Influence of media composition on xylitol fermentation by Candida guiliiermondii using response surface methodology

Summary The bioconversion of xylose to xylitol by the yeast Candida guilliermondii FTI 20037 was evaluated under different nutritional conditions using rice straw hemicellulose hydrolysate. Statistical designs were used to determine the fermentation medium composition. Ammonium sulfate and rice bran have been identified as required nutrients in the hydrolysate since there was a significant interaction between them. In the presence of both nutrients, the xylitol yield factor (Yp/s) and volumetric productivities (Qp) were 0.68 g/g and 0.54 g/L.h, respectively.     

Xylitol production by <Emphasis Type="Italic">Debaryomyces hansenii</Emphasis> in brewery spent grain dilute-acid hydrolysate: effect of supplementation

A brewery spent-grain hemicellulosic hydrolysate was used for xylitol production by Debaryomyces hansenii. Addition of 6 g yeast extract/l increased the xylitol yield to 0.57 g/g, and productivity to 0.51 g/l h that were, respectively, 1.4 -and 1.8-times higher than the values obtained with non-supplemented hydrolysate. When corn steep liquor was combined with 3 g yeast extract/l, the highest xylitol yield, 0.58 g/g, was obtained with a similar productivity.     

A study on xylitol production from sugarcane bagasse hemicellulosic hydrolysate by Ca-alginate entrapped cells in a stirred tank reactor

Candida guilliermondii FTI 20037 cells were entrapped in Ca-alginate beads and used for xylitol production from sugarcane bagasse hemicellulosic hydrolysate in a stirred tank reactor (STR). Screening design and response surface methodologies were used to determine adequate cultivation conditions for this fermentation system. Quadratic models were fitted to the experimental data by regression analysis, considering the yield (Y_P/S) and the productivity (Q_P) of the xylose-to-xylitol bioconversion as dependent variables. Using a five-fold concentrated hydrolysate, air flowrate of 1.30 l/min, agitation speed of 300 rpm, initial cell concentration of 1.4 g/l and value 6.0 for the initial pH of the fermentation medium resulted in a xylitol production of 47.5 g/l after 120 h of fermentation, corresponding to a Y_P/S of 0.81 g/g and to a Q_P of 0.40 g/l h.     

Effect of inoculum level on xylitol production from rice straw hemicellulose hydrolysate byCandida guilliermondii

The effect of inoculum level on xylitol production byCandida guilliermondii was evaluated in a rice straw hemicellulose hydrolysate. High initial cell density did not show a positive effect in this bioconversion since increasing the initial cell density from 0.67 g L^–1 to 2.41 g L^–1 decreased both the rate of xylose utilization and xylitol accumulation. The maximum xylitol yield (0.71 g g^–1) and volumetric productivity (0.56 g L^–1 h^–1) were reached with an inoculum level of 0.9 g L^–1. These results show that under appropriate inoculum conditions rice straw hemicellulose hydrolysate can be converted into xylitol by the yeastC. guilliermondii with efficiency values as high as 77% of the theoretical maximum.     

Eucalyptus hydrolysate detoxification with activated charcoal adsorption or ion-exchange resins for xylitol production

Eucalyptus hemicellulosic hydrolysate used for xylitol production by Candida guilliermondii FTI20037 was previously treated either with ion-exchange resins or with activated charcoal adsorption combined with pH adjustment, in order that acetic acid, furfural and hydroxymethylfurfural could be removed. The best results for xylitol yield factor (0.76 g/g) and volumetric productivity (0.68 g/(l h) were attained when a three-fold concentrated hydrolysate was treated with ion-exchange resins. Using activated charcoal combined with pH adjustment for treating a three-fold concentrated hydrolysate resulted in a xylitol yield factor of 0.40 g/g and a volumetric productivity of 0.30 g/(l h). This same treatment applied to a six-fold concentrated hydrolysate resulted in a xylitol yield factor of 0.66 g/g and a volumetric productivity of 0.50 g/(l h).     

