A laboratory-scale system for mass culture of freshwater microalgae in polyethylene bags

A laboratory-scale system for mass culture of microalgae in 8-, 20- and 40-L polyethylene bags, was designed. Bags are 16.8 cm diameter and 52 cm (8-L bags), 112 cm (20-L) or 224 cm (40-L) length. The system was tested successfully with two freshwater microalgae,Ankistrodesmus falcatus andScenedesmus incrassatulus, cultured in Bold's Basal medium (prepared with either deionized or tap water). The procedure described is simple, reliable and practical, and enables a very cost-effective production of freshwater microalgae to satisfy any laboratory requirements, and when quantities demanded for special applications can not be met by the standard laboratory culture procedures.     

Long term lily scale bulblet storage: effects of temperature and storage in polyethylene bags

Collections of lily genotypes are usually maintained by yearly planting, harvesting and storage of the bulbs. To facilitate this maintenance, a storage method has been developed for a collection of lily genotypes, including Asiatic hybrids, Oriental hybrids, Lilium longiflorum and L. henryi. Scale bulblets were stored either dry, sealed air-tight in polyethylene bags, or in moist vermiculite in open polyethylene bags for a period of 2 yr. The decrease in mass, sprouting proportion and ion leakage or sprouting proportion alone were determined for treatments carried out at -2°C, °C and 17°C. Sealing scale bulblets in polyethylene bags at -2°C resulted in the smallest decrease in mass, the least ion leakage and the highest sprouting proportion after 2 yr of storage.     

Comparative study of hydrogel-immobilized l-glutamate oxidases for a novel thick-film biosensor and its application in food samples

Novel, thick-film biosensors have been developed for the determination of l-glutamate in foodstuffs. The sensors were prepared by immobilization of l-glutamate oxidase by using polycarbamylsulfonate-hydrogel on a thick-film sensor. l-Glutamate oxidases obtained from Streptomyces sp. with different degree of purification were compared with their characteristic response to l-glutamate at different conditions and for their specificity, inhibition, and storage properties. These sensors were applied to determine monosodium glutamate in soy sauce samples and show good correlation with colorimetric method.     

Fungal deterioration of melon seeds stored in jute sacks and polyethylene bags in Ago-Iwoye,southwestern Nigeria

Laboratory studies were carried out in the Department of Biological Sciences, Ogun State University, Ago-Iwoye, southwestern Nigeria, to determine the extent of fungal deterioration of melon seeds stored in two types of storage bags viz; jute and polyethylene bags. Melon seeds of varieties Tc139 and V2 were stored in jute and polyethylene bags under ambient conditions using the 2 × 2 factorial design (variety vs type of bag) for 12 months. The moisture content (mc), incidence of visible mouldiness (ivm) and germinability of the stored seeds were determined monthly. The mc of Tc139 ranged from 6.1 to 6.7% in jute and 6.2 to 6.5% in polyethylene bags. The ivm which was initially 2.1% increased to 10.7% and 5.5% in jute and polyethylene bags respectively, after 12 months in storage. The germination percentage decreased from 96.3% to 28.7% and 45.3% in jute and polyethylene bags, respectively. The mc of V2 stored in jute and polyethylene bags varied from 5.9 to 6.4%, and 5.8 to 6.2%, respectively. The ivm increased from 1.8% before storage to 8.9% and 4.8% in jute and polyethylene bags, respectively, after 12 months. The percentage seed germination declined from 98.0%to 37.3% in jute and 48.7% in polyethylene bags after 12 months. Decreased incidence of field fungi namely: Alternaria, Botryodiplodia theobromae, Cladosporium, Fusarium and Macrophomina phaseolina was accompanied by simultaneous increase in storage fungi viz: Aspergillus, Penicillium, and Rhizopus with prolonged storage. This revised version was published online in June 2006 with corrections to the Cover Date.     

The use of polyethylene bags in the culture and study of Striga spp. and other organisms on crop roots

A technique is described by which root parasites such as Striga and Orobanche species may be grown on the roots of suitable host plants growing on a layer of glass-fibre filter paper in a flattened, standard polyethylene bag. The single-bag units are compact, inexpensive, simple to set up and allow repeated observation without damage. Some other potential uses of the technique are described.     

