Improving secondary embryogenesis in <Emphasis Type="Italic">Quercus robur</Emphasis>: application of temporary immersion for mass propagation

The effects of the culture system used for embryo proliferation were investigated with the aim of improving multiplication rates and somatic embryo quality in two embryogenic lines of Quercus robur derived from mature trees (B-17 and Sainza). Embryo proliferation medium was defined following comparison of five different semi-solid media, and the highest multiplication rates (based on the total number of embryos and number of cotyledonary-shaped embryos) were achieved with medium supplemented with 0.44 μM benzyladenine for both lines. Embryo proliferation on semi-solid medium was compared with that obtained by a temporary immersion system (TIS), in which four cycles with immersion frequencies of 1 min every 6, 8, 12 or 24 h were tested. TIS promoted a significant increase in proliferated embryo biomass, with the growth index (GI) two and four times higher than in semi-solid medium in B-17 and Sainza genotypes, respectively. An immersion cycle of 1 min every 8 or 12 h produced approximately 700 somatic embryos (B-17) and 1,500 somatic embryos (Sainza) per RITA^® bioreactor, with significant differences in the latter genotype with respect to gelled medium. TIS had also a significant effect on somatic embryo synchronization as it enabled a higher production of cotyledonary embryos (90%), which represents increases of 14% (B-17) and 20% (Sainza) with respect to gelled medium. For germination of embryos proliferated in TIS two maturation systems were applied: (1) culture in semi-solid medium containing 6% sorbitol or (2) culture by TIS (without sorbitol) at a frequency of 1 min immersion every 48 h. Germination ability was higher after maturation on sorbitol medium and plantlet conversion occurred in 48% (B-17) and 13% (Sainza) embryos. TIS produced large numbers of well-developed cotyledonary embryos, hence reduced the cost and labor.