The identification of cutin synthase: formation of the plant polyester cutin

A hydrophobic cuticle consisting of waxes and the polyester cutin covers the aerial epidermis of all land plants, providing essential protection from desiccation and other stresses. We have determined the enzymatic basis of cutin polymerization through characterization of a tomato extracellular acyltransferase, CD1, and its substrate, 2-mono(10,16-dihydroxyhexadecanoyl)glycerol. CD1 has in vitro polyester synthesis activity and is required for cutin accumulation in vivo, indicating that it is a cutin synthase.     

Glycerol derivatives of cutin and suberin monomers: synthesis and self-assembly

Glycerol derivatives of cutin and suberin monomers were synthesized by acid catalysis. Their dispersion in an aqueous solution was examined by phase contrast microscopy, neutron scattering, and solid state NMR. It is shown that the phase behavior strongly depends on the nature of the derivatives forming either lumps of aggregated membranes or well dispersed membranes.     

Biosynthesis of cutin monomers: involvement of a lipoxygenase/peroxygenase pathway

Cutin is synthesized from oxygenated fatty acids derived preponderantly from oleic acid. The enzymatic pathways involved in the biosynthesis of such cutin monomers have been studied, i.e. 18-hydroxyoleic acid, 9,10-epoxy-18-hydroxystearic acid (the major constituent) and 9,10,18-trihydroxystearic acid. This was approached by studying (i) the substrate specificity and stereoselectivity of purified peroxygenase, which epoxidizes unsaturated fatty acids, and fatty acid epoxide hydrolase, i.e. two enzyme activities that have been found recently in higher plants, and (ii) the transformation of oleic acid into cutin monomers by a cell free system, i.e. soybean microsomes. These two enzymes, along with a ω-hydroxylating activity, can account for the biosynthesis of the oleic acid-derived cutin monomers and their precursors. A new biosynthetic scheme is proposed, whose pathways take into account the dynamic aspects of the expression of the different enzyme activities involved. Importantly, since peroxygenase, for its activity, is strictly dependent on fatty acid hydroperoxides, which act as co-substrates, the biosynthesis of cutin monomers is also dependent on the activity of lipoxygenases.     

Molecular characterization of the plant biopolyester cutin by AFM and spectroscopic techniques

Atomic force microscopy, FT-IR spectroscopy, and solid-state nuclear magnetic resonance have been used to improve our current knowledge on the molecular characteristics of the biopolyester cutin, the main component of the plant cuticle. After comparison of samples of cutin isolated from young and mature tomato fruit cuticles has been possible to establish different degrees of cross-linking in the biopolymer and that the polymer is mainly formed after esterification of secondary hydroxyl groups of the monomers that form this type of cutin. Atomic force microscopy gave useful structural information on the molecular topography of the outer surface of the isolated samples. The texture of these samples is a consequence of the cross-linking degree or chemical status of the polymer. Thus, the more dense and cross-linked cutin from ripe or mature tomato fruit is characterized by a flatter and more globular texture in addition to the development of elongated and orientated superstructures.     

ByDioscorea deltoidea free and immobilized plant cells

Summary 2-(4-methoxybenzyl)-1-cyclohexanone (1) was converted to its glucoside (4,5) via corresponding alcohols (3,4) usingDioscorea deltoidea Wall. free and immobilized plant cells.     

Evaluation of unbound free heme in plant cells by differential acetone extraction

Heme functions not only as a prosthetic group of hemoproteins but also as a regulatory molecule, suggesting the presence of 'free' heme. Classically, total non-covalently bound heme is extracted from plant samples with acidic acetone after removal of pigments with basic and neutral acetone. Earlier work proposed that free heme can be selectively extracted into basic acetone. Using authentic hemoproteins, we confirmed that acidic acetone can quantitatively extract heme, while no heme was extracted into neutral acetone. Meanwhile, a certain amount of heme was extracted into basic acetone from hemoglobin and myoglobin. Moreover, basic acetone extracted loosely bound heme from bovine serum albumin, implying that the nature of hemoproteins largely influences heme extraction into basic acetone. Using a highly sensitive heme assay, we found that basic and neutral acetone can extract low levels of heme from plant samples. In addition, neutral acetone quantitatively extracted free heme when it was externally added to plant homogenates. Furthermore, the level of neutral acetone-extractable heme remained unchanged by precursor (5-aminolevulinic acid) feeding, while increased by norflurazon treatment which abolishes chloroplast biogenesis. However, changes in these heme levels did not correlate to genomes uncoupled phenotypes, suggesting that the level of unbound free heme would not affect retrograde signaling from plastids to the nucleus. The present data demonstrate that the combination of single-step acetone extraction following a sensitive heme assay is the ideal method for determining total and free heme in plants.     

