Property control of sophorolipids: influence of fatty acid substrate and blending

Sophorolipids (SLs) were synthesized by fed-batch fermentation of Candida bombicola on glucose and either palmitic acid (SL-p), stearic acid (SL-s), oleic acid (SL-o) or linoleic acid (SL-l) and the structural distribution accurately determined by atmospheric pressure chemical ionization-mass spectrometry (APCI-MS). The surfactant properties, including critical micelle concentration (CMC), minimum surface tension (min.ST) and oil-water interfacial tension (IFT) were measured by tensiometry. Minimum STs of 35–36 mN/m were obtained regardless of the substrate while IFTs ranged from 3–5 mN/m with the exception of SL-l, which had an IFT of 7 mN/m. The largest disparity occurred in the CMC values, which ranged from 35 ppm for SL-s to 250 ppm for SL-l. By manually mixing these four SLs in different ratios, it was possible to better control the CMC values without affecting the min.ST or IFT, which will prove beneficial as new applications for SLs are established. Mention of trade names or commercial products in this publication is solely for the purpose of providing specific information and does not imply recommendation or endorsement by the U.S. Department of Agriculture.     

Nature of micellar calcium phosphate in cows' milk as studied by high-resolution electron microscopy

The nature of the inorganic calcium phosphate in the casein micelle of cows' milk has been studied by high-resolution electron microscopy. No periodic lattice spacings could be imaged, and diffraction patterns were of the diffuse amorphous type. Short-range order of less than 15 Å may be present, but the results indicate that there is no long-range order in micellar calcium phosphate.     

Ca2+-induced isotropic motion and phosphatidylcholine flip-flop in phosphatidylcholine-cardiolipin bilayers

Ca²⁺ induces a structural change in phosphatidylcholine-cardiolipin bilayers, which is visualised by freeze-fracturing as lipidic particles associated with the bilayer and is detected by ³¹P-NMR as isotropic motion of the phospholipids. In this structure a rapid transbilayer movement of phosphatidylcholine and a highly increased permeability towards Mn²⁺ are observed.     

Nanoparticulate drug delivery systems for cancer chemotherapy

Abstract

Nanoparticles (NPs) are, in general, colloidal particles, less than 1000 nm, that can be used for better drug delivery and prepared either by encapsulating the drug within a vesicle and or by dispersing the drug molecules within a matrix. Nanoparticulate drug delivery systems have been extensively studied in recent years for spatial and temporal delivery, especially in tumour and brain targeting. NPs have great promise for better drug delivery as found in both pharmaceutical and clinical research. As a drug carrier, NPs have significant advantages like better bioavailability, systemic stability, high drug loading, long blood circulation time and selective distribution in the organs/tissues with longer half life. The selective targeting of NPs can be achieved by the enhanced permeability and retention effect (EPR-effect), attaching specific ligands, or by making selective distribution due to change of the physiological conditions of specific systems like nature, pH, temperature, etc. It has been observed that drug-loaded NPs can have selective distribution to organs/tissues using different types of and proportions of polymers. The current aim of researchers is to prepare NPs that are long-lived with and that demonstrate the appropriate selective distribution for better therapy and thus improved clinical outcomes. Nanoparticulate drug delivery systems have the potential to deliver a drug to the target site with specificity and to maintain the desired concentration at the site for the intended time without untoward effects. In this review article, the methods for the preparation of NPs, their characterization, biodistribution, and pharmacokinetic characteristics are discussed.     

Factorial design optimization of micelle enhanced synchronous spectrofluorimetric assay of Omarigliptin: Applied to content uniformity testing and in vitro drug release

A micelle enhanced spectrofluorimetric method was developed for determination of Omarigliptin (OMG) based on its native fluorescence behavior. The interaction of OMG with surfactants and macromolecules was studied. In aqueous solution, the relative fluorescence intensity (RFI) of OMG was enhanced by 24% in the presence of Tween 80 at pH 3.5. The optimal conditions for the micelle enhanced fluorescence were attained by Minitab® program using Plackett–Burman factorial design. Pareto chart, contour plots and surface plots were used to exclude the insignificant variables and optimize the significant factors. The spectrofluorimeter was operated under synchronous mode using ?λ = 30 nm and recording the RFI of the intense narrow band at 267 nm for OMG in 0.5% w/v Tween 80 + 0.2 M acetate buffer (pH 3.5) system using water as diluent. Using synchronous scan mode offered many advantages including considerable reduction of spectral overlap and enhanced linearity of the calibrators. Validation parameters were satisfied over the concentration range 0.1–2 μg/ml. The developed method was the first analytical procedure for OMG assay in Marizev® tablets. Moreover, content uniformity testing and in vitro drug release of tablets were performed.     