The behavior of key enzymes of xylose metabolism on the xylitol production by <Emphasis Type="Italic">Candida guilliermondii</Emphasis> grown in hemicellulosic hydrolysate

A variety of raw materials have been used in fermentation process. This study shows the use of rice straw hemicellulosic hydrolysate, as the only source of nutrient, to produce high added-value products. In the present work, the activity of the enzymes xylose reductase (XR); xylitol dehydrogenase (XD); and glucose-6-phosphate dehydrogenase (G6PD) during cultivation of Candida guilliermondii on rice straw hemicellulosic hydrolysate was measured and correlated with xylitol production under different pH values (around 4.5 and 7.5) and initial xylose concentration (around 30 and 70 g l(-1)). Independent of the pH value and xylose concentration evaluated, the title of XD remained constant. On the other hand, the volumetric activity of G6PD increased whereas the level of XR decreased when the initial xylose concentration was increased from 30 to 70 g l(-1). The highest values of xylitol productivity (Q (P) approximately 0.40 g l(-1)) and yield factor (Y (P/S) approximately 0.60 g g(-1)) were reached at highest G6PD/XR ratio and lowest XR/XD ratio. These results suggest that NADPH concentrations influence the formation of xylitol more than the activity ratios of the enzymes XR and XD. Thus, an optimal rate between G6PD and XR must be reached in order to optimize the xylitol production.     

Statistical screening method for selection of important variables on xylitol biosynthesis from rice straw hydrolysate by Candida guilliermondii FTI 20037

Fourteen assays were conducted to study the influence of different variables, namely xylose concentration, inoculum level, agitation speed and nutrient supplementation, on xylitol biosynthesis by Candida guilliermondii FTI 20037. The maximum predicted values for xylitol yield (0.65 g g^–1) and xylitol productivity (0.66 g l^–1 h^–1) can be attained with rice straw hydrolysate containing 60 g xylose l^–1 without supplementation of ammonium sulfate, calcium chloride and rice bran extract, using 5 g inoculum l^–1, at 250 rpm. Xylose concentration and inoculum level were selected for further optimization studies.     

Improvement in xylitol production from sugarcane bagasse hydrolysate achieved by the use of a repeated-batch immobilized cell system

Candida guilliermondii cells were immobilized in Ca-alginate beads and used for xylitol production from concentrated sugarcane bagasse hydrolysate during five successive fermentation batches, each lasting 48 hours. The bioconversion efficiency of 53.2%, the productivity of 0.50 g/l x h and the final xylitol concentration of 23.8 g/l obtained in the first batch increased to 61.5%, 0.59 g/l x h and 28.4 g/l, respectively, in the other four batches (mean values), with variation coefficients of up to 2.3%.     

Development of a yeast strain for xylitol production without hydrolysate detoxification as part of the integration of co-product generation within the lignocellulosic ethanol process

The present study verified an applicable technology of xylitol bioconversion as part of the integration of co-product generation within second-generation bioethanol processes. A newly isolated yeast strain, Candida tropicalis JH030, was shown to have a capacity for xylitol production from hemicellulosic hydrolysate without detoxification. The yeast gives a promising xylitol yield of 0.71 g(p) g(s)(-1) from non-detoxified rice straw hydrolysate that had been prepared by the dilute acid pretreatment under severe conditions. The yeast's capacity was also found to be practicable with various other raw materials, such as sugarcane bagasse, silvergrass, napiergrass and pineapple peel. The lack of a need to hydrolysate detoxification enhances the potential of this newly isolated yeast for xylitol production and this, in turn, has the capacity to improve economics of lignocellulosic ethanol production.     

聚氨酯固定化热带假丝酵母发酵木糖醇

固定在多孔聚氨酯载体中的热带假丝酵母(Candida tropicalis), 可有效地利用玉米芯半纤维素水解液生产木糖醇。在摇瓶条件下, 采用分批发酵方式, 确立了适宜的发酵工艺参数为: 接种量7%, 聚氨酯加入量1.0 g/100 mL, 温度30°C, 初始pH值6.0, 分段改变摇床转速进行溶氧调节, 其中0~24 h 为200 r/min; 24 h~46 h为140 r/min。聚氨酯固定化提高了菌体对发酵抑制物的耐受力, 固定化细胞密度高, 发酵性能稳定, 发酵产率和体积生产速率都有所提高。水解液未经脱色与离子交换便可转化成木糖醇, 大幅降低了成本, 显示了良好的应用前景。固定化细胞连续重复进行12批次21 d的发酵, 木糖醇得率平均为67.6%, 体积生产速率平均为1.92 g/(L·h)。