Stiffness of glycerinated rabbit psoas fibers in the rigor state. Filament-overlap relation

The stiffness of glycerinated rabbit psoas fibers in the rigor state was measured at various sarcomere lengths in order to determine the distribution of the sarcomere compliance between the cross-bridge and other structures. The stiffness was determined by measuring the tension increment at one end of a fiber segment while stretching the other end of the fiber. The contribution of the end compliance to the rigor segments was checked both by laser diffractometry of the sarcomere length change and by measuring the length dependence of the Young's modulus; the contribution was found to be small. The stiffness in the rigor state was constant at sarcomere lengths of 2.4 microns or less; at greater sarcomere lengths the stiffness, when corrected for the contribution of resting stiffness, scaled with the amount of overlap between the thick and thin filaments. These results suggest that the source of the sarcomere compliance of the rigor fiber at the full overlapping of filaments is mostly the cross-bridge compliance.     

The stiffness of skeletal muscle in isometric contraction and rigor: the fraction of myosin heads bound to actin.

Step changes in length (between -3 and +5 nm per half-sarcomere) were imposed on isolated muscle fibers at the plateau of an isometric tetanus (tension T0) and on the same fibers in rigor after permeabilization of the sarcolemma, to determine stiffness of the half-sarcomere in the two conditions. To identify the contribution of actin filaments to the total half-sarcomere compliance (C), measurements were made at sarcomere lengths between 2.00 and 2.15 microm, where the number of myosin cross-bridges in the region of overlap between the myosin filament and the actin filament remains constant, and only the length of the nonoverlapped region of the actin filament changes with sarcomere length. At 2.1 microm sarcomere length, C was 3.9 nm T0(-1) in active isometric contraction and 2.6 nm T0(-1) in rigor. The actin filament compliance, estimated from the slope of the relation between C and sarcomere length, was 2.3 nm microm(-1) T0(-1). Recent x-ray diffraction experiments suggest that the myosin filament compliance is 1.3 nm microm(-1) T0(-1). With these values for filament compliance, the difference in half-sarcomere compliance between isometric contraction and rigor indicates that the fraction of myosin cross-bridges attached to actin in isometric contraction is not larger than 0.43, assuming that cross-bridge elasticity is the same in isometric contraction and rigor.     

On the relation between filament overlap and the number of calcium-binding sites on glycerinated muscle fibers.

The formation of rigor complexes between the thick and thin filaments of glycerinated rabbit psoas muscle fibers causes the fibers to bind more calcium at any given level of free calcium. I studied the maximum amount of calcium bound as a function of filament overlap under rigor conditions. Fibers stretched to zero filament overlap (sarcomere length greater than 3.8 micron) bound exactly 75% as much calcium as fibers with maximum overlap. Between these extremes a linear relationship was found between maximum bound calcium and the length of the overlap zone. The results support the hypothesis that in the intact filament lattice one of the four calcium-binding sites of troponin depends for its existence on attachment between myosin and actin. In addition, the linear relation between maximum bound calcium and filament overlap is consistent with the assumption that the cooperative effect of rigor complex formation on calcium binding is limited to the binding site in the immediate vicinity of the rigor complex.     

Extensibility of the myofilaments in vertebrate skeletal muscle as revealed by stretching rigor muscle fibers

The extensibility of the myofilaments in vertebrate skeletal muscle was studied by stretching glycerinated rabbit psoas muscle fibers in rigor state and examining the resulting extension of sarcomere structures under an electron microscope. Although stretches applied to rigor fibers produced a successive yielding of the weakest sarcomeres, the length of the remaining intact sarcomeres in many myofibrils was fairly uniform, being definitely longer than the sarcomeres in the control, nonstretched part of rigor fibers. The stretch-induced increase in sarcomere length was found to be taken up by the extension of the H zone and the I band, whereas the amount of overlap between the thick and thin filaments did not change appreciably with stretches of 10-20%. The thick filament extension in the H zone was localized in the bare regions, whereas the thin filament extension in the I band appeared to take place uniformly along the filament length. No marked increase in the Z-line width was observed even with stretches of 20-30%. These results clearly demonstrate the extensibility of the thick and thin filaments. The possible contribution of the myofilament compliance to the series elastic component (SEC) in vertebrate skeletal muscle fibers is discussed on the basis of the electron microscopic data and the force-extension curve of the SEC in rigor fibers.     

X-ray diffraction evidence for the extensibility of actin and myosin filaments during muscle contraction.

