链霉菌M-1菌株所产抑菌活性物质特性的初步研究

用链霉菌M-1菌株所产的抑菌物质进行稳定性试验和极性试验,稳定性试验表明该菌株连续传代10次后遗传性稳定,且发酵液在100℃处理60 min,紫外线照射3 min和在碱性条件下处理后其对病原指示菌的抑菌活性基本不减。极性试验表明该物质属于弱碱性水溶性抗生素。本研究为进一步对该抑菌活性物质分离提取工艺和其在实践上的应用,提供了有益的试验数据。     

关于提高血气分析仪测量精度的探讨

血气分析已广泛用于昏迷、休克、严重外伤的危急病人的血液酸碱度、氧分压、二氧化碳分压的测量。测量数据的准确性至关重要。本文对与测量精度有关的几个环节如计量检定、质控与定标、样本采集与测量、日常维护与故障处理进行探讨,提出提高血气分析精度的解决方案。     

A novel device to monitor small changes in underwater distances

Abstract. This study describes a technique to record small (1 cm) distance changes or movements occurring in seawater using a simple electronic circuit and miniature ball electrodes. This low-cost technique was designed to directly measure such changes in a broad range of experiments involving small marine invertebrates while minimizing the mechanical loading of the structures of interest. The circuit detects and amplifies small changes in the resistance of seawater between two electrodes as the distance between them varies; these are then converted to voltage changes. After calibrating the output of the device with known distance measurements, it was evaluated using a test organism by monitoring and recording the body flushing behavior of the sea squirt, Styela plicata . Electrodes were sewn to the tunic at the base of the atrial siphon and changes in its diameter were recorded >24-h periods. Using ∼3-cm-tall sea squirts, the distance between the electrodes expanded and contracted with a range of 5.5 mm during rhythmic flushings. Flushes occurred on average every 4.1 min and showed a rapid initial contraction, followed by a slower expansion while refilling. Attaching electrodes to the tunic had little mechanical or behavioral effect; the untouched control specimen had similar flushing rates. The movement monitor circuit is stable, sensitive, and performed well in full-strength seawater experiments where good spatial and high temporal resolution, low inertial loading, and low noise were required. The technique, as shown here, can be used to record a wide range of animal movements and further suggested modifications of the circuit may suit a broad range of other experimental situations.     

Old and new challenges in using species diversity for assessing biodiversity

Although the maintenance of diversity of living systems is critical for ecosystem functioning, the accelerating pace of global change is threatening its preservation. Standardized methods for biodiversity assessment and monitoring are needed. Species diversity is one of the most widely adopted metrics for assessing patterns and processes of biodiversity, at both ecological and biogeographic scales. However, those perspectives differ because of the types of data that can be feasibly collected, resulting in differences in the questions that can be addressed. Despite a theoretical consensus on diversity metrics, standardized methods for its measurement are lacking, especially at the scales needed to monitor biodiversity for conservation and management purposes. We review the conceptual framework for species diversity, examine common metrics, and explore their use for biodiversity conservation and management. Key differences in diversity measures at ecological and biogeographic scales are the completeness of species lists and the ability to include information on species abundances. We analyse the major pitfalls and problems with quantitative measurement of species diversity, look at the use of weighting measures by phylogenetic distance, discuss potential solutions and propose a research agenda to solve the major existing problems.     

Measurements on ground or sectioned otoliths: possibilities of bias

Back-calculation usually requires measurements of growth marks revealed on otoliths by specific preparations. The standardization of the grinding (or sectioning) plane is necessary, but difficult, especially along the antero-posterior axis. In order to show the importance of the grinding plane, tetracycline labelling of eel otoliths ( Anguilla anguilla L.) has been used. This marking has a calcio-traumatic effect on otoliths, which can be revealed with staining techniques. Unless the grinding plane is incorrect, the tetracycline labelling and the staining of the ground surface are then superposed.     

