Effects of sporulation pH on the heat resistance and the sporulation of Bacillus cereus

Spores of Bacillus cereus ATCC 7004, 4342 and 9818 were obtained in nutrient agar at several pH from 5·9 to 8·3. The optimum pH for sporulation was around 7, but good production of spores was obtained in the range 6·5–8·3. With all three strains, D -values clearly dropped with sporulation pH, decreasing by about 65% per pH unit. z -Values were not significantly modified ( P > 0·05) by this factor. Mean z -values of 7·13 °C ± 0·16 for strain 7004, 7·67 °C ± 0·04 for 4342 and 8·80 °C ± 0·64 for 9818 were obtained.     

A note on the effect of sporulation conditions on the resistance of Bacillus spores to heat and chemicals

Spores of Bacillus subtilis SA22 harvested after 22 d incubation on nutrient agar at 30°C were more resistant to 0–04% peracetic acid at 20°C than spores harvested following 2 d incubation. Similarly, spores of B. subtilis globigii B17, harvested after 7 d incubation on a sporulation agar were up to 10 times less resistant to 0.04% peracetic acid at 20°C than spores harvested after 35 d incubation. An increase in resistance to heating at 100°C and to exposure to 17.7% hydrogen peroxide at 20°C occurred as the age of B. subtilis SA22 spores prior to harvesting increased, whereas differences in resistance were not observed with spores of B. subtilis globigii B17.     

Stimulation of the onset of sporulation ofClostridium perfringens type A by netropsin and distamycin

The basic peptide antibiotics, netropsin and distamycin, previously shown to inhibit sporulation ofBacillus subtilis, stimulated low levels of sporulation ofClostridium perfringens strain NCTC 8798 at concentrations of 1.0 and 0.1 g/ml respectively. Most sporulating cells produced in the presence of the antibiotics were defective. These were blocked at Stage III of sporulation, and many possessed forespores exterior to the sporangium. The same antibiotics could also inhibit the caffeine-induced stimulation of sporulation of this strain.     

Mechanism of chemical manipulation of the heat resistance of Clostridium perfringens spores

The mechanism(s) of chemical manipulation of the heat resistance of Clostridium perfringens type A spores was studied. Spores were converted to various ionic forms by base-exchange technique and these spores were heated at 95°C. Of the four ionic forms, i.e. Ca²⁺, Na⁺, H⁺ and native, only hydrogen spores appeared to have been rapidly inactivated at this temperature, when survivors were enumerated on the ordinary plating medium. However, the recovery of the survivors was improved when the plating medium was supplemented with lysozyme, and more dramatically when the heated spores were pretreated with alkali followed by plating in the medium containing lysozyme. In contrast to crucial damage to germination, in particular to spore lytic enzyme, no appreciable amount of DPA was released from the heat-damaged H-spores. These results suggest that a germination system is involved in the thermal inactivation of the ionic forms of spores, and that exchangeable cation load plays a role in protection from thermal damage of the germination system within the spore. An enhancement of thermal stability of spore lytic enzyme in the presence of a high concentration of NaCl was consistent with the hypothesis.     

Perturbation of the heat resistance of bacterial spores by sporulation temperature and ethanol

Spores ofBacillus megaterium, B. subtilis, andB. stearothermophilus, harvested from cultures grown and sporulated at different temperatures or in the presence of ethanol, had different thermal resistance. There was a direct relationship between the sporulation temperature and the spore-killing temperature. The spores were more temperature-sensitive when formed in ethanol-supplemented media. Temperature and ethanol are known to perturb the degree of order within membranes and to alter membrane functions. Thus, alteration of spore membranes is an additional factor in the multifactorial nature of heat resistance. Another interpretation may be that heat shock proteins, known to be induced by heat, are formed during sporulation and may increase the thermostability of the spores.     

Influence of sporulation medium and divalent ions on the heat resistance of Alicyclobacillus acidoterrestris spores

The influence of divalent cations on the heat resistance of spores of the thermoacidophilic spoilage bacterium Alicyclobacillus acidoterrestris was studied. The heat resistance of A. acidoterrestris spores was not affected by the presence of the different divalent cations (Ca²⁺, Mg²⁺, Ba²⁺, Mn²⁺ and Sr²⁺) in the sporulation medium, and by the demineralization or remineralization. And the Ca and Mn contents in A. acidoterrestris spores were scarcely changed by these treatments. However, the heat resistance of Bacillus subtilis spores was affected with the changes of Ca content in the spores. The Ca contents in A. acidoterrestris spores of the different forms were greater than the DPA content. In contrast, the DPA content in the B. subtilis spores was greater than the Ca content. These findings suggest that the presence of constant amount of Ca-DPA and a stronger binding characteristic of divalent ions, especially Ca and Mn, is reflected in the specific heat resistance of A. acidoterrestris spores.     

