Hydraulic acclimation in a Mediterranean oak subjected to permanent throughfall exclusion results in increased stem hydraulic capacitance

Stem water storage capacity and hydraulic capacitance (C_S) play a crucial role in tree survival under drought-stress. To investigate whether C_S adjusts to increasing water deficit, variation in stem water content (StWC) was monitored in vivo for 2 years and related to periodical measurements of tree water potential in Mediterranean Quercus ilex trees subjected either to permanent throughfall exclusion (TE) or to control conditions. Seasonal reductions in StWC were larger in TE trees relative to control ones, resulting in greater seasonal C_S (154 and 80 kg m⁻³ MPa⁻¹, respectively), but only during the first phase of the desorption curve, when predawn water potential was above −1.1 MPa. Below this point, C_S decreased substantially and did not differ between treatments (<20 kg m⁻³ MPa⁻¹). The allometric relationship between tree diameter and sapwood area, measured via electrical resistivity tomography, was not affected by TE. Our results suggest that (a) C_S response to water deficit in the drought-tolerant Q. ilex might be more important to optimize carbon gain during well-hydrated periods than to prevent drought-induced embolism formation during severe drought stress, and (b) enhanced C_S during early summer does not result from proportional increases in sapwood volume, but mostly from increased elastic water.     

云雾山草坡和泾川刺槐林坡面土壤电阻率和含水率的空间差异

采用盆栽控水的方法,研究干旱胁迫（80%FC、60%FC、40%FC和20%FC）及施氮（N0 0 g·pot-1、Nl 1.2 g·pot-1、Nm 3.6 g·pot-1和Nh 6.0 g·pot-1）对麻疯树幼苗叶、茎和根部主要渗透调节物质积累的影响.结果表明： 干旱胁迫条件下,麻疯树幼苗茎和根部的游离脯氨酸、可溶性蛋白和茎部可溶性糖大量积累,叶片中脯氨酸含量也随干旱胁迫程度的增加大幅度上升;Na+、Ca2+和Mg2+在麻疯树幼苗叶、茎和根中大量积累,而K+仅在茎中大量积累,叶片和根部K+含量略微上升.施氮对植株渗透调节物质的影响与干旱胁迫强度和施氮水平有关.在80%FC和60%FC水分条件下,增加N肥施用量能明显促进麻疯树幼苗各组分渗透调节物质的积累;在40%FC水分条件下,Nh处理对渗透调节物质积累的促进作用减弱;而在20%FC条件下,Nl处理植株的渗透调节能力较高,Nm和Nh处理对植株渗透调节的促进作用不明显甚至转为抑制.     

Membrane and cytoplasmic resistivity properties of normal and sickle red blood cells

The cytoplasmic resistivities and membrane breakdown potentials of normal (AA), sickle-cell-trait (AS), and sickle (SS) red blood cells have been measured by the biophysical methodology of resistive pulse spectroscopy over a range of osmolalities. At isotonicity, the average membrane breakdown potentials are virtually identical for the three types of cells occurring at about 1150 V/cm. Average isotonic cytoplasmic resistivities are somewhat higher for the SS cells (166.7±7.49 ohm-cm) compared to the AA (147.6±1.98 ohm-cm) or AS cells (148.7±1.79 ohm-cm). As medium osmolality is varied, the differences in resistive properties become enlarged, especially at very low and very high osmolalities. At high osmolalities, both types of sickle cells show a large increase in internal resistivity compared to the normals; at low osmolality, the SS samples exhibit a distinctly different membrane breakdown characteristic, decreasing in this parameter, whereas the other two groups increase. Of the 15 SS samples tested, three displayed much higher cytoplasmic resistivities at isotonicity: 218.2±5.25 ohm-cm, compared to an average of 153.5±3.46 ohm-cm for the other 12. The relationship between these high resistivities and the subfraction of irreversibly sickled cells in the sample is discussed.     

Hydraulic connections of leaves and fruit to the parent plant in Capsicum frutescens (hot pepper) during fruit ripening

Background and Aims

The hydraulic architecture and water relations of fruits and leaves of Capsicum frutescens were measured before and during the fruiting phase in order to estimate the eventual impact of xylem cavitation and embolism on the hydraulic isolation of fruits and leaves before maturation/abscission.

