Genetic variability under mutation selection balance

A fundamental problem in evolutionary genetics is understanding how high levels of genetic variation in quantitative traits are maintained in natural populations. Variation is removed by the natural selection of individuals with optimal phenotypes and is recovered by mutation; however, previous analyses had indicated that a mutation-selection balance was insufficient to maintain observed levels of genetic variation in these traits. Using more general models, however, it has recently been shown that it is indeed a sufficient mechanism. These models can be used to explore other phenomena in evolutionary biology.     

A comparison of genetic variability in strains of Japanese quail selected for heavy body weight.

Electrophoretic analyses of body tissues from three strains of Japanese quail from the Quail Genetic Stock Centre at the University of British Columbia, two selected for heavy body weight and one randombred, were carried out to determine whether genetic variations in selected strains were different from randombred strains. In addition, the data were also compared with those obtained from domestic and wild populations in Japan. The proportion of polymorphic loci was higher in the heavy strains than in the randombred strain. The selected strains also differed from the randombred strain in the allelic frequencies of liver esterase and phosphogluconate dehydrogenase. While the randombred strain was genetically similar to the domestic strains in Japan, the two selected strains were different from each other and from the domestic strains in Japan. This indicates that (1) polymorphic loci have adaptive importance, and (2) heavy body weight can be achieved by separate genetic mechanisms. A previously unreported allele that affects the migration pattern of muscle adenylate kinase was also discovered in one of the selected strains.     

Genetic variability and advance under four selection procedures in wheat pedigree breeding programme

Summary Four methods of generation advance (SPS, SSD, BP and MMS) were compared in F₃ and F₄ generations. In the F₃ generation, the SPS and SSD methods of generation advance proved superior to the BP and MMS methods for grain yield per plant and for at least one of the yield component traits. The F₃ SSD population did not differ significantly from the F₃ SPS for any of the traits. However, the F₃ SSD population retained more range and cv for different traits than with other methods of generation advance. F₄ progenies derived from F₃ SSD population were significantly superior for grain yield than lines derived from the other three F₃ populations. The MMS method of generation advance proved useful for increasing the 1,000-grain weight for which initial selection was made.Part of Ph.D. Thesis submitted by senior author to Haryana Agricultural University, Hisar     

The relationship between nephron number,kidney size and body weight in two inbred mouse strains

While some reports in humans have shown that nephron number is positively correlated with height, body weight or kidney weight, other studies have not reproduced these findings. To understand the impact of genetic and environmental variation on these relationships, we examined whether nephron number correlates with body weight, kidney planar surface area, or kidney weight in two inbred mouse strains with contrasting kidney sizes but no overt renal pathology: C3H/HeJ and C57BL/6J. C3H/HeJ mice had smaller kidneys at birth and larger kidneys by adulthood, however there was no significant difference in nephron number between the two strains. We did observe a correlation between kidney size and body weight at birth and at adulthood for both strains. However, there was no relationship between nephron number and body weight or between nephron number and kidney size. From other studies, it appears that a greater than 2-fold variation is required in each of these parameters in order to demonstrate these relationships, suggesting they are highly dependent on scale. Our results are therefore not surprising since there was a less than 2-fold variation in each of the parameters examined. In summary, the relationship between nephron number and body or kidney size is most likely to be demonstrated when there is greater phenotypic variation either from genetic and/or environmental factors.     

The relationship between nephron number, kidney size and body weight in two inbred mouse strains

While some reports in humans have shown that nephron number is positively correlated with height, body weight or kidney weight, other studies have not reproduced these findings. To understand the impact of genetic and environmental variation on these relationships, we examined whether nephron number correlates with body weight, kidney planar surface area, or kidney weight in two inbred mouse strains with contrasting kidney sizes but no overt renal pathology: C3H/HeJ and C57BL/6J. C3H/HeJ mice had smaller kidneys at birth and larger kidneys by adulthood, however there was no significant difference in nephron number between the two strains. We did observe a correlation between kidney size and body weight at birth and at adulthood for both strains. However, there was no relationship between nephron number and body weight or between nephron number and kidney size. From other studies, it appears that a greater than two-fold variation is required in each of these parameters in order to demonstrate these relationships, suggesting they are highly dependent on scale. Our results are therefore not surprising since there was a less than two-fold variation in each of the parameters examined. In summary, the relationship between nephron number and body or kidney size is most likely to be demonstrated when there is greater phenotypic variation either from genetic and/or environmental factors.     