Seed storage in polyethylene bags of a recalcitrant species (Quercus ilex): analysis of some bio-energetic and oxidative parameters

Some technological and physiological aspects were analysed during seed storage of holm oak (Quercus ilex L.), a typical Mediterranean recalcitrant species. Considering the mild dormancy and desiccation sensitivity of these seeds, the influence of the storage environment on viability was examined. Acorns were maintained at low temperature and at high moisture content either inside thin polyethylene bags or mixed with peat in a bin. Storage in polyethylene bags, if compared with peat treatment, maintained optimal seed quality parameters. The effects of the two treatments on some physiological parameters were analysed during 1-year seed storage. Acorns stored in a bin with peat started to germinate early and exhibited a more rapid seed deterioration caused by metabolism-linked oxidative damage. The latter phenomenon was linked to a higher respiration and H₂O₂ level, induction of catalase activity, as well as lowered glutathione pool and ATP content. In addition, a more oxidized redox poise was observed. On the contrary, the plastic film of polyethylene, limiting gaseous exchanges, maintained acorn metabolic activity at low levels and allowed the accumulation of ethylene inside the storage atmosphere. These factors, inducing a dormant-like state, could have played a crucial role in prolonging seed storage.     

Preparation and characterization of thick-film Ni/MH battery

Using the porous polypropylene (PP) films sputtered with gold and the Ni as current collectors, the electroactive materials (Ni(OH)2 and metal hydride (MH)) of positive and negative electrodes were prepared on the current collector using thick-film technology. Two types of cell configurations were prepared and the characteristics of these batteries were compared. The cycle number for the formation of batteries based on the porous PP film was found to be 2, which was significantly less than that of batteries based on the ceramic substrates. Using the porous PP film as substrate, the number of cycles for the formation of battery increased from 2 to 5 with the increase of the charge/discharge rate from 0.1C/0.025C to 2.0C/0.5C. The silver oxides dendrites formed by the oxidation of silver paste used to adhere the current collectors and the conducting wires in the charge/discharge process caused a short contact between the positive and negative electrodes, which then caused the battery failure. The cycle life of the battery based on the porous PP film was found to be greater than 400 when the charge/discharge rate was 2.0C/0.5C.     

Antimicrobial activity of a nisin-activated plastic film for food packaging

AIMS: To determine the effectiveness of a packaging film coated with nisin to inhibit Micrococcus luteus ATCC 10240 in tryptone soya broth (TSB) and the microbiota of raw milk during storage. A further aim was to examine the release of nisin from the activated film. METHODS AND RESULTS: An active package, obtained from nisin-treated film, was filled with 1 l of M. luteus ATCC 10240 (ML) suspension in TSB and stored at 4 and 25 degrees C for 2 days. After 24 h at 25 degrees C there was a remarkable reduction of M. luteus ATCC 10240 compared with the control, while at 4 degrees C a slight reduction was observed. Moreover, microbial growth was controlled when 1 l of three different kinds of milk was poured into the active package and stored at 4 degrees C for 7 days. The most significant results were observed in raw milk and pasteurized milk with a reduction of 0.9 log and 1.3 log, respectively. The release experiments showed that nisin release from the film was unpredictable, but it was favoured by low pH and high temperature. CONCLUSIONS: It appears that nisin-coated films were effective in inhibiting M. luteus ATCC 10240 in TSB and the bacterial flora in milk, and the release of nisin was pH and temperature dependent. SIGNIFICANCE AND IMPACT OF THE STUDY: Nisin-activated film may control bacterial growth, maintaining food quality, safety and extending the shelf-life of food products.     

Simultaneous Monitoring of Phosphine and of Phosphorus Species in Taihu Lake Sediments and Phosphine Emission from Lake Sediments

Phosphine (PH₃) was monitored in the Taihu Lake in China by a GC/NPD method, coupled with cryo-trapping enrichment technology. Results showed that PH₃ was universally detected in sediments, lake water and atmosphere of the Taihu Lake area. Total phosphorus (TP_s) and fractions of different phosphorus species in lake sediments were separately measured as dissolved phosphate (DP), phosphorus bound to aluminum (Al-P), iron (Fe-P) and calcium (Ca-P), occluded phosphorus (OP), and organic phosphorus (Org-P) by sequential chemical extraction. High PH₃ levels were correlated with high TP_s values in sediments and with eutrophication at different sites. In addition, a positive linear correlation equation was obtained between the concentrations of PH₃ in lake sediments and of the phosphorus fractions. The resulting multiple linear regression equation is PH₃ = −165 + 63.3 DP + 0.736 Al-P + 2.33 Ca-P + 2.29 Org-P. The flux of PH₃ across the sediment–water interface was estimated from sediment core incubation in May and October 2002. The annual average sediment–water flux of PH₃ was estimated at ca. 0.0138±0.005 pg dm⁻² h⁻¹, the average yearly emission value of PH₃ from Taihu Lake sediments to water was calculated to be 28.3±10.2 g year⁻¹, which causes a water PH₃ concentration of up to 0.178±0.064 pmol dm⁻³. The real importance of PH₃ could be higher, because PH₃ could be consumed in the oxic sediment–water boundary layer and in the water column. Spatial and temporal distributions of total phosphorus (TP_w) and chlorophyll a (Chl-a) in the water column of Taihu Lake were measured over the study period. Higher water PH₃ has also been found where the TP_w content was high. Similarly, high Chl-a was consistent with higher water PH₃. Positive relationships between PH₃ and TP_w (average R² = 0.47±0.26) and Chl-a (average R² = 0.23±0.31) were observed in Taihu Lake water.     