Effect of sporulation conditions on the resistance of Bacillus subtilis spores to heat and high pressure

Bacillus subtilis(B. subtilis) cells were placed in various environmental conditions to study the effects of aeration, water activity of the medium, temperature, pH, and calcium content on spore formation and the resulting properties. Modification of the sporulation conditions lengthened the growth period of B. subtilis and its sporulation. In some cases, it reduced the final spore concentration. The sporulation conditions significantly affected the spore properties, including germination capacity and resistance to heat treatment in water (30 min at 97°C) or to high pressure (60 min at 350 MPa and 40°C). The relationship between the modifications of these spore properties and the change in the spore structure induced by different sporulation conditions is also considered. According to this study, sporulation conditions must be carefully taken into account during settling sterilization processes applied in the food industry.     

The heat resistance of bacterial spores and its relationship to the contraction of the forespore protoplasm during sporulation

The heat resistance of spores of 11 bacterial species is shown to correlate with the average decrease in volume of the protoplasm of spores that occurs during sporulation and that is measured from the stage in the development of the forespore at which the cortex can first be observed.     

The effect of hydrogen peroxide on spores of Clostridium perfringens

Dithiothreitol (DTT)-treated spores of Clostridium perfringens were much more sensitive to lysis by H₂O₂ in the presence of Cu²⁺ than untreated spores. Lysis was greatly inhibited by hydroxyl radical (.OH) scavengers such as thiourea, dimethylthiourea and dimethylsulfoxide, suggesting that lysis of spores by H₂O₂ involves formation of OH by Cu²⁺-catalysed decomposition of the peroxide. DTT-treated spores took up Cu²⁺ at almost the same rate and extent as did isolated cortical fragments. Hydrogen peroxide caused both the decrease in optical density and the hexosamine solubilization of cortical fragments which bound Cu²⁺.     

Heat shock applied early in sporulation affects heat resistance of Bacillus megaterium spores.

Cells of Bacillus megaterium 27 were challenged by a 30-min heat shock at 45 degrees C during various sporulation stages and then shifted back to a temperature permissive for sporulation (27 degrees C), at which they developed spores. Heat shock applied at 120 min after the end of the exponential phase induced synthesis of heat shock proteins (HSPs) in the sporangia and delayed the inactivation of spores at 85 degrees C. Several HSPs, mainly HSP 70, could be detected in the cytoplasm of these spores. An analogous HSP, the main HSP induced by increased temperature during growth, belongs to the GroEL group according to its N-terminal sequence. The identity of this protein was confirmed by Western blot (immunoblot) analysis with polyclonal antibodies against B. subtilis GroEL. Sporangia treated by heat shock immediately or 240 min after exponential phase also synthesized HSPs, but none of them could be detected in the spores in an appreciable amount. These spores showed only a slightly increased heat resistance.     

The effect of recovery conditions on the apparent heat resistance of Bacillus cereus spores

The effect of recovery media and incubation temperature on the apparent heat resistance of three ATCC strains (4342, 7004 and 9818) of Bacillus cereus spores were studied. Nutrient Agar (NA), Tryptic Soy Agar (TSA), Plate Count Agar (PCA) and Milk Agar (MA) as the media and temperatures in the range of 15–40°C were used to recover heated spores. Higher counts of heat injured spores were obtained on PCA and NA. The optimum subculture temperature was about 5°C below the optimum temperature for unheated spores. No significant differences in heat resistance were observed with the different recovery conditions except for strains 4342 and 9818 when MA was used as plating medium.
Large differences in D -values were found among the strains ( D ₁₀₀=0·28 min for 7004; D ₁₀₀=0·99 min for 4342; D ₁₀₀= 4·57 min for 9818). The 7004 strain showed a sub-population with a greater heat resistance. The z values obtained for the three strains studied under the different recovery conditions were similar (7·64°C 0·25).     