To clarify the extensibility of thin actin and thick myosin filaments in muscle, we examined the spacings of actin and myosin filament-based reflections in x-ray diffraction patterns at high resolution during isometric contraction of frog skeletal muscles and steady lengthening of the active muscles using synchrotron radiation as an intense x-ray source and a storage phosphor plate as a high sensitivity, high resolution area detector. Spacing of the actin meridional reflection at approximately 1/2.7 nm-1, which corresponds to the axial rise per actin subunit in the thin filament, increased about 0.25% during isometric contraction of muscles at full overlap length of thick and thin filaments. The changes in muscles stretched to approximately half overlap of the filaments, when they were scaled linearly up to the full isometric tension, gave an increase of approximately 0.3%. Conversely, the spacing decreased by approximately 0.1% upon activation of muscles at nonoverlap length. Slow stretching of a contracting muscle increased tension and increased this spacing over the isometric contraction value. Scaled up to a 100% tension increase, this corresponds to a approximately 0.26% additional change, consistent with that of the initial isometric contraction. Taken together, the extensibility of the actin filament amounts to 3-4 nm of elongation when a muscle switches from relaxation to maximum isometric contraction. Axial spacings of the layer-line reflections at approximately 1/5.1 nm-1 and approximately 1/5.9 nm-1 corresponding to the pitches of the right- and left-handed genetic helices of the actin filament, showed similar changes to that of the meridional reflection during isometric contraction of muscles at full overlap. The spacing changes of these reflections, which also depend on the mechanical load on the muscle, indicate that elongation is accompanied by slight changes of the actin helical structure possibly because of the axial force exerted by the actomyosin cross-bridges. Additional small spacing changes of the myosin meridional reflections during length changes applied to contracting muscles represented an increase of approximately 0.26% (scaled up to a 100% tension increase) in the myosin periodicity, suggesting that such spacing changes correspond to a tension-related extension of the myosin filaments. Elongation of the myosin filament backbone amounts to approximately 2.1 nm per half sarcomere. The results indicate that a large part (approximately 70%) of the sarcomere compliance of an active muscle is caused by the extensibility of the actin and myosin filaments; 42% of the compliance resides in the actin filaments, and 27% of it is in the myosin filaments.     

Polarization states of diffracted light. Changes accompanying fiber activation.

Measurement of the state of optical polarization of light diffracted from single, skinned and intact fibers of anterior tibialis muscle from Rana pipiens revealed a dependence upon rigor, activation, and sarcomere length (SL) change. Changes in total birefringence, delta nT, and differential field ratio value, rT, were determined. In a relaxed, skinned fiber the total birefringence value, delta nT, decreases as sarcomere length is increased from 2.1 microns to approximately 2.8-3.0 microns. From there it increases significantly to a value of approximately 1.8 x 10(-3) at a sarcomere length of 3.6 microns. The differential field ratio, rT, also shows a biphasic response to increasing sarcomere length, first exhibiting a rapid decrease over shorter SL and leveling out after the SL is beyond 3.0 microns. In comparison, relaxed intact fibers change substantially less upon sarcomere length change, showing little change in birefringence and a small bi-phasic change in rT. Skinned fibers were activated using a solution that has the same ionic strength as the relaxing solution and allows repeatable, and sustained activation. A decrease in both delta nT and rT was observed upon fiber activation. The decrease in delta nT and rT was slightly larger at shorter sarcomere lengths than at longer lengths. Relaxed fibers placed in rigor showed changes in delta nT and rT similar to those observed in activated fibers. These results are consistent with the hypothesis that, after activation, a significant portion of the thick filament cross-bridges rotate towards the actin filament resulting in redistribution of the interfilament mass content. They are also consistent with an average orientation of crossbridges in the overlap region different from that in the nonoverlap region.     