Usefulness of an aluminized polyester film for reducing heat in polyethylene calf hutches

This study determined the efficacy of a radiant barrier material used in the construction industry to moderate summer temperatures in polyethylene calf hutches. The cover consisted of a single layer of two-sided reflective aluminized polyester film with a center polyester scrim reinforcement (reflectivity?=?95 %). At each of two dairies, six hutches containing a young calf were either uncovered (control) or had reflective covers across the top and sides of the hutch, leaving the front, back, and 1.2?×?1.8-m attached outdoor wire pen exposed. Duplicate loggers mounted 20 cm above the flooring in the center of each hutch recorded interior temperature at 30-min intervals over 22 days during late August to early September. The mean daily interior peak temperatures in each of the hutches over 21 days of observation were significantly less (P?P?=?0.77) between dairies. The mean daily interior peak temperatures in each of the hutches over the warmest 10 days of observation were significantly less (P?P?相似文献   

Physicochemical and bioactivity of cross-linked chitosan–PVA film for food packaging applications

This work aimed to develop a novel antimicrobial coating based on chitosan and PVA to evaluate its effect on minimally processed tomato by means of microbiological analyses. In this report an antimicrobial film was prepared by blending chitosan (CS) and poly(vinyl alcohol) (PVA) with glutaraldehyde as the cross-linker. The miscibility and morphology of the film were investigated by X-ray diffraction (XRD) and scanning electron microscopy (SEM). The thermal property of the chitosan–PVA film was examined by differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA). The microbiological screening has demonstrated the antimicrobial activity of the film against food pathogenic bacteria viz. Escherichia coli, Staphylococcus aureus, and Bacillus subtilis. The obtained results indicate the film may be a promising material for food packaging applications.     

Reuse of peat bags for tomatoes and cucumbers

Summary Growing tomatoes in low humified Sphagnum peat gave satisfactory results when using the peat bags in three successive seasons without any sterilization. Use of a complete nutrient solution showed an increase of phosphorus and boron from one season to the next. The pH varied with the electrical conductivity in the peat, dependent on the nutrient concentration used. The solution used for reused peat should have a lower content of phosphorus and boron compared to a solution used for one season peat.The air capacity is high and have to be considered as optimal also in reused peat. The effect of reusing the peat on physical properties as porosity and pore size distribution is therefore of no practical significance.     

Soil bacterial strains able to grow on the surface of oxidized polyethylene film containing prooxidant additives

Twelve bacterial strains able to adsorb and grow on the surface of oxidized low-density polyethylene film containing prooxidant additives were isolated from three forest soils and subsequently identified. Most of them belonged to different genera of the proteobacteria group; however, three of the isolates were Rhodococcus strains. With the exception of one of the Rhodococcus strains, the isolates did not exhibit significant hydrophobicity of their cell surfaces. The study showed that bacteria capable of adhering to the surface of oxidized polyethylene, growing there and possibly biodegrading its oxidation products are not rare in forest soils and that they belong to different taxonomical groups common in soil environment.     

Environmental impacts of conventional plastic and bio-based carrier bags

Background, aim, and scope  

The use of bio-based products as carrier bags, packaging materials, and many other applications has been increasingly replacing conventional polymer products. One of the main driving forces of bio-plastic applications is the perceived depletion and scarcity of fossil fuels, especially petroleum. However, despite being introduced as an environmentally friendly alternative to plastics made from crude oil, the environmental benefits of bio-plastics remain debatable. This article serves to investigate whether or not bio-based materials are environmentally friendlier options compared to plastics and attempts to explain the rationale of the results.