Frog striated muscle is permeable to hydroxide and buffer anions

Hydroxide, bicarbonate and buffer anion permeabilities in semitendinosus muscle fibers of Rana pipiens were measured. In all experiments, the fibers were initially equilibrated in isotonic, high K₂SO₄ solutions at pH _o =7.2 buffered with phosphate. Two different methods were used to estimate permeabilities: (i) membrane potential changes were recorded in response to changes in external ion concentrations, and (ii) intracellular pH changes were recorded in response to changes in external concentrations of ions that alter intracellular pH. Constant field equations were used to calculate relative or absolute permeabilities.In the first method, to increase the size of the membrane potential change produced by a sudden change in anion entry, external K⁺ was replaced by Cs⁺ prior to changes of the anion under study. At constant external Cs⁺ activity, a hyperpolarization results from increasing external pH from 7.2 to 10.0 or higher, using either CAPS (3-cyclohexylamino]-1-propanesulfonic acid) or CHES (2-N-cyclohexylamino]-ethanesulfonic acid) as buffer. For each buffer, the protonated form is a zwitterion of zero net charge and the nonprotonated form is an anion. Using reported values of H⁺ permeability, calculations show that the reduction in H⁺] _o cannot account for the hyperpolarizations produced by alkaline solutions. Membrane hyperpolarization increases with increasing total external buffer concentration at constant external pH, and with increasing external pH at constant external buffer anion concentration. Taken together, these observations indicate that both OH^– and buffer anions permeate the surface membrane. The following relative permeabilities were obtained at pH_o, 10.0± 0.3: (P_OH/P_K) = 890 ± 150, (P_CAPS/P_K) = 12 ± 2 (P_CHIES/P_K) = 5.3 ± 0.9, and (P_NO3/P_K) = 4.7 ± 0.5 P_NO/P_K was independent of pH _o up to 10.75. At pH_o = 9.6, (P_HCO3/P_K) = 0.49 ± 0.03; at pH _o = 8.9, (P_Cl/P_K) = 18± 2 and at pH _o = 7.1, (P_HEPES/P_K) = 20 ± 2.In the second method, on increasing external pH from 7.2 to 10.0, using 2.5 mm CAPS (total buffer concentration), the internal pH increases linearly with time over the next 10 min. This alkalinization is due to the entry of OH^– and the absorption of internal H⁺ by entering CAPS^– anion. The rate of CAPS^– entry was determined in experiments in which the external CAPS concentration was increased at constant external pH. Such increases invariably produced an increase in the rate of internal alkalinization, which was reversed when the CAPS concentration was reduced to its initial value. From the internal buffer power, the diameter of the fiber under study and the rates of change of internal pH, the absolute permeability for both OH^– and CAPS^– were calculated. At external pH = 10.0, the average (±sem) permeabilities were: P_OH=1.68±0.19×10^–4 cm/sec and P_CAPS=2.10±0.74×10^–6cm/sec.We conclude that OH^– is about 50 times more permeable than Cl^– at alkaline pH and that the anionic forms of commonly used buffers have significant permeabilities.This research was supported by a grant from the National Institutes of Health (AR 31814). The authors wish to thank Dr. Peter G. Shrager and Dr. Bruce C. Spalding for reading an early draft of this report and for providing helpful suggestions.