The activation by Ca of the ATPase of extracted muscle fibrils with variation of ionic strength, pH and concentration of MgATP

1. The alteration of the Ca²⁺ requirements of the ATPase activity of fibrils from rabbits and crabs at varying ionic strength, pH and concentration of MgATP (i.e. MgATP²⁻ + MgHATP⁻) was investigated.

2. Under physiological conditions, it was found that the ATPase activity of rabbit and crab fibrils after an initial increase decreased steeply when the Ca²⁺ concentration is raised above 1×10⁻⁴ M. This is a primary effect of the over-optimal Ca²⁺ concentration and not a secondary one caused by the influence of accompanying ions.

3. The Ca²⁺ requirements for ATP splitting by rabbit fibrils remain constant at an ionic strength from 0.1 to 0.2 and for a MgATP concentration in the range from 0.5 to 10 mM. At I = 0.05 it is about 5 times smaller than at 0.1. When the pH is decreased from 8 to 7, the Ca²⁺ requirements are increased some 10 times but only 3 times when the pH is varied between 7 and 6.

4. In crab fibrils, there is no alteration of the Ca²⁺ requirements when the ionic strength is varied between 0.05 and 0.2, but a reduction of the pH from 8.0 to 6.0 raises the Ca²⁺ requirements for half activation and for threshold by a factor of 10. Changing the MgATP concentration increases the Ca²⁺ requirements only in the range from 1 to 5 mM, while the concentration required in 0.5 mM is identical with that at 1 mM, and 10 mM corresponds to 5 mM.

5. It can be deduced from the experimental results that at a pH above 6.0 maximal activation is always obtained if the Ca²⁺ concentration is 5×10⁻⁵ M. By contrast, relaxation is only achieved when the Ca²⁺ concentration is below 1×10⁻⁷ M for pH 7.0 and I > 0.1 or below 1×10⁻⁸ for pH > 7.0 or I < 0.1.

6. To achieve complete relaxation, an ethyleneglycoldiaminotetraacetate (EGTA) concentration of 1 mM is sufficient, even when there is a large degree of contamination by Ca²⁺ as long as the pH stays above 6.5.