Methods

Measurements were performed at three different growth stages: (1) actively growing plants with some flowers before anthesis (GS1), (2) plants with about 50 % fully expanded leaves and immature fruits (GS2) and (3) plants with mature fruits and senescing basal leaves (GS3). Leaf conductance to water vapour as well as leaf and fruit water potential were measured. Hydraulic measurements were made using both the high-pressure flow meter (HPFM) and the vacuum chamber (VC) technique.

Key Results

The hydraulic architecture of hot pepper plants during the fruiting phase was clearly addressed to favour water supply to growing fruits. Hydraulic measurements revealed that leaves of GS1 plants as well as leaves and fruit peduncles of GS2 plants were free from significant xylem embolism. Substantial increases in leaf petiole and fruit peduncle resistivity were recorded in GS3 plants irrespective of the hydraulic technique used. The higher fraction of resistivity measured using the VC technique compared with the HPFM technique was apparently due to conduit embolism.

Conclusions

The present study is the first to look at the hydraulics of leaves and fruits during growth and maturation through direct, simultaneous measurements of water status and xylem efficiency of both plant regions at different hours of the day.     

Mechanical reinforcement of tracheids compromises the hydraulic efficiency of conifer xylem

Wood structure and function of juvenile wood from 18 conifer species from four conifer families (Araucariaceae, Cupressaceae, Pinaceae and Podocarpaceae) were examined for a trade-off between wood reinforcement and hydraulic efficiency. Wood density and tracheid 'thickness-to-span' ratio were used as anatomical proxies for mechanical properties. The thickness:span represented the ratio of tracheid double wall thickness to lumen diameter. Hydraulic resistivity (R) of tracheids on a cross-sectional area basis (RCA) increased over 50-fold with increasing density and thickness:span, implying a strength versus efficiency conflict. The conflict arose because density and thickness:span were increased by narrowing tracheid diameter rather than by thickening walls, which may be developmentally difficult. In the Pinaceae and Cupressaceae species, density and thickness:span correlated strongly with protection from drought-induced embolism, suggesting that mechanical strength was required in part to withstand tracheid collapse by negative sap pressure. These species showed a corresponding trade-off between increasing RCA and embolism protection. In contrast, species of Podocarpaceae and Araucariaceae were overbuilt for their embolism protection and were hydraulically inefficient, having greater density, thickness:span and RCA, none of which were correlated with vulnerability to embolism.     

Electrical properties of the vertically growing root tip of Lepidium sativum L.

Electrical transmembrane potential differences and resistances in different tissues of intact root tips of Lepidium sativum L. were investigated in a humid atmosphere by conventional glass-microelectrode techniques with the reference electrode at the surface (apoplast) of the root. The resting potential (inside negative) in cells of the root cap rose from-80 mV in external cell layers (secretion cells) to approx.-140 mV in central cells (statocytes). Measurements of the electric input resistance within the apoplast of the root tip (calyptra, meristem and elongation zone) yielded a preference for longitudinal contact (resistance per length of tissue approx. 3.4 GOhm m^-1) compared with transversal contact (approx. 14 GOhm m^-1). Similarly, the symplastic coupling expressed as the characteristic length (L) where a signal is reduced to 1/c compared with the origin yielded L _y =390 m in the longitudinal (y) direction and L _x =140 m in the transversal (x) direction. Cable analytical treatment of the symplastic input resistances (approx. 10 MOhm) resulted in low membrane resistances in the y-direction at the ends of cells compared with the membrane resistances in the x-direction (approx. 0.2 Ohm m²) of the lateral membranes in the approximately cylindrical cells. This anisotropy is discussed in terms of model calculations. The resistivity of the symplast was calculated to be about 2.5 Ohm m. The input current-voltage relationship displayed a slight curvature with increasing slope for the more negative membrane potential typical of membranes with electrogenic pumps. Even after massive electrical stimulation in the range from-50 to-150mV carried out to trace current-voltage curves, electrical excitations (action potentials) were not detected in the cells investigated.Abbreviations el voltage recording electrodes - R resistance - V _r resting potential     

沙质林地土壤阻抗系数测量方法

介绍了土壤阻抗系数的测量目的及测量的一般方法;重点描述了应用大地阻抗仪(Yokogawa Type 3244)(specific earth resistance tester)测量沙质林地土壤阻抗系数的理论背景和室内、外操作步骤与数据处理方法。结果表明,使用3244大地阻抗仪,即运用Wenner法测量沙质林地土壤阻抗系数是可行的。其测量结果在对土壤分层、确定表层土壤含水量、初步确定地下水位等具有一定的应用前景。     