Changes in the lateral filament spacing of skinned muscle fibres when cross-bridges attach

When a skinned fibre prepared from frog skeletal muscle goes from the relaxed to the rigor state at a sarcomere length of about 2.2 μm, the 1, 0 transverse spacing of the filament lattice, measured by X-ray diffraction, decreases by about 11%. In measurements at various sarcomere lengths, the decrease in the spacing was approximately proportional to the degree of overlap between the thick and thin filaments. This suggests that the shrinkage of the lattice is caused by a lateral force produced by cross-bridges. In order to estimate the magnitude of the lateral force, the decrease of spacing between relaxed and rigor states was compared with the shrinkage caused osmotically by adding a high molecular weight polymer, polyvinylpyrrolidone, to the bathing solution. The results indicate that the lateral force produced per unit length of thick filament in the overlap zone is of the same order of magnitude as the axially directed force produced during maximum isometric contraction (10^?10 to 10^?9 N/μm).Experiments in the presence of a high concentration of polyvinylpyrrolidone (100 g/l) show that when the lattice spacing is decreased osmotically beyond a certain value, the lateral force produced when the fibre goes into rigor changes its direction, causing the lattice to swell. This result can be explained by assuming that there is an optimum interfilament spacing at which the cross-bridges produce no lateral force. At other spacings, the lateral force tends to displace the filament lattice toward that optimum value.     

Lattice swelling with the selective digestion of elastic components in single-skinned fibers of frog muscle.

Changes in the 1.0 lattice spacing during trypsin (0.25 micrograms/ml) treatment in mechanically skinned single fibers of frog muscle was examined by an x-ray diffraction method at various sarcomere lengths. The resting tension of a relaxed fiber was decreased by trypsin treatment but the stiffness of a rigor fiber was not, suggesting that elastic components were selectively digested. With progression of the digestion, the lattice spacing increased remarkably at longer sarcomere lengths and finally became independent of the sarcomere length. The increase in the lattice spacing was proportional to the decrease in the resting tension. These results support our previous suggestion (Higuchi, H., and Y. Umazume, 1986, Biophys. J., 50:385-389) that the lattice spacing decreases at long lengths due to compressive force exerted by a lateral elastic component that connects thick filaments to an axial elastic component. Consequently, it is unlikely that the decrease in the lattice spacing is determined by a decrease in the repulsive force between thick and thin filaments with stretching a fiber.     

Differences in the Charge Distribution of Glycerol-Extracted Muscle Fibers in Rigor, Relaxation, and Contraction

Glycerol-extracted rabbit psoas muscle fibers were impaled with KCl-filled glass microelectrodes. For fibers at rest-length, the potentials were significantly more negative in solutions producing relaxation than in solutions producing either rigor or contraction; further the potentials in the latter two cases were not significantly different. For stretched fibers, with no overlap between thick and thin filaments, the potentials did not differ in the rigor, the relaxation, or the contraction solutions. The potentials measured from fibers in rigor did not vary significantly with the sarcomere length. For relaxed fibers, however, the potential magnitude decreased with increasing sarcomere length. The difference between the potentials measured for rigor and relaxed fibers exhibited a nonlinear relationship with sarcomere length. The potentials from calcium-insensitive fibers were less negative in both the rigor and the relaxation solutions than those from normal fibers. When calcium-insensitive fibers had been incubated in Hasselbach and Schneider's solution plus MgCl₂ or Guba-Straub's solution plus MgATP the potentials recorded upon impalement were similar in the rigor and the relaxation solution to those obtained from normal fibers in the relaxed state. It is concluded that the increase in the negative potential as the glycerinated fiber goes from rigor to relaxation may be due to an alteration in the conformation of the contractile proteins in the relaxed state.     

Does thin filament compliance diminish the cross-bridge kinetics? A study in rabbit psoas fibers.

The effect of thin filament compliance on our ability to detect the cross-bridge kinetics was examined. Our experiment is based on the facts that in rabbit psoas the thin filament (1.12 micrometer) is longer than half the thick filament length (0.82 micrometer) and that the thick filament has a central bare zone (0.16 micrometer). Consequently, when sarcomere length is increased from 2.1 to 2.4 micrometer, the same number of cross-bridges is involved in force generation but extra series compliance is introduced in the I-band. Three apparent rate constants (2pia, 2pib, and 2pic) were characterized by sinusoidal analysis at pCa 4.66. Our results demonstrate that 2pia and 2pib increased 13-16% when sarcomere length was increased from 2.0 to 2.5 micrometer, and 2pic decreased slightly (9%). This slight decrease can be explained by compression of the lattice spacing. These observations are at variance with the expectation based on increased series compliance, which predicts that the rate constants will decrease. We also determined compliance of the I-band during rigor. I-band compliance during rigor induction was 35% of sarcomere compliance at sarcomere length 2.4 micrometer, and 24% at sarcomere length 2.1 micrometer. We conclude that the presence of thin filament compliance does not seriously interfere with our ability to detect cross-bridge kinetics using sinusoidal analysis.