Thermostable, Raw-Starch-Digesting Amylase from Bacillus stearothermophilus

An endospore-forming thermophilic bacterium, which produced amylase and was identified as Bacillus stearothermophilus, was isolated from soil. The amylase had an optimum temperature of 70°C and strongly degraded wheat starch granules (93%) and potato starch granules (80%) at 60°C.     

High Production of Thermostable beta-Galactosidase of Bacillus stearothermophilus in Bacillus subtilis

By cloning the beta-galactosidase gene of Bacillus stearothermophilus IAM11001 (ATCC 8005) into Bacillus subtilis, enzyme production was enhanced 50 times. beta-Galactosidase could be purified to 80% homogeneity by incubating the cell extract of B. subtilis at 70 degrees C for 15 min, followed by centrifugation to remove the denatured proteins. Because of its heat stability and ease of production, beta-galactosidase is suitable for application in industrial processes.     

Thermostable peroxidase from Bacillus stearothermophilus

A peroxidase from Bacillus stearothermophilus was purified to homogeneity. The enzyme (Mr 175,000) was composed of two subunits of equal size, and showed a Soret band at 406 nm. On reduction with sodium dithionite, absorption at 434 nm and 558 nm was observed. The spectrum of reduced pyridine haemochrome showed peaks at 418, 526 and 557 nm; the reduced minus oxidized spectrum of pyridine haemochrome showed peaks of 418, 524 and 556 nm with a trough at 452 nm. These results indicate that the enzyme contained protohaem IX as a prosthetic group. The optimum pH was about 6 and the apparent optimum temperature was 70 degrees C. The enzyme was relatively stable up to 70 degrees C; at 30 degrees C it was stable for a month. The enzyme had peroxidase activity toward a mixture of 2,4-dichlorophenol and 4-aminoantipyrine with a Km for H2O2 of 1.3 mM. It also acted as a catalase with a Km for H2O2 of 7.5 mM.     

Spore Production by Bacillus stearothermophilus

[This corrects the article on p. 690 in vol. 14.].     

Cloning and Expression of Thermostable alpha-Amylase Gene from Bacillus stearothermophilus in Bacillus stearothermophilus and Bacillus subtilis

The structural gene for a thermostable alpha-amylase from Bacillus stearothermophilus was cloned in plasmids pTB90 and pTB53. It was expressed in both B. stearothermophilus and Bacillus subtilis. B. stearothermophilus carrying the recombinant plasmid produced about fivefold more alpha-amylase (20.9 U/mg of dry cells) than did the wild-type strain of B. stearothermophilus. Some properties of the alpha-amylases that were purified from the transformants of B. stearothermophilus and B. subtilis were examined. No significant differences were observed among the enzyme properties despite the difference in host cells. It was found that the alpha-amylase, with a molecular weight of 53,000, retained about 60% of its activity even after treatment at 80 degrees C for 60 min.     

Kinetics of Thermostable Alanine Racemase of Bacillus stearothermophilus

Unlabeled D- and L-alanine were racemized in deuterium oxide with an alanine racemase of Bacillus stearothermophilus at saturated concentration of substrate, and various p²H and temperature. Samples of the solution were taken at intervals, and all alanine isomers in the samples were transformed into a mixture of diastereomeric derivatives of methyl N-(–)-camphanylalaninate. Their ratio was measured on a GC-Mass, and the relative rate was calculated at the initial stage of the reaction. There was little difference in the decrease rate of the optical rotation between the enantiomers. Internal proton-transfer to the antipode was almost zero for either substrate. The α-hydrogen was abstracted 1.2–2.3 times faster from D-alanine than from L-alanine. D-Alanine gave an almost even mixture of deuterium labeled D- and L-alanine, while L-alanine gave a mixture of labeled D- and L-alanine at a ratio of 3:1. These results suggest the racemase builds two different bases in the active site. The base for D-alanine may be closer to the enzyme surface, and that for L-alanine inside.     