ABCG transporters export cutin precursors for the formation of the plant cuticle

1. Download : Download high-res image (193KB)
2. Download : Download full-size image

     

A functional cutin matrix is required for plant protection against water loss

The plant cuticle, a cutin matrix embedded with and covered by wax, seals the aerial organ''s surface to protect the plant against uncontrolled water loss. The cutin matrix is essential for the cuticle to function as a barrier to water loss. Recently, we identified from wild barley a drought supersensitive mutant, eibi1, which is caused by a defective cutin matrix as the result of the loss of function of HvABCG31, an ABCG full transporter. Here, we report that eibi1 epidermal cells contain lipid-like droplets, which are supposed to consist of cutin monomers that have not been transported out of the cells. The eibi1 cuticle is fragile due to a defective cutin matrix. The rice ortholog of the EIBI1 gene has a similar pattern of expression, young shoot but not flag leaf blade, as the barley gene. The model of the function of Eibi1 is discussed. The HvABCG31 full transporter functions in the export of cutin components and contributed to land plant colonization, hence also to terrestrial life evolution.Key words: ABC transporter, cuticle, cuticular wax, drought resistance, inclusion     

Self-assembled polyhydroxy fatty acids vesicles: a mechanism for plant cutin synthesis

Despite its biological importance, the mechanism of formation of cutin, the polymeric matrix of plant cuticles, has not yet been fully clarified. Here, for the first time, we show the participation in the process of lipid vesicles formed by the self-assembly of endogenous polyhydroxy fatty acids. The accumulation and fusion of these vesicles (cutinsomes) at the outer part of epidermal cell wall is proposed as the mechanism for early cuticle formation.     

A combined micro-and semi-micro colorimetric determination of long-chain fatty acids from plant cutin

Summary Re-examination of the colorimetric fatty acid determination with copper nitrate, followed by complex formation with DIECA has shown that the method is not reliable if applied as described by Duncombe (1962, 1963): The Cu concentration is too high, the DIECA concentration much too low and the wavelength chosen (440 m) is suitable only for very low fatty acid concentrations.According to the results reported here the following alterations have to be adopted: The concentration of the copper nitrate solution should be 3%, a 0.5% solution of DIECA in butanol has to be used and measurements should be done at 492 m. The method described here offers the opportunity to determine fatty acid concentrations in the semi-micro range by measuring the filtered chloroform phase directly at 691 m, covering a range between 175 g/ml to 1.2 mg/ml. If the concentration turns out to be lower than 200 g F. A./ml, the same sample can be used for a micro-determination (up to 200 g/ml) at 492 m, after formation of the yellowish-brown complex by addition of 0.1 ml 0.5% butanolic DIECA solution to 1.0 ml of the chloroform phase.The method has been applied to determine the amount of free F. A. in cutin layers and cutin powder, revealing that the latter contains 5.6 times more free F. A. than the intact material. The free F. A. within the polymer seem to serve as interconnections for the main units of the cutin polylipid.     

Radiation stimulated increase of plating efficiency of free plant cells

Summary Radiation induced stimulation of plating efficiency of free plant cells was observed following irradiation with X-rays (1.25 Gy, dose rate 3.1 Gy.nin^–1) and fission neutrons (1.5 Gy, dose rate 0.05 Gy.nin^–1). The dose range where the radiation stimulation effect is manifest is inversely correlated with the applied dose rate.The results are discussed in view of the radiation induced stimulation as it is applied in agricultural practice.     

