Novel hydrophobic standards for membrane protein molecular weight determinations via sodium dodecyl sulfate-polyacrylamide gel electrophoresis

Sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) is a universally employed technique that separates proteins on the basis of molecular weight (MW). However, membrane proteins are known to size anomalously on SDS-PAGE calibrated with conventional standards, an issue that complicates interpretation of protein identity, purity, degradation, and/or stoichiometry. Here we describe the preparation of novel polyleucine hydrophobic standards for SDS-PAGE that reduce the average deviation of the apparent MW from the formula MW of natural membrane proteins to 7% versus 20% with commercially available standards. Our results suggest that gel calibration with hydrophobic standards may facilitate the interpretation of membrane protein SDS-PAGE experiments.     

Prefractionation of protein samples for proteome analysis by sodium dodecyl sulfate-polyacrylamide gel electrophoresis

To isolate high molecular weight (HMW) or low-abundance proteins we exploited the high resolving power provided by the molecular sieves of polyacrylamide gel matrices. Rice-leaf protein extracts were applied to a single well of an SDS-polyacrylamide gel with prestained molecular size markers at both ends. After electrophoresis, the gel was cut into 4 segments according to size, and each segment was ground in extraction buffer. The eluted proteins were separated from the gel matrix by centrifugation followed by acetone precipitation, and the precipitated proteins were subjected to SDS-PAGE and 2-DE. The SDS-PAGE-based prefractionation method provided non-overlapping discrete sample pools. About 27% more protein spots were detected in the fractionated samples than in the unfractionated samples, and 17% were enhanced. The improvement was especially prominent in the case of HMW proteins. Well-separated HMW proteins were analyzed by MALDI-TOF mass spectrometry. The molecular masses of the identified proteins in the > 48 kDa gel segment were distributed between 50 and 112 kDa, thus validating this prefractionation method. Identified HMW proteins with similar mass but different pI were mostly isoforms. Thus SDS-PAGE-based size prefractionation provides improved separation and detection of HMW proteins.     

An evaluation of sodium dodecyl sulfate-polyacrylamide gel electrophoresis for the identification of microsporidia

Microsporidian spore polypeptides separated with sodium dodecyl sulfate (SDS)-polyacrylamide gel electrophoresis (PAGE) can be used to identify isolates of microsporidia. The spore polypeptides separated with SDS/PAGE provided unique, reproducible electrophoretic profiles which were not influenced by host species or the temperature at which the host larvae were maintained for development. Furthermore, host proteins were not detected in electrophoretic profiles of the spore polypeptides. Spore mixtures of two microsporidian species can be detected when the spore polypeptides of either or both species have been previously separated with SDS/PAGE.     

One-step casting of Laemmli discontinued sodium dodecyl sulfate-polyacrylamide gel electrophoresis gel

A modified Laemmli sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) protocol is described. The new method saves 30 min for gel casting without loss of the resolution power of Laemmli gel. In this method, both the upper and lower gels can be cast at the same time because the lower gel contains 10% glycerol, which generates higher density in the lower gel than in the upper gel.     

Extraction of proteins for sodium dodecyl sulfate-polyacrylamide gel electrophoresis from protease-rich plant tissues

A method of extracting proteins for sodium dodecyl sulfate-polyacrylamide gel electrophoresis from plant tissues with high protease activity was described. It resolved protein bands in highmolecular-weight regions of the gel and replaced commonly used procedures which showed severe degradation of proteins, even in the presence of protease inhibitors.     

Mobility of acetylated histones in sodium dodecyl sulfate-polyacrylamide gel electrophoresis

We describe an altered mobility for acetylated histone isoforms in sodium dodecyl sulfate-polyacrylamide gel electrophoresis. Isoforms of histones H3 and H4 with a higher acetylation degree have a slightly faster electrophoretic mobility. Since acetylation neutralizes the positive charge of the epsilon-amino group of lysine, without significantly changing the molecular mass of the protein, the acetylation-dependent mobility shift could be explained by the increase of the net negative charge of the SDS-histone complexes. A possible consequence of this differential mobility for the acetylation site determination by protein microsequencing from SDS gels is discussed.     