High Production of Thermostable β-Galactosidase of Bacillus stearothermophilus in Bacillus subtilis

By cloning the β-galactosidase gene of Bacillus stearothermophilus IAM11001 (ATCC 8005) into Bacillus subtilis, enzyme production was enhanced 50 times. β-Galactosidase could be purified to 80% homogeneity by incubating the cell extract of B. subtilis at 70°C for 15 min, followed by centrifugation to remove the denatured proteins. Because of its heat stability and ease of production, β-galactosidase is suitable for application in industrial processes.     

Selection of a Potent Bacillus licheniformis Strain Producing Thermostable Amylase

A highly potent strain of Bacillus licheniformis 103 that synthesized thermostable -amylase with temperature and pH optima of 90–95°C and 6.0–8.5, respectively, was obtained by mutagenesis and selection. The composition of fermentation media and conditions for submerged cultivation of the producer were optimized. -Amylase whose activity reached 260 U/ml was obtained in laboratory fermenters.     

Thermostable polynucleotide phosphorylases from Bacillus stearothermophilus and Thermus aquaticus.

Polynucleotide phosphorylase from Bacillus stearothermophilus has been purified to homogeneity. Polyacrylamide gel electrophoresis run under denaturing conditions indicates that the enzyme is a tetramer with subunits of apparent molecular weight 51,000 daltons. A partial purification of polynucleotide phosphorylase from Thermus aquaticus has also been effected. The two enzymes show similar catalytic properties, which differ little from those of mesophilic polynucleotide phosphorylases. The use of thermostable polynucleotide phosphorylases for in vitro nucleic acid synthesis is discussed.     

Cloning and Expression of Thermostable α-Amylase Gene from Bacillus stearothermophilus in Bacillus stearothermophilus and Bacillus subtilis

The structural gene for a thermostable α-amylase from Bacillus stearothermophilus was cloned in plasmids pTB90 and pTB53. It was expressed in both B. stearothermophilus and Bacillus subtilis. B. stearothermophilus carrying the recombinant plasmid produced about fivefold more α-amylase (20.9 U/mg of dry cells) than did the wild-type strain of B. stearothermophilus. Some properties of the α-amylases that were purified from the transformants of B. stearothermophilus and B. subtilis were examined. No significant differences were observed among the enzyme properties despite the difference in host cells. It was found that the α-amylase, with a molecular weight of 53,000, retained about 60% of its activity even after treatment at 80°C for 60 min.     

Thermostable extracellular protease of Bacillus stearothermophilus: factors affecting its production

A strain of protease-producing Bacillus stearothermophilus has been isolated. Glycerol was the best carbon source for production whereas yeast extract was the best nitrogen source. The bacterium could grow up to 70°C but optimum protease production was at 60°C. Best initial pH for protease production was 5. Alkaline pH inhibited production. The enzyme was stable at 60°C for 18 h and was inhibited by EDTA, PMSF and HgCl₂.The authors are with the Enzyme and Microbial Technology Group, Faculty of Science and Environmental Studies, Universiti Pertanian Malaysia, 43400 UPM Serdang, Selangor, Malaysia     

Thermostable alanine racemase of Bacillus stearothermophilus: subunit dissociation and unfolding.

The guanidine hydrochloride-induced subunit dissociation and unfolding of thermostable alanine racemase from Bacillus stearothermophilus have been studied by circular dichroism, fluorescence and absorption spectroscopies, and gel filtration. The overall process was found to be reversible: more than 75% of the original activity was recovered upon reduction of the denaturant concentration. In the range of 0.6 to 1.5 M guanidine hydrochloride, the dimeric enzyme was dissociated into a monomeric form, which was catalytically inactive. The monomeric enzyme appeared to bind the cofactor pyridoxal phosphate by a non-covalent linkage, although the native dimeric enzyme binds the cofactor through an aldimine Schiff base linkage. The monomer was mostly unfolded, with the transition occurring in the range of 1.8 to 2.2 M guanidine hydrochloride.     

