Effect of hydrophobicity degree of polymer particles on lipase immobilization and on biocatalyst performance

Abstract

Many studies describe the advantages of using hydrophobic particles on lipase immobilisation. However, many of these works neglect the effect of other variables of the supports, such as specific area and porosity, on the biocatalyst performance, and do not evaluate the influence of the hydrophobicity level of the particles on the biocatalysts’ activity as a single variable. Thus, the focus of the present work was to evaluate the effect of the hydrophobicity degree of polymeric particles on the biocatalysts’ activities, mitigating the influence of other variables. The study was divided into two steps. Firstly, distinct particles, exhibiting different composition and hydrophobicity levels, were used for the immobilization of a commercial lipase B from Candida antarctica (CAL-B). Then, distinct core-shell polymeric particles presenting different functional compounds on the surface were produced, using as comonomers styrene, divinylbenzene, 1-octene, vinylbenzoate and cardanol. Such particles were subsequently used for CAL-B immobilisation and the performance of the biocatalysts was evaluated on hydrolysis (using p-nitrophenyl laurate, as substrate) and esterification (using ethanol and oleic acid, as substrate) reactions. Based on the screening step, it was observed that for non-porous particles the correlation coefficients between the hydrophobicity level of the supports and the biocatalysts performance, for both hydrolysis and esterification reactions, were very low (0.32 and 0.45, respectively). It highlights that there was no significant correlation between these variables and that, probably, the chemical composition of the polymeric chains affects more significantly the biocatalyst performance. Then, analysing the subsequent stage, it was observed that small changes in the surface composition of the core-shell particles result in significant changes on the textural properties of the supports (specific area ranging from 1.2?m².g^?1 to 18.3?m².g^?1; and contact angles ranging from 71° (hydrophilic particles) to 92° (hydrophobic supports) when polymer films were put in contact with water). Such particles were also employed on CAL-B immobilization and it was noticed that higher correlation coefficients were achieved for hydrolysis (ρ?=?0.53) and esterification (ρ?=?0.74) reactions. Therefore, it is shown that the hydrophobicity degree of such supports starts to affect more effectively the biocatalysts performance when other textural features of the supports become more significant, such as specific area and porosity.