Electrical properties of soybean plasma membrane measured in heterotrophic suspension callus

Previous work on heterotrophic suspension-cultured cells has failed to detect the electrogenic processes normally associated with the plasma membranes of non-animal cells. This study reports measurements on heterotrophic cells from soybean (Glycine max L.) suspension cultures, which are shown to be amenable to impalement with microelectrodes. The plasma membrane clearly exhibits fundamental characteristics which are common to many other plant cell types: (i) a resting membrane potential significantly more negative than-100mV (measured value:121±4mV); (ii) obvious electrogenic activity, as evidenced by the marked depolarization of the membrane (87±6mV) by cyanide, and by the fact the membrane potential was frequently more negative than the equilibrium potential for K⁺; (iii) a finite permeability to K⁺ ions; (iv) electrophoretic transport of glucose. The development of a recording medium consisting primarily of 1:5 diluted growth medium was critical for successful impalement of these cells. It is proposed that the novel identification of electrogenic processes in heterotrophic suspension-cultured cells results from the deployment of electrodes with relatively dilute filling solutions, thus avoiding substantial changes in intracellular ion concentrations.The overwhelming majority of cells in soybean suspension cultures exist in small clusters, and the possibility of intercellular coupling potentially precludes assessment of membrane specific resistance and current density. Furthermore, as with most higher-plant cells, the vacuole occupies a large fraction of the intracellular volume. However, a model in which the measuring electrode is cytosolically located and the cells are electrically well-coupled is the only one which satisfactorily generates values for membrane specific resistance in a manner which is not strongly dependent on the number of cells in the cluster: other models in which the electrode tip is located in the vacuole and-or the impaled cell is electrically isolated from the others do not seem to apply. The measured values of membrane specific resistance are in the range 5.4 to 8.4 ·m², which is in excellent agreement with comparable measurements on other plant and fungal cells. The results are discussed with respect to mechanisms of transmembrane signalling in soybean, as well as to general electrophysiological studies on higher-plant cells in suspension culture and in tissues.Abbreviations and symbols R_m membrane resistance - r_p plasma-membrane resistivity - SRB Soybean Recording Buffer - V_m membrane potential     

Signals in Stochastically Generated Neurons

To incorporate variation of neuron shape in neural models, we developed a method of generating a population of realistically shaped neurons. Parameters that characterize a neuron include soma diameters, distances to branch points, fiber diameters, and overall dendritic tree shape and size. Experimentally measured distributions provide a means of treating these morphological parameters as stochastic variables in an algorithm for production of neurons. Stochastically generated neurons shapes were used in a model of hippocampal dentate gyrus granule cells. A large part of the variation of whole neuron input resistance RN is due to variation in shape. Membrane resistivity Rm computed from RN varies accordingly. Statistics of responses to synaptic activation were computed for different dendritic shapes. Magnitude of response variation depended on synapse location, measurement site, and attribute of response.     

Wear Resistance and Non-Magnetic Layer Formation on 316L Implant Material with Plasma Nitriding

In this study, the applicability of plasma nitriding treatment in the production of non-magnetic and corrosion resistant layer on 316L stainless steel implant material was investigated. 316L stainless steel substrates were plasma nitrided at temperatures of 350 ℃, 375 ℃, 400 ℃, 425 ℃ and 450 ℃ for 2 h in a gas mixture of 50% N2-50% H2, respectively. It was determined that the treatment temperature is the most important factor on the properties of the corrosion resistant layer of 316L stainless steel. The results show that s-phase formed at the temperatures under 400 ℃, and at the temperatures above 400 ℃, instead of s-phase, CrN and y＇-Fe4N phases were observed in the modified layer. The electrical resistivity and surface roughness of the modified layer increase with treatment temperature. Under 400 ℃ the corrosion resistance increased with the temperature, above 400 ℃ it decreased with the increase in treatment temperature. It was analyzed that the electrical resistivity and the soft （ideal） ferro- magnetic properties of 316L stainless steel increased with treatment temperature during nitriding treatment. Also, plasma ni- triding at low temperatures provided magnetic behavior close to the ideal untreated 316L stainless steel.