Dielectric monitoring of growth and sporulation of <Emphasis Type="BoldItalic">Bacillus thuringiensis</Emphasis>

On-line permittivity and optical density measurements have been used to monitor biomass concentration and sporulation status during growth of a spore-forming bacterium, Bacillus thuringiensis, in fed-batch culture. The correlation between permittivity, optical density and other observations showed three distinct phases of growth: growth itself, transition and sporulation. The permittivity variations during the transition and sporulation phases could be related to the sporulation development: the evolution pattern of the ratio of optical density to permittivity was representative of the culture state, and during the sporulation phase, a permittivity index could be build to measure the extend of spore liberation.     

Phylloclimate or the climate perceived by individual plant organs: what is it? How to model it? What for?

This review introduces the emergence of a new research topic, phylloclimate, located at the crossroads between ecophysiology and canopy microclimate research. Phylloclimate corresponds to the physical environment actually perceived by each individual aerial organ of a plant population, and is described by physical variables such as spectral irradiance, temperature, on-leaf water and features of around-organ air (wind speed, temperature, humidity, etc.). Knowing the actual climate in which plant organs grow may enable advances in the understanding of plant-environment interactions, as knowing surface temperature instead of air temperature enabled advances in the study of canopy development. Characterizing phylloclimate variables, using experimental work or modeling, raises many questions such as the choice of suitable space- and time-scale as well as the ability to individualize plant organs within a canopy. This is of particular importance when aiming to link phylloclimate and function-structure plant models. Finally, recent trends and challenging questions in phylloclimate research are discussed, as well as the possible applications of phylloclimate results.     

The effect of intraspecific sample size on type I and type II error rates in comparative studies

Comparative studies have increased greatly in number in recent years due to advances in statistical and phylogenetic methodologies. For these studies, a trade-off often exists between the number of species that can be included in any given study and the number of individuals examined per species. Here, we describe a simple simulation study examining the effect of intraspecific sample size on statistical error in comparative studies. We find that ignoring measurement error has no effect on type I error of nonphylogenetic analyses, but can lead to increased type I error under some circumstances when using independent contrasts. We suggest using ANOVA to evaluate the relative amounts of within- and between-species variation when considering a phylogenetic comparative study. If within-species variance is particularly large and intraspecific sample sizes small, then either larger sample sizes or comparative methods that account for measurement error are necessary.     

New manganese complexes with 2-salicyloylhydrazono-1,3-dithiolane ligand and various coordination solvents

The new complexes with 2-salicyloylhydrazono-1,3-dithiolane ligand (H₂L) have been obtained with good yields (≈85%) by reacting manganese (II) acetate tetrahydrate or manganese (II) acetylacetonate with 2-salicyloylhydrazono-1,3-dithiolane ligand in DMF, THF or Py (L′). These compounds have been fully characterized by spectroscopic methods and single crystal X-ray diffraction. In the solid state, supramolecular networks are described and discussed in terms of weak H-bonds and short contacts. The new monomeric complexes will be considered as candidates to obtain polynuclear complexes.     

Direct pelletization in a rotary processor controlled by torque measurements. III. Investigation of microcrystalline cellulose and lactose grade

The aim of the present study was to investigate the use of different grades of microcrystalline cellulose (MCC) and lactose in a direct pelletization process in a rotary processor. For this purpose, a mixed 2- and 3-level factorial study was performed to determine the influence of the particle size of microcrystalline cellulose (MCC), (≈60 and 105 μm) and lactose (≈30, 40, and 55 μm), as well as MCC type (Avicel and Emcocel) on the pelletization process and the physical properties of the prepared pellets. A 1∶4 mixture of MCC and lactose was applied, and granulation liquid was added until a 0.45 Nm increase in the torque of the friction plate was reached. All combinations of the 3 factors resulted in spherical pellets of a high physical strength. The particle size of MCC was found to have no marked effect on the amount of water required for agglomerate growth or on the size of the resulting pellets. An increasing particle size of lactose gave rise to more spherical pellets of a more narrow size distribution as well as higher yields. The MCC type was found to affect both the release of the model drug from the prepared pellets and the size distribution. Generally, the determined influence of the investigated factors was small, and direct pelletization in a rotary processor was found to be a robust process, insensitive to variations in the particle size and type of MCC and the particle size of lactose. Published: October 24, 2005