Histopathological effect ofClostridium perfringens 8-6 enterotoxin on rabbit intestine

Intestinal damage caused by an enterotoxin from a coatless spore mutant ofClostridium perfringens type A (8-6) was identified by both light and scanning electron microscopy. Under the light microscope, damage to the epithelial layer of the villus and to the lamina propria was evident. Whole tissue viewed under the scanning electron microscope confirmed the two distinct forms of damage seen by light microscopy and showed that the action of the enterotoxin on an individual villus appears to occur in a specific sequence. The gross tissue damage observed contrasts with that found in previous studies of the action ofClostridium perfringens enterotoxin on rabbit ileal tissue; this suggests that the 8-6 enterotoxin may have a different mode of action on the cell, which subsequently leads to death and lysis.     

Influence of transition metals added during sporulation on heat resistance of Clostridium botulinum 113B spores

Sporulation of Clostridium botulinum 113B in a complex medium supplemented with certain transition metals (Fe, Mn, Cu, or Zn) at 0.01 to 1.0 mM gave spores that were increased two to sevenfold in their contents of the added metals. The contents of calcium, magnesium, and other metals in the purified spores were relatively unchanged. Inclusion of sodium citrate (3 g/liter) in the medium enhanced metal accumulation and gave consistency in the transition metal contents of independent spore crops. In citrate-supplemented media, C. botulinum formed spores with very high contents of Zn (approximately 1% of the dry weight). Spores containing an increased content of Fe (0.1 to 0.2%) were more susceptible to thermal killing than were native spores or spores containing increased Zn or Mn. The spores formed with added Fe or Cu also appeared less able to repair heat-induced injuries than the spores with added Mn or Zn. Fe-increased spores appeared to germinate and outgrow at a higher frequency than did native and Mn-increased spores. This study shows that C. botulinum spores can be sensitized to increased thermal destruction by incorporation of Fe in the spores.     

Influence of transition metals added during sporulation on heat resistance of Clostridium botulinum 113B spores.

Sporulation of Clostridium botulinum 113B in a complex medium supplemented with certain transition metals (Fe, Mn, Cu, or Zn) at 0.01 to 1.0 mM gave spores that were increased two to sevenfold in their contents of the added metals. The contents of calcium, magnesium, and other metals in the purified spores were relatively unchanged. Inclusion of sodium citrate (3 g/liter) in the medium enhanced metal accumulation and gave consistency in the transition metal contents of independent spore crops. In citrate-supplemented media, C. botulinum formed spores with very high contents of Zn (approximately 1% of the dry weight). Spores containing an increased content of Fe (0.1 to 0.2%) were more susceptible to thermal killing than were native spores or spores containing increased Zn or Mn. The spores formed with added Fe or Cu also appeared less able to repair heat-induced injuries than the spores with added Mn or Zn. Fe-increased spores appeared to germinate and outgrow at a higher frequency than did native and Mn-increased spores. This study shows that C. botulinum spores can be sensitized to increased thermal destruction by incorporation of Fe in the spores.     

Reversal of radiation-dependent heat sensitization of Clostridium perfringens spores

The effect of solute concentration on the sensitization of Clostridium perfringens spores to heat by ionizing radiation was investigated. As we have shown previously, spores of C. perfringens treated with gamma radiation are now sensitive to subsequent heat treatments than are spores that receive no radiation treatment. When gamma-irradiated spores were heated in the presence of increasing concentrations of glycerol or sucrose, the heat sensitivity induced by irradiation was progressively decreased. The magnitude of the increase in heat resistance induced by extracellular solutes was greater in gamma-irradiated spores than in nonirradiated spores. Based on these observations, it is proposed that the induction of heat sensitivity in spores by radiation is related to the loss of osmoregulatory or dehydrating mechanisms in irradiated spores.     

Effect of sporulation and recovery medium on the heat resistance and amount of injury of spores from spoilage bacilli

AIMS: To assess the influence of sporulation media on heat resistance, and the use of stress recovery media to measure preservation injury of spores of five representative spoilage bacilli. METHODS AND RESULTS: Bacillus spores prepared on nutrient agar supplemented with Ca2+, Mg2+, Mn2+, Fe2+ and K+ were more heat-resistant than spores obtained from nutrient agar with Mn2+. This increased heat resistance correlated with a decrease in the protoplast water content as determined by buoyant density sedimentation. The degree of preservation injury severity could be assessed on media containing NaCl at moderate pH and organic acids at acid pH. Ca-DPA, K+ or proline were added to the recovery media to demonstrate that heat probably caused injury to both spore germination and the outgrowth system. SIGNIFICANCE AND IMPACT OF THE STUDY: The metal content of sporulation media can strongly effect the validity of preservation resistance studies. The distinctive recovery media developed here can be relevant for assessing and comparing new preservation technologies.