Perception and modification of plant flavonoid signals by rhizosphere microorganisms

Flavonoids are a diverse class of polyphenolic compounds that are produced as a result of plant secondary metabolism. They are known to play a multifunctional role in rhizospheric plant-microbe and plant-plant communication. Most familiar is their function as a signal in initiation of the legume-rhizobia symbiosis, but, flavonoids may also be signals in the establishment of arbuscular mycorrhizal symbiosis and are known agents in plant defence and in allelopathic interactions. Flavonoid perception by, and impact on, their microbial targets (e.g. rhizobia, plant pathogens) is relatively well characterized. However, potential impacts on 'non-target' rhizosphere inhabitants ('non-target' is used to distinguish those microorganisms not conventionally known as targets) have not been thoroughly investigated. Thus, this review first summarizes the conventional roles of flavonoids as nod gene inducers, phytoalexins and allelochemicals before exploring questions concerning 'non-target' impacts. We hypothesize that flavonoids act to shape rhizosphere microbial community structure because they represent a potential source of carbon and toxicity and that they impact on rhizosphere function, for example, by accelerating the biodegradation of xenobiotics. We also examine the reverse question, 'how do rhizosphere microbial communities impact on flavonoid signals?' The presence of microorganisms undoubtedly influences the quality and quantity of flavonoids present in the rhizosphere, both through modification of root exudation patterns and microbial catabolism of exudates. Microbial alteration and attenuation of flavonoid signals may have ecological consequences for below-ground plant-microbe and plant-plant interaction. We have a lack of knowledge concerning the composition, concentration and bioavailability of flavonoids actually experienced by microbes in an intact rhizosphere, but this may be addressed through advances in microspectroscopic and biosensor techniques. Through the use of plant mutants defective in flavonoid biosynthesis, we may also start to address the question of the significance of flavonoids in shaping rhizosphere community structure and function.     

A protein kinase from Colletotrichum trifolii is induced by plant cutin and is required for appressorium formation

When certain phytopathogenic fungi contact plant surfaces, specialized infection structures (appressoria) are produced that facilitate penetration of the plant external barrier; the cuticle. Recognition of this hydrophobic host surface must be sensed by the fungus, initiating the appropriate signaling pathway or pathways for pathogenic development. Using polymerase chain reaction and primers designed from mammalian protein kinase C sequences (PKC), we have isolated, cloned, and characterized a protein kinase from Colletotrichum trifolii, causal agent of alfalfa anthracnose. Though sequence analysis indicated conserved sequences in mammalian PKC genes, we were unable to induce activity of the fungal protein using known activators of PKC. Instead, we show that the C. trifolii gene, designated LIPK (lipid-induced protein kinase) is induced specifically by purified plant cutin or long-chain fatty acids which are monomeric constituents of cutin. PKC inhibitors prevented appressorium formation and, to a lesser extent, spore germination. Overexpression of LIPK resulted in multiple, abnormally shaped appressoria. Gene replacement of lipk yielded strains which were unable to develop appressoria and were unable to infect intact host plant tissue. However, these mutants were able to colonize host tissue following artificial wounding, resulting in typical anthracnose lesions. Taken together, these data indicate a central role in triggering infection structure formation for this protein kinase, which is induced specifically by components of the plant cuticle. Thus, the fungus is able to sense and use host surface chemistry to induce a protein kinase-mediated pathway that is required for pathogenic development.     

Perception of plant volatile blends by herbivorous insects--finding the right mix

Volatile plant secondary metabolites are detected by the highly sensitive olfactory system employed by insects to locate suitable plants as hosts and to avoid unsuitable hosts. Perception of these compounds depends on olfactory receptor neurones (ORNs) in sensillae, mostly on the insect antennae, which can recognise individual molecular structures. Perception of blends of plant volatiles plays a pivotal role in host recognition, non-host avoidance and ensuing behavioural responses as different responses can occur to a whole blend compared to individual components. There are emergent properties of blend perception because components of the host blend may not be recognised as host when perceived outside the context of that blend. Often there is redundancy in the composition of blends recognised as host because certain compounds can be substituted by others. Fine spatio-temporal resolution of the synchronous firing of ORNs tuned to specific compounds enables insects to pick out relevant host odour cues against high background noise and with ephemeral exposure to the volatiles at varying concentrations. This task is challenging as they usually rely on ubiquitous plant volatiles and not those taxonomically characteristic of host plants. However, such an odour coding system has the advantage of providing flexibility; it allows for adaptation to changing environments by alterations in signal processing while maintaining the same peripheral olfactory receptors.