Production and Purification of Thermostable Amylase and Protease of Thermomonospora viridis

Maximum yields of amylase were produced by the thermophilic actinomycete Thermomonospora viridis in a modified Simpson and McCoy medium containing 1.5% corn starch and 0.5% mycological peptone with an initial pH 7.0. Best yields of amylase were obtained after incubation for 48 h, when the pH of the medium had risen to 8.2. Amylase was purified 313-fold by precipitation with n-propyl alcohol, dialysis against tap water, adsorption on Ca₃(PO₄)₂, and fractionation on Sephadex G-100. Protease was produced in nutrient broth containing 0.5% starch and 1.0% corn steep liquor and at an initial pH 7.0. Maximum yields of protease were produced after 42 h. The protease was purified 54-fold by precipitation with n-propyl alcohol, dialysis against tap water, adsorption on Ca₃(PO₄)₂, and fractionation on Sephadex G-200.     

Purification and Characterization of Thermostable Purine Nucleoside Phosphorylase of Bacillus stearothermophilus JTS 859

A thermostable purine nucleoside phosphorylase has been purified more than 800-fold from Bacillus stearothermophilus JTS 859. The enzyme had a molecular weight of 68,000 consisting of 2 identical subunits (A/_w, 34,000). The isoelectric point of the enzyme was 4.7. The enzyme did not contain cysteine. The optimal pH of the enzyme reaction was from 7.5 to 11.0. The Michaelis constants for inosine, guanosine, 2′-deoxyinosine, and 2′-deoxyguanosine were 0.22, 0.14, 0.20, and 0.10mM, respectively. The optimal temperature of the reaction was 80 C. The half-life of the enzyme was 16 hr in 20mM potassium phosphate and ImM inosine (pH 7.0) at 80°C, and no decrease of the enzyme activity was observed at least for the first 30 hr at 70°C.     

Thermostable d-hydantoinase from thermophilic Bacillus stearothermophilus SD-1: characteristics of purified enzyme

One thousand thermophiles isolated from soils were screened for hydantoinase and its thermostability. One thermophilic bacterium that showed the highest thermostability and activity of hydantoinase was identified to be Bacillus stearothermophilus SD-1 according to morphological and physiological characteristics. The hydantoinase of B. stearothermophilus SD-1 was purified to homogeneity via ammonium sulfate fractionation, anion-exchange chromatography, heat treatment, hydrophobic-interaction chromatography, and preparative gel electrophoresis. The relative molecular mass of the hydantoinase was determined to be 126 kDa by gel-filtration chromatography, and a value of 54 kDa was obtained as a molecular mass of the subunit on analytical sodiumdodecylsulfate/polyacrylamide gel electrophoresis. The hydantoinase was strictly d-specific and metal-dependent. The optimal pH and temperature were about 8.0 and 65°C respectively, and the half-life of the d-hydantoinase was estimated to be 30 min at 80°C, indicating the most thermostable enzyme so far.     

地衣芽孢杆菌D-1产碱性蛋白酶培养条件的优化

为了对产碱性蛋白酶的地衣芽孢杆菌D-1的培养条件进行优化,利用10 L发酵罐,采用正交设计19(34)试验,对培养温度、pH值、搅拌转速、通气量4条件进行优化,得到地衣芽孢杆菌D-1发酵产碱性蛋白酶的最优培养条件为:培养温度37.0℃,pH值7.5,通气量4L/min,搅拌转速300r/min.利用最优条件组合进行验证...     

Improvement of Bacillus thuringiensis Bacteriocin Production Through Culture Conditions Optimization

Abstract

BUPM4 is a Bacillus thuringiensis subsp. kurstaki strain, isolated from Tunisian soil, producing an original bacteriocin named Bacthuricin F4. The optimization of the latter production conditions was carried out under several physicochemical conditions. It was found that the highest bacteriocin activity was reached at low aeration while bacteriocin synthesis yields were strongly reduced at higher ones. A balance between growth and bacteriocin synthesis, both highly dependent on aeration, was taken into account for the overproduction of bacteriocin. Both glucose and glycerol were shown to be necessary for Bacthuricin F4 maximal synthesis. In addition, the optimal carbon/nitrogen ratio for bacteriocin production is 9. In such optimal conditions, more than 4-fold greater bacteriocin production was obtained than when using TSB medium.