation of the differences of 0.479 litre/min, or 10.2% of the mean values derived from the cuvette curves. The regression equation describing the values derived from ear curves in terms of values from the cuvette curves differed only slightly from unity (Y = 0.167 + 0.985X). The usefulness of the fiberoptic earpiece technique both in clinical investigations and cardiovascular diagnosis was demonstrated.