Effects of surface roughness on the coefficients of friction in model orthodontic systems |
| |
Authors: | R P Kusy J Q Whitley |
| |
Institution: | Dental Research Center/Dept of Orthodontics and Biomedical Engineering, University of North Carolina, Chapel Hill 27599-7455. |
| |
Abstract: | Orthodontists, like others (Engel, P.A. (1976) Impact Wear of Materials. Elsevier Scientific, New York.), often equate the smoothness of surfaces with the absence of friction. To investigate whether the surface roughness of opposing materials influence the coefficients of friction and ultimately the movement of teeth, arch wires were slid between contact flats to simulate orthodontic arch wire-bracket appliances. From laser specular reflectance measurements, the RMS surface roughness of these arch wires varied from 0.04 microns for stainless steel to 0.23 microns for nickel titanium. Using the same technique, the roughnesses of the contact flats varied from 0.03 microns for the 1 micron lapped stainless steel, to 0.26 microns for the as-received alumina. After each of the arch wire-contact flat couples was placed in a friction tester, fifteen normal forces were systemically applied at 34 degrees C. From plots of the static and kinetic frictional forces vs the normal forces, dry coefficients of friction was obtained that were greater than those reported in the dental literature. The all-stainless steel couples had lower kinetic coefficients (0.120-0.148) than the stainless steel-polycrystalline alumina couple (0.187). When pressed against the various flats, the beta-titanium arch wire (RMS = 0.14 microns) had the highest coefficients of friction (0.445-0.658), although the nickel titanium arch wire was the roughest (RMS = 0.23 microns). Scanning electron microscopy (SEM) and energy dispersive X-ray analysis (EDX) verified that mass transfer of the beta-titanium arch wire occurred by adhesion onto the stainless steel flats or by abrasion from the sharply faceted polycrystalline alumina flats. |
| |
Keywords: | |
|
|