Characterization of antagonistic and acid formation properties of Lactobacillus casei

Cultural, morphologic, and biochemical characteristics of Lactobacillus casei were studied as well as their acid-forming and antagonistic activity and resistance to antibiotics. 60 cultures identified as L. caseiwere isolated from 250 samples of sour-milk products and clinical specimens. All isolated strains had respectively high antagonistic activity regardless of their source. Dependence between antagonistic activity and acid formation was not detected. Conclusion about promise for using these lactobacilli for manufacturing of probiotics has been done.     

Production of lactic acid from soybean stalk hydrolysate with Lactobacillus sake and Lactobacillus casei

In order to make full use of soybean stalk produced in large quantity annually in China, a process is proposed for production of lactic acid from soybean stalk hydrolysate with Lactobacillus sake and Lactobacillus casei. Experiments were conducted using the proposed process and experimental results indicate that the potential of 242 mg (g stalk)⁻¹ fermentable sugar is released from hydrolysate through enzymatic saccharication with a saccharication of 51%. The main sugar released from pretreated soybean stalk through enzymatic hydrolysis was a mixture of glucose, xylose and cellobiose at a ratio of 3.9:1.7:1. Fermentation of soybean stalk hydrolysate by L. sake and L. casei yielded the lactic acid conversion of 48% and 56%, respectively, however, lactic acid conversion increased to 71% by co-inoculation of both strains. L. sake and L. casei were able to degrade glucose, but unable to completely assimilate xylose and cellobiose. The proposed process can be used to produce lactic acid from soybean stalk hydrolysate.     

Thymine transport in Lactobacillus casei

Abstract A transport system for thymine was investigated in a Lactobacillus casei mutant lacking thymidine phosphorylase activity (the first enzyme required for thymine utilization). Transport was dependent on an energy supply; transport was inhibited by the uncouplers carbonylcyanide-m-chlorophenylhydrazone (CCCP) and 2,4 dinitrophenol (DNP), and also by sodium azide and N,N'-dicyclohexylcarbodiimide (DCCD). Thymine transport was inhibited by some uracil and adenosine derivatives and by thymidine, but was not affected by guanosine, deoxycytidine or azacytidine. Inhibition by p-chloromercurybenzoate (PCMB) was reversed by dithiothreitol (DTT).     

Citrate metabolism in Lactobacillus casei and Lactobacillus plantarum

Information on the factors influencing citrate metabolism in lactobacilli is limited and could be useful in understanding the growth of lactobacilli in ripening cheese. Citrate was not used as an energy source by either Lactobacillus casei ATCC 393 or Lact. plantarum 1919 and did not affect the growth rate when co-metabolized with glucose or galactose. In growing cells, metabolism of citrate was minimal at pH 6 but significant at pH 4·5 and was greater in cells co-metabolizing galactose than in those co-metabolizing glucose or lactose. In non-growing cells, optimum utilization of citrate also occurred at pH 4·5 and was not increased substantially by the presence of fermentable sugars. In both growing and non-growing cells, acetate and acetoin were the major products of citrate metabolism; pyruvate was also produced by non-growing cells and was transformed to acetoin once the citrate was exhausted. Citrate was metabolized more rapidly than sugar by non-growing cells; the reverse was true of growing cells. Citrate metabolism by Lact. plantarum 1919 and Lact. casei ATCC 393 increased six- and 22-fold, respectively, when the cells were pre-grown on galactose plus citrate than when pre-grown on galactose only. This was probably due to induction of citrate lyase by growth on citrate plus sugar. These results imply that lactobacilli, if present in large enough numbers, can metabolize citrate in ripening cheese in the absence of an energy source.     

Lactic acid production from whey permeate by immobilized Lactobacillus casei

Two matrices have been assessed for their ability to immobilize Lactobacillus casei cells for lactic acid fermentation in whey permeate medium. Agar at 2% concentration was found to be a better gel than polyacrylamide in its effectiveness to entrap the bacterial cells to carry out batch fermentation up to three repeat runs. Of the various physiological parameters studied, temperature and pH were observed to have no significant influence on the fermentation ability of the immobilized organism. A temperature range of 40–50°C and a pH range of 4.5–6.0 rather than specific values, were found to be optimum when fermentation was carried out under stationary conditions. In batch fermentation ～90% conversion of the substrate (lactose) was achieved in 48 h using immobilized cell gel cubes of 4 × 2 × 2 mm size, containing 400 mg dry bacterial cells per flask and 4.5% w/v (initial) whey lactose content as substrate. However, further increase in substrate levels tested (>4.5% w/v) did not improve the process efficiency. Supplementation of Mg²⁺ (1 mM) and agricultural by-products (mustard oil cake, 6%) in the whey permeate medium further improved the acid production ability of the immobilized cells under study.     