Genetic parameters related to environmental variability of weight traits in a selection experiment for weight gain in mice; signs of correlated canalised response

Data from an experimental mice population selected from 18 generations to increase weight gain were used to estimate the genetic parameters associated with environmental variability. The analysis involved three traits: weight at 21 days, weight at 42 days and weight gain between 21 and 42 days. A dataset of 5273 records for males was studied. Data were analysed using Bayesian procedures by comparing the Deviance Information Criterion (DIC) value of two different models: one assuming homogeneous environmental variances and another assuming them as heterogeneous. The model assuming heterogeneity was better in all cases and also showed higher additive genetic variances and lower common environmental variances. The heterogeneity of residual variance was associated with systematic and additive genetic effects thus making reduction by selection possible. Genetic correlations between the additive genetic effects on mean and environmental variance of the traits analysed were always negative, ranging from -0.19 to -0.38. An increase in the heritability of the traits was found when considering the genetic determination of the environmental variability. A suggested correlated canalised response was found in terms of coefficient of variation but it could be insufficient to compensate for the scale effect associated with an increase of the mean.     

Genetic variation in growth and development time under two selection regimes in Leptinotarsa decemlineata

It is possible to predict the potential range of a species on the basis of its ecological characteristics and those of the invaded ecosystem. The existence of genetic variation indicates a species’ potential to respond to new environmental conditions, thus facilitating its success as an invader. Accordingly, evolutionary and ecological approaches are needed to identify the factors explaining both species’ range and their potential to invade new areas. We combined these two approaches and studied whether genetic variation in life‐history traits under abiotic (temperature) and biotic (host plant) selection pressures contributes to the potential range expansion of Leptinotarsa decemlineata Say (Coleoptera: Chrysomelidae). We reared full‐sib families of L. decemlineata from the current northernmost European population at 15 °C (temperature below that in the current range) and 25 °C (optimal temperature) and on three potato varieties. We monitored development time, adult weight and larval‐to‐adult survival, and estimated the amount of heritable variance. The development time and adult weight of progenies were more variable between than within families. Thus, there was genetic variability in traits relevant to the ability to adapt to a colder environment (i.e., accelerate development and become heavier) allowing range expansion further north in Europe, even though low temperature increased beetle mortality. Temperature strongly affected all traits measured. Potato variety, in turn, did not strongly affect beetles’ performance. Beetle ability to adapt to a cool environment was further enhanced by the fact that size was not constrained by fast development. The results showed that beetle populations possess genetic variation allowing a response to temperature and thus have the evolutionary potential to adapt and spread beyond their current range.     

Genetic parameters of body weight and prolificacy in pigeons

Genetic parameters of body weight at weaning and of prolificacy were estimated in three commercial lines of pigeons selected by BLUP (Best Linear Unbiased Prediction) on both traits. The model of analysis took into account the direct genetic effects for both traits and the effect of parental permanent environment for body weight. Depending on the line considered, body weight varied from 556.7 g to 647.6 g and prolificacy ranged from 12.5 to 16.8 pigeons weaned per couple of parents per year. Heritability of body weight was high, varying between 0.46 and 0.60, and permanent environment was responsible for 6% to 9% of the total variability. On the contrary, prolificacy was poorly heritable (0.04 to 0.12). They were highly and negatively correlated (-0.77 to -0.82). Body weight showed significant genetic trends in lines B and C. No significant genetic difference could be observed between males and females for both traits.     

Genetic variability at neutral markers,quantitative trait land trait in a subdivided population under selection

Genetic variability in a subdivided population under stabilizing and diversifying selection was investigated at three levels: neutral markers, QTL coding for a trait, and the trait itself. A quantitative model with additive effects was used to link genotypes to phenotypes. No physical linkage was introduced. Using an analytical approach, we compared the diversity within deme (H(S)) and the differentiation (F(ST)) at the QTL with the genetic variance within deme (V(W)) and the differentiation (Q(ST)) for the trait. The difference between F(ST) and Q(ST) was shown to depend on the relative amounts of covariance between QTL within and between demes. Simulations were used to study the effect of selection intensity, variance of optima among demes, and migration rate for an allogamous and predominantly selfing species. Contrasting dynamics of the genetic variability at markers, QTL, and trait were observed as a function of the level of gene flow and diversifying selection. The highest discrepancy among the three levels occurred under highly diversifying selection and high gene flow. Furthermore, diversifying selection might cause substantial heterogeneity among QTL, only a few of them showing allelic differentiation, while the others behave as neutral markers.     

Genetic variability following selection of Haemonchus contortus with anthelmintics

Genetic diversity in nematodes leads to variation in response to anthelmintics. Haemonchus contortus shows enormous genetic diversity, allowing anthelmintic resistance alleles to be rapidly selected. Anthelmintic resistance is now a widespread problem, especially in H. contortus. Here, I compare the genes involved in anthelmintic resistance in H. contortus with those that confer susceptibility or resistance on the free living nematode Caenorhabditis elegans. I also discuss the latest knowledge of genes associated with resistance to benzimidazoles, levamisole and the macrocyclic lactones and the need for DNA markers for anthelmintic resistance.     