A lactational study of the composition and integrity of casein micelles from the milk of the tammar wallaby (Macropus eugenii)

The amount of casein found in the milk of the tammar wallaby increases as lactation progresses. The increase is due to increasing amounts of β-casein; the α-casein remains largely constant. The α-casein is the more highly phosphorylated; the most abundant form is the 10-P, throughout lactation. The level of phosphorylation of β-casein shifts to lower average values in late lactation, possibly indicating the enzymatic reaction is overloaded by the increasing amounts of β-casein. Unlike bovine casein micelles, the wallaby micelles are not completely disrupted at pH 7.0 by sequestration of their calcium content with ethylene diamine tetraacetic acid (EDTA). Complete disruption only follows the addition of sodium dodecyl sulphate, indicating considerably greater importance for hydrophobic bonds in maintaining their integrity. This micellar behaviour indicates that, despite the evolutionary divergence of marsupials millennia ago, the caseins of wallaby milk assemble into micelles in much the same fashion as in bovine milk.     

Conformational and functional studies of gomesin analogues by CD, EPR and fluorescence spectroscopies

The aim of this work was to examine the bioactivity and the conformational behavior of some gomesin (Gm) analogues in different environments that mimic the biological membrane/water interface. Thus, manual peptide synthesis was performed by the solid-phase method, antimicrobial activity was evaluated by a liquid growth inhibition assay, and conformational studies were performed making use of several spectroscopic techniques: CD, fluorescence and EPR. [TOAC¹]-Gm; [TOAC¹, Ser^2,6,11,15]-Gm; [Trp⁷]-Gm; [Ser^2,6,11,15, Trp⁷]-Gm; [Trp⁹]-Gm; and [Ser^2,6,11,15, Trp⁹]-Gm were synthesized and tested. The results indicated that incorporation of TOAC or Trp caused no significant reduction of antimicrobial activity; the cyclic analogues presented a β-hairpin conformation similar to that of Gm. All analogues interacted with negatively charged SDS both above and below the detergent's critical micellar concentration (cmc). In contrast, while Gm and [TOAC¹]-Gm required higher LPC concentrations to bind to micelles of this zwitterionic detergent, the cyclic Trp derivatives and the linear derivatives did not seem to interact with this membrane-mimetic system. These data corroborate previous results that suggest that electrostatic interactions with the lipid bilayer of microorganisms play an important role in the mechanism of action of gomesin. Moreover, the results show that hydrophobic interactions also contribute to membrane binding of this antimicrobial peptide.     

Unfolding kinetics of beta-lactoglobulin induced by surfactant and denaturant: a stopped-flow/fluorescence study

The beta-->alpha transition of beta-lactoglobulin, a globular protein abundant in the milk of several mammals, is investigated in this work. This transition, induced by the cationic surfactant dodecyltrimethylammonium chloride (DTAC), is accompanied by partial unfolding of the protein. In this work, unfolding of bovine beta-lactoglobulin in DTAC is compared with its unfolding induced by the chemical denaturant guanidine hydrochloride (GnHCl). The final protein states attained in the two media have quite different secondary structure: in DTAC the alpha-helical content increases, leading to the so-called alpha-state; in GnHCl the amount of ordered secondary-structure decreases, resulting in a random coil-rich final state (denatured, or D, state). To obtain information on both mechanistic routes, in DTAC and GnHCl, and to characterize intermediates, the kinetics of unfolding were investigated in the two media. Equilibrium and kinetic data show the partial accumulation of an on-pathway intermediate in each unfolding route: in DTAC, an intermediate (I(1)) with mostly native secondary structure but loose tertiary structure appears between the native (beta) and alpha-states; in GnHCl, another intermediate (I(2)) appears between states beta and D. Kinetic rate constants follow a linear Chevron-plot representation in GnHCl, but show a more complex mechanism in DTAC, which acts like a stronger binding species.     

Outer membrane protein A of E. coli folds into detergent micelles, but not in the presence of monomeric detergent.

Outer membrane protein A (OmpA) of Escherichia coli is a beta-barrel membrane protein that unfolds in 8 M urea to a random coil. OmpA refolds upon urea dilution in the presence of certain detergents or lipids. To examine the minimal requirements for secondary and tertiary structure formation in beta-barrel membrane proteins, folding of OmpA was studied as a function of the hydrophobic chain length, the chemical structure of the polar headgroup, and the concentration of a large array of amphiphiles. OmpA folded in the presence of detergents only above a critical minimal chain length of the apolar chain as determined by circular dichroism spectroscopy and a SDS-PAGE assay that measures tertiary structure formation. Details of the chemical structure of the polar headgroup were unimportant for folding. The minimal chain length required for folding correlated with the critical micelle concentration in each detergent series. Therefore, OmpA requires preformed detergent micelles for folding and does not adsorb monomeric detergent to its perimeter after folding. Formation of secondary and tertiary structure is thermodynamically coupled and strictly dependent on the interaction with aggregated amphiphiles.