Lactobacillus casei combats acid stress by maintaining cell membrane functionality

Lactobacillus casei strains have traditionally been recognized as probiotics and frequently used as adjunct culture in fermented dairy products where lactic acid stress is a frequently encountered environmental condition. We have investigated the effect of lactic acid stress on the cell membrane of L. casei Zhang [wild type (WT)] and its acid-resistant mutant Lbz-2. Both strains were grown under glucose-limiting conditions in chemostats; following challenge by low pH, the cell membrane stress responses were investigated. In response to acid stress, cell membrane fluidity decreased and its fatty acid composition changed to reduce the damage caused by lactic acid. Compared with the WT, the acid-resistant mutant exhibited numerous survival advantages, such as higher membrane fluidity, higher proportions of unsaturated fatty acids, and higher mean chain length. In addition, cell integrity analysis showed that the mutant maintained a more intact cellular structure and lower membrane permeability after environmental acidification. These results indicate that alteration in membrane fluidity, fatty acid distribution, and cell integrity are common mechanisms utilized by L. casei to withstand severe acidification and to reduce the deleterious effect of lactic acid on the cell membrane. This detailed comparison of cell membrane responses between the WT and mutant add to our knowledge of the acid stress adaptation and thus enable new strategies to be developed aimed at improving the industrial performance of this species under acid stress.     

Protective effect of lipoteichoic acid from Lactobacillus casei and Lactobacillus fermentum against Pseudomonas aeruginosa in mice

Lipoteichoic acid (LTA) from Lactobacillus casei YIT 9018 or Lactobacillus fermentum YIT 0159 augmented the resistance of C57BL/6 mice to infection with Pseudomonas aeruginosa, but conferred no resistance to Listeria monocytogenes. It is suggested that LTA was unable to activate macrophages.     

Biosynthesis of D-alanyl-lipoteichoic acid in Lactobacillus casei: D-alanyl-lipophilic compounds as intermediates

D-Alanyl-lipoteichoic acid (D-alanyl-LTA) from Lactobacillus casei contains a poly(glycerol phosphate) moiety that is selectively acylated with D-alanine ester residues. To characterize further the mechanism of D-alanine substitution, intermediates were sought that participate in the assembly of this LTA. From the incorporation system utilizing either toluene-treated cells or a combination of membrane fragments and supernatant fraction, a series of membrane-associated D-[14C]alanyl-lipophilic compounds was found. The assay of these compounds depended on their extractability into monophasic chloroform-methanol-water (0.8:3.2:1.0, vol/vol/vol) and subsequent partitioning into chloroform. Four lines of evidence suggested that the D-alanyl-lipophilic compounds are intermediates in the synthesis of D-alanyl-LTA. First, partial degradation of the poly(glycerol phosphate) moiety of D-alanyl-LTA by phosphodiesterase II/phosphatase from Aspergillus niger generated a series of D-alanyl-lipophilic compounds similar to those extracted from the toluene-treated cells during the incorporation of D-alanine. Second, enzymatic degradation of the D-alanyl-lipophilic compounds by the above procedure gave D-alanyl-glycerol, the same degradation product obtained from D-alanyl-LTA. Third, the incorporation of D-alanine into these compounds required the same components as the incorporation of D-alanine into membrane-associated D-alanyl-LTA. Fourth, the phosphate-induced loss of D-[14C]alanine-labeled lipophilic compounds could be correlated with the stimulation of phosphatidylglycerol synthesis in the presence of excess phosphate. We interpreted these experiments to indicate that the D-alanyl-lipophilic compounds are D-alanyl-LTA with short polymer chains and are most likely intermediates in the assembly of the completed polymer, D-alanyl-LTA.     

Protoplast Fusion of Lactobacillus casei

Lactobacillus casei ATCC 7469 was successfully converted to protoplasts by treatment with endo-7V-acetyl muramidase in sucrose phosphate buffer. For full hydrolysis of cell walls, a high concentration of sucrose and a cold shock were necessary. Mg²⁺ ions enhanced the stability of protoplasting cells. The cell wall regeneration of protoplasts was more effective on gelatin-induced regeneration medium than with the soft overlay method. The optimal concentration of gelatin was 2.5%. The frequency of regeneration was found to be about 6% for the protoplast prepared by enzyme treatment for 20 min. The mutants having streptomycin resistance and rifampicin resistance, as selection markers for the detection of fusion, were isolated by UV irradiation and NTG treatment. These mutants were stable for at least several transfers. Protoplast fusion was carried out using PEG (50% solution of polyethyleneglycol, M.W. 6,000). The frequency of protoplast fusion was found to be about 10^-5.