Genetic analyses of metabolic body weight,carcass weight and body conformation traits in Nordic dairy cattle

Improving feed efficiency in dairy cattle by animal breeding has started in the Nordic countries. One of the two traits included in the applied Saved feed index is called maintenance and it is based on the breeding values for metabolic BW (MBW). However, BW recording based on heart girth measurements is decreasing and recording based on scales is increasing only slowly, which may weaken the maintenance index in future. Therefore, the benefit of including correlated traits, like carcass weight and conformation traits, is of interest. In this study, we estimated genetic variation and genetic correlations for eight traits describing the energy requirement for maintenance in dairy cattle including: first, second and third parity MBW based on heart girth measurements, carcass weight (CARW) and predicted MBW (pMBW) based on predicted slaughter weight, and first parity conformation traits stature (ST), chest width (CW) and body depth (BD). The data consisted of 21 329 records from Finnish Ayrshire and 9 780 records from Holstein cows. Heritability estimates were 0.44, 0.53, 0.56, 0.52, 0.54, 0.60, 0.17 and 0.26 for MBW1, MBW2, MBW3, CARW, pMBW, ST, CW and BD, respectively. Estimated genetic correlations among MBW traits were strong (>0.95). Genetic correlations between slaughter traits (CARW and pMBW) and MBW traits were higher (from 0.77 to 0.90) than between conformation and MBW traits (from 0.47 to 0.70). Our results suggest that including information on carcass weight and body conformation as correlated traits into the maintenance index is beneficial when direct BW measurements are not available or are difficult or expensive to obtain.     

Genetic analysis of sexual dimorphism of body weight in broilers

Variation in sexual dimorphism (SD) is particularly marked in meat-type chickens. This paper investigates the genetic basis of SD in an important economic trait, i.e. body weight (BW) at 35 days of age, in broilers by applying quantitative genetic analysis. A large dataset comprising 203,323 BW records of a commercial line of broiler chicken was used. First, a bivariate approach was employed treating BW as a sex-specific trait. During this approach, seven bivariate models were applied and variances due to direct additive genetic, maternal genetic and maternal environmental effects were estimated via the restricted maximum likelihood method. The best-fitting model included direct additive genetic, maternal genetic and maternal environmental effects with a direct–maternal genetic covariance. Differences between male and female direct heritabilities were non-significant (0.28 vs. 0.29 for males and females, respectively), implying no need for sex-specific selection strategies. The direct–maternal genetic correlation was more strongly negative in males than in females (?0.72 vs. ?0.56), implying a more profound antagonism between direct additive and maternal genetic effects in this particular gender. The direct genetic correlation of BW between the two sexes was as high as 0.91, i.e. only slightly lower than unity. Second, variance components and genetic parameters of two measures of SD, i.e. the weight difference (Δ) and the weight ratio (R), between the genders were estimated. Direct heritabilities for both measures were significantly different to 0 but of low magnitude (0.04). Apart from the additive–maternal covariance, no other random effects were found to be of importance for Δ and R. The results of the present study suggest that only minimal selection responses due to the selection of Δ and/or R and a small capacity for amplifying or reducing the BW differences between the sexes are to be expected in this specific population. Furthermore, selection pressure on BW is expected to amplify SD.     

Genetics of body weight in the LXS recombinant inbred mouse strains

This is the first phenotypic analysis of 75 new recombinant inbred (RI) strains derived from ILS and ISS progenitors. We analyzed body weight in two independent cohorts of female mice at various ages and in males at 60 days. Body weight is a complex trait which has been mapped in numerous crosses in rodents. The LXS RI strains displayed a large range of weights, transgressing those of the inbred progenitors, supporting the utility of this large panel for mapping traits not selected in the progenitors. Numerous QTLs for body weight mapped in single- and multilocus scans. We assessed replication between these and previously reported QTLs based on overlapping confidence intervals of published QTLs for body weight at 60 days and used meta-analyses to determine combined p values for three QTL regions located on Chromosomes 4, 5, and 11. Strain distribution patterns of microsatellite marker genotypes, weight, and other phenotypes are available on WebQTL () and allow genetic mapping of any heritable quantitative phenotype measured in these strains. We report one such analysis, correlating brain and body weights. Large reference panels of RI strains, such as the LXS, are invaluable for identifying genetic correlations, GXE (Gene X Environment) interactions, and replicating previously identified QTLs. Electronic Supplementary Material Electronic Supplementary material is available for this article at and accessible for authorised users.