Comparative analysis of protein aggregates by blue native electrophoresis and subsequent sodium dodecyl sulfate-polyacrylamide gel electrophoresis in a three-dimensional geometry gel

We describe the comparative analysis of protein aggregates by combining blue native electrophoresis and subsequent sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) using a 3-D geometry gel for simultaneous processing of many samples. The first native electrophoresis step, separating the aggregates, is carried out for a series of samples in parallel lanes within a slab gel. This gel is then placed on the top surface of a cylindrical, 3-D geometry gel for the second denaturing electrophoresis step, separating the proteins composing the aggregates. The samples migrate parallel to the vertical axis of the gel cylinder. Data are acquired online by photodetection of laser-induced fluorescence during electrophoresis. For this purpose, the samples are fluorescently labeled within the slab gel after the first separation step. A 3-D geometry gel separates the equivalent of many conventional SDS slab gels represented by vertical layers in the 3-D gel body. In this way, many samples are analyzed in the same gel under identical conditions, improving comparability and resolution and making the process considerably more efficient. This novel technique allowed the identification of several aggregate classes of recombinant proteins expressed in bacteria. We observed that proteins preferentially bind to homolog polypeptides, but also seem to form a trapping mesh co-aggregating with other proteins. The aggregation pattern revealed by this technique supplements data obtained from standard two-dimensional gel electrophoresis analysis. We expect interesting applications, for instance in aggregate monitoring of clinical samples. It should be feasible to quickly gain a diagnostic picture during amyloid-related neurodegenerative disease development or to observe drug effects on protein aggregation.     

An improved method for separation of low-molecular-weight polypeptides by electrophoresis in sodium dodecyl sulfate-polyacrylamide gel

An improved system for SDS-polyacrylamide gel electrophoresis, capable of analyzing polypeptides having molecular weights from 1500 to 100,000 (especially showing high resolving power in the 1500 to 25,000 molecular weight range) is described. The 10 to 18% linear gradient gel containing 7 M urea with an acrylamide:bisacrylamide ratio of 20:1 and the Laemmli discontinuous buffer was used. The use of the gel with a high crosslinkage ratio is shown to be effective in lowering the leakage of low-molecular-weight polypeptides from the gel. This method has facilitated rapid detection of small amounts of low-molecular-weight polypeptides in body fluids by the use of silver stain. A procedure is presented for the elimination of false bands on the gel frequently encountered during silver staining. The separation patterns of enzymatic cleavage products of proteins, uremic plasma, and urines from nephropathy patients are illustrated. This system is also applicable in the separation of lipopolysaccharides and also for the detection of phospholipids.     

Classification of Clostridium butyricum based on sodium dodecyl sulfate-polyacrylamide gel electrophoresis and pulsed-field gel electrophoresis

Eleven strains of Clostridium butyricum collected from different sources were analysed by both sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) and pulsed-field gel electrophoresis (PFGE). The strains could be classified into four groups based on their banding profiles of the proteins extracted from the cells on SDS-PAGE. Group I consisted of seven strains, and these strains were further divided into five subgroups by PFGE. The strains belonging to groups II, III, and IV on SDS-PAGE were also classified into the same II to IV groups by PFGE. These data indicate that grouping of the strains of C. butyricum can be performed by employing both SDS-PAGE and PFGE.     

Lysozyme activity in animal extracts after sodium dodecyl sulfate-polyacrylamide gel electrophoresis

1. Lysozyme activity was detected after electrophoresis in sodium dodecyl sulfate-polyacrylamide gels containing 0.2% (W/V) autoclaved Micrococcus lysodeikticus cells as substrate. 2. Lysozyme activity appeared as clear lysis zones after incubation of opaque gels at 37 degrees C in buffered Triton X-100. 3. As low as 0.1 pg of purified hen egg white lysozyme could be detected after 16 hr incubation at pH 6.5. 4. Bands with lytic activity from kidney and pancreas acetone powders, bird's egg whites and vitelline membranes, animal sera and human saliva corresponded to c-type (Mr 14,500), g-type (Mr 20,500) or both lysozymes as far as molecular weight is concerned. 5. Some extracts, like porcine kidney, exhibited more than two bands. 6. Bands with lytic activity migrating at the level of g-type lysozymes were detected in some kidney and pancreas extracts.     

Quantitative determination of overlapped proteins in sodium dodecyl sulfate-polyacrylamide gel electrophoresis

A method for resolving an overlapped polypeptide pattern of sodium dodecyl sulfate-polyacrylamide gel electrophoresis was described. The procedure was essentially a Gaussian fitting using the least squares method, and could resolve more than 20 overlapped components simultaneously. The applicability to overlapped and shouldered patterns was evaluated using practical electrophoretic data with varying amounts of mitochondrial samples. The relative contents of respective polypeptide components gave a good agreement regardless of the loaded amounts.     

Direct detection of an antimicrobial peptide ofPediococcus acidilactici in sodium dodecyl sulfate-polyacrylamide gel electrophoresis

Summary An SDS-PAGE technique is described that allows identification of the antimicrobial activity of a peptide secreted by a strain ofPediococcus acidilactici. This peptide has an antimicrobial property against several baeteria associated with food. This technique enables detection of the specific peptide (or protein) band(s) associated with the inhibitory effect which can then be eluted from the gel for further studies.Published with the approval of the Director, Wyoming Agriculture Experiment Station as Journal Article No. 1526.     

Artifacts in sodium dodecyl sulfate-polyacrylamide gel electrophoresis due to 2-mercaptoethanol

Mercaptoethanol, when present in the sample buffer during sodium dodecyl sulfate-polyacrylamide gel electrophoresis, is responsible for the appearance of two nonprotein bands (electrophoretic mobilities corresponding to 68 and 54 kdalton) stainable with silver and with Coomassie blue. After iodination in vitro of DNA preparations isolated by alkaline phenol extraction using chloramine-T procedure, part of the radioactive label is found in these bands, provided the reaction is terminated by mercaptoethanol, whereas only a diffuse background is present in this area if the reaction is stopped by sodium metabisulfite. Similar results are obtained with highly purified total cytoplasmic RNA. The results indicate that the appearance of the 68- and 54-kdalton bands is in artifact. The relevance of these results to the proteins tightly bound to DNA is discussed.     

An efficient two-dimensional sodium dodecyl sulfate-polyacrylamide gel electrophoresis method for simultaneous peptide mapping of protein contained in a mixture

A method for simultaneous peptide mapping of polypeptides contained in a mixture is presented. The polypeptides were first separated by conventional sodium dodecyl sulfate-polyacrylamide gel electrophoresis. The strip of gel containing these unstained polypeptide bands was subsequently embedded perpendicular to the direction of electrophoresis in the stacking gel of a second gel. The proteolytic enzymes, loaded on top of the second gel, were brought in contact with the substrates through moving boundary electrophoresis. The peptides thus generated were then resolved by electrophoresis in a gradient gel. A polychromatic silver staining method added an extra dimension to the identification and characterization of the peptides in the maps obtained in that specific peptides got specific colors. Moreover, the sensitivity of this method was illustrated by the demonstration that original quantities in the submicrogram range of nonradioactive proteins (exemplified here by the structural proteins of densonucleosis virus) largely sufficed for satisfactory maps. Other advantages of this procedure over current methods included (i) the elimination of the purification step (and consequently virtually no loss or contamination), (ii) that only the strict minimum of material (necessary for the ultimate visualization of the maps) had to be used, (iii) that no special two-dimensional electrophoresis equipment was needed, and (iv) the consistency, speed, and simplicity of the method.     

Electrophoretic mobility of Alzheimer's amyloid-beta peptides in urea-sodium dodecyl sulfate-polyacrylamide gel electrophoresis

The 43-amino acid Alzheimer's amyloid-beta peptide (Abeta peptide) retains a predominantly alpha-helix and beta-strand structure in sodium dodecyl sulfate (SDS) solution. This conformer has a high tendency to aggregate during conventional SDS-polyacrylamide gel electrophoresis (PAGE). Both the secondary structure and the proclivity for aggregation are obviated by the use of urea-SDS-PAGE: In 8M urea-with or without SDS-the Abeta peptide becomes 100% random coil and remains monomeric. However, during electrophoresis in this medium, the peptide and its truncated variants do not obey the law of mass/mobility relationship that most proteins-including Abeta peptides-follow in conventional SDS-PAGE. Rather, the smaller carboxy-terminally truncated peptides migrate slower than the larger full-length peptide, while the amino terminally truncated peptide does migrate faster than the full-length Abeta peptide. Thus, despite their small size (2-4kDa) and minor differences between their lengths, the Abeta peptides display a wide separation in this low-porosity (12% acrylamide) gel. We found that this unusual electrophoretic mobility in 8M urea is due to the fact that the quantity of [35S]SDS bound to the Abeta peptides, instead of being proportional to the total number of amino acids, is rather proportional to the sum of the hydrophobicity consensus indices of the constituent amino acids. It is then their hydrophobicity and, hence, the net negative charges contributed by the peptide-bound SDS that plays a major role in determining the mobility of Abeta peptides in 8M urea-SDS-PAGE. The high selectivity of the 8M urea-SDS-PAGE method allowed us to detect the presence of hitherto unknown Abeta peptide variants that were secreted in the conditioned medium by cultured HeLa cells.     

Lysozyme oligomers as a molecular mass standard for sodium dodecyl sulfate-polyacrylamide gel electrophoresis

Egg white lysozyme treated with hypochlorous acid links together producing di-, tri-, tetra-, and pentameric derivatives with molecular masses ranging from 14,300 to 90,500. Similar oligomeric products may be obtained by treating lysozyme color derivatives produced by labeling lysozyme with fluorescein, trinitrobenzenesulfonic acid and 2,4-dinitrofluorobenzene, with hypochlorous acid. The oligomeric lysozyme derivatives thus obtained consist of a mixture of proteins with molecular masses equal to multiples of 14,300 (lysozyme molecular mass). This mixture can be applied as a set of molecular mass standards suitable for determination of protein molecular masses on sodium dodecyl sulfate-polyacrylamide